Golf-FAQ.com

how to test a coil an a 1989 ezgo gas golf cart

by Aiyana Satterfield Published 2 years ago Updated 2 years ago
image

Take the voltmeter's black and red probe and place it on the –ve and +ve terminal of the coil. Take the readings. It should be between 3.7-5.2 ohms. If outside the range, the coil should be replaced.

Full Answer

What is the serial number on an EZGO gas golf cart?

Have an EZGO gas golf cart with manufacturer's code d1394 and serial number 793317. It has a two cylinder engine and has no spark from either ignition coil wire. It has voltage on the red wire to the coil when the accelerator pedal is pressed.

How do you test a Pulser coil on an EZGO golf cart?

How to test a pulser coil on an EZGO golf cart A voltmeter can be used to test the pulser coil or the igniter of a golf cart. This will tell you if the coils are damaged or there is some other larger problem hidden underneath the golf cart. Check the user manual to know the exact location of the pulser coil under the seat.

When should I replace the coil on my EZGO golf cart?

If outside the range, the coil should be replaced. Pulser coils can be fried, and the only way to start a EZGO golf cart is by replacing the coil. You can test the coil and use follow the below steps to remove and install a new one.

What's the EZGO gas golf cart code 793317?

Have an EZGO gas golf cart with manufacturer's code d1394 and serial number 793317. It has a two cylinder engine and has no spark from either ignition coil wire.

image

How do I know if my golf cart coils are bad?

Ignition Coil Problems, Symptoms and SolutionsEngine misfires.Rough idle.A decrease in car power, especially in acceleration.Poor fuel economy.Difficulty starting the engine.Check engine light is on.Exhaust backfiring.Increased hydrocarbon emissions.More items...•

How do you test a golf cart Ignitor?

Testing Your IgnitorPark your cart and put bricks behind the wheels to keep it from moving.Open up your cart engine and attempt to identify the ignitor using your cart engine schematic.Trace the ignitor back to the pulsar to see where they are connected together on your cart.More items...

How do you test a coil?

To test the primary resistance on the coil, grab a multimeter and attach the positive probe to the positive terminal on the coil. Then, attach the negative probe to the negative terminal. Set the multimeter to 200 ohms in the resistance category and take the reading.

How do you check for spark on a golf cart?

0:4816:08Got Burned...by a GOLF CART?!? (EZ-GO No-Start) - YouTubeYouTubeStart of suggested clipEnd of suggested clipYou just plug in a test light instead of the ignition coil just to check if we have power andMoreYou just plug in a test light instead of the ignition coil just to check if we have power and control so we expect a blinking test light when we crank the engine. Over.

How do you test an ezgo coil?

Take the voltmeter's black and red probe and place it on the –ve and +ve terminal of the coil. Take the readings. It should be between 3.7-5.2 ohms. If outside the range, the coil should be replaced.

What would cause a gas golf cart not to fire?

Check the area for loose wires or any broken pieces. You'll also want to look at your forward and reverse switch, which is also prone to wearing out after long-term use. This is an easy fix — replacing the forward/reverse switch is a generally inexpensive and quick repair.

How do you check a coil with a multimeter?

1:127:49How to Test an Ignition Coil Pack - Best Testing Procedure - YouTubeYouTubeStart of suggested clipEnd of suggested clipThat's one before you start the car and then you get grab your multimeter. Put it on DC voltage.MoreThat's one before you start the car and then you get grab your multimeter. Put it on DC voltage. Ground your black test lead and then on the connector. Side you start checking for voltage.

How do you test an old ignition coil?

0:498:12Ignition Coil Test (The Short Version) - YouTubeYouTubeStart of suggested clipEnd of suggested clipThere's actually two coils that are contained within this canister here and on the the the high sideMoreThere's actually two coils that are contained within this canister here and on the the the high side or the secondary. Side you can go between either terminal on the primary.

How do you test a coil with a screwdriver?

1:211:57How Do I test my car for spark? Here's how to! - YouTubeYouTubeStart of suggested clipEnd of suggested clipYou take the screwdriver. And you put the screwdriver in the spark plug wire. And then hold it closeMoreYou take the screwdriver. And you put the screwdriver in the spark plug wire. And then hold it close about what a spark plug gap would be and this way you can actually vary the distance.

Why does my golf cart have no spark?

If there is no spark, unplug the white plug with blue and black wires that are at the bottom of the engine under the valve cover. Check for spark once again. If there is a spark, the coil is in good condition and the ignition kill relay or its wiring is at fault.

How does a golf cart coil work?

Every time you turn your cart on or press the pedal, a small amount of voltage passes along the wire coil and triggers the steel plunger to close. This process allows energy from the battery to directly contact your golf cart's motor so that it can run properly.

How does a gas golf cart start?

In a gasoline-powered golf cart, the engine starts when you step on the gas pedal, and it shuts off when you take your foot off the gas. That feature helps save gas, cuts down on emissions and helps keep the course quiet, too.

What does the ignitor do on a golf cart?

The ignitor boosts the signal and sends it to the ignition coil. The coil then creates the large spark that goes to the spark plug and fires the gas mixture in the cylinder. Ignitors can be the cause of a weak spark or they may fail completely and then the coil cannot create any spark at all.

Why does my golf cart have no spark?

If there is no spark, unplug the white plug with blue and black wires that are at the bottom of the engine under the valve cover. Check for spark once again. If there is a spark, the coil is in good condition and the ignition kill relay or its wiring is at fault.

How do you test a GM coil pack with a multimeter?

1:127:49How to Test an Ignition Coil Pack - Best Testing Procedure - YouTubeYouTubeStart of suggested clipEnd of suggested clipThat's one before you start the car and then you get grab your multimeter. Put it on DC voltage.MoreThat's one before you start the car and then you get grab your multimeter. Put it on DC voltage. Ground your black test lead and then on the connector. Side you start checking for voltage.

Are ignition coils all the same?

Automotive Ignition Coils Come In A Wide Range Of Shapes, Sizes And Applications. The distinct differences between coil designs make identification of optional coils relatively simple for both the parts specialist and the technician. Ignition coils come in a wide range of shapes, sizes and applications.

Why do you need to test a golf cart coil?

Testing the coil on a golf cart is required due to a bad ignition coil or a problem that may run deep in the engine. Coils are intrinsic to every golf cart and the ignition system powers the spark plugs.

Why does my golf cart ignition go bad?

The main cause of golf cart ignition coils going bad is the wearing out due to a bad spark plug ignition cable. When a bad plug is inserted, it will have a much higher resistance value. During such high resistance a high amount of voltage gets generated from the secondary wiring of the ignition coil. The excess amount of voltage ends up creating ...

What is the most important thing about a golf cart?

Engine performance issue remains one of the most important concerns. The ignition coils are one of the most important components of an engine of a golf cart. Such issue can compromise the spark which can downgrade the performance of the golf cart.

Why does my ignition coil mat fail?

The ignition coil mat fail due to voltage supply being cut down or overload of the ignition control unit. It can also be due to any sort of mechanical damage to the ignition wires due to a faulty valve cover gasket or oil leakages.

What is the purpose of an ignition coil?

One of the major objectives of an ignition coil is to let a high voltage be induced from a low voltage. There is a laminated iron core which has the task of getting the magnetic field amplified. The primary wiring is connected to the secondary wiring via a connection to the terminal.

Why is my golf cart not starting?

Golf Cart not starting in one go: If you experience that the Golf Cart is not starting in one or two goes, then it is an indication that there may be a failure in ignition coil.

How to keep water out of coil plug?

Put grease on the coil plug as it will keep water out of the reach of the connection. Get the coil slide so that the boot clicks into the spark plug. Get the electrical connection reattached. Move to the next unit till the other coils are replaced.

What year is the Ezgo?

Okay your EZGO is a 1983. The pulser coil is behind the fan/flywheel. According to the service manual to test the pulser coil you should get a ohm reading between 120-180 between the red and blue wires on the pulser coil if it's good.

How many ohms should a pulser coil have?

According to the service manual to test the pulser coil you should get a ohm reading between 120-180 between the red and blue wires on the pulser coil if it's good. You must log in or register to reply here.

Does B8327#N have a spark?

b8327#N#No spark, no signal to coil. I couldn't find a method to test ignition box so i bought an HEI box to replace it. I was just testing the pulsar circuit first before cutting up the wiring. It doesn't look like I'm getting a signal from the pulsar and trying to find a diagram of how to remove or adjust it.

Do E-Z-Go Golf Carts have titles?

E-Z-Go Golf Carts, unlike vehicles, do not have a title, but they do have serial numbers. If you are buying a golf cart, it is essential to check the serial number to ensure you do not buy a stolen one. Each E-Z-Go Golf cart has a unique serial number that you can use to identify your golf cart.

Where is the E-Z-Go Cart Serial Number

As mentioned above, all E-Z-Go Golf carts have unique serial numbers. These numbers are essential when buying replacement parts for your golf cart. Textron Specialized Vehicles has been building golf carts for a long time, and the serial numbers are placed on different parts of the golf carts.

How do I push my E-Z-Go Golf Cart?

It can be frustrating when your battery is flat and your golf cart will not roll. To push it to the nearest charging or gas station, you need to release the motor brake. Follow these easy steps to do that.

Why does my E-Z-Go golf cart not move

There are several reasons why your cart refuses to move, but you should check the battery before anything else. If the battery is charged, here are some other reasons why your golf cart will not move.

Are all E-Z-Go Golf carts electric?

No, there are both electric and gas-powered E-Z-Go Golf carts available. Bear in mind that there are several models you can drive on the street, but those are all-electric. These electric models run on batteries that you have to charge at least every 24 hours, depending on how much you use them.

How to tell the Assembly year of my E-Z-Go golf cart

The placement of serial numbers is discussed above, and you will find the manufacturer’s number right next to it. The manufacturer’s number consists of one letter and 3 or 4 numbers. The last two numbers indicate the last two digits of the year of assembly.

How to service E-Z-Go Golf Cart

Like all vehicles, E-Z-Go golf carts require regular maintenance to enhance longevity and performance. You should ensure that your golf cart is serviced after every six months of use. That will ensure that you spot problems and repair them early, which will help reduce repair costs. Here are essential guidelines for E-Z-Go golf cart maintenance.

How to test golf cart solenoid?

A diode allows current to run in one direction, but not in the other. Testing the diode is a simple procedure. Remove the diode from the circuit and check the leads with a continuity tester.

How to tell if a golf cart won't start?

The first and most obvious symptom is the golf cart won’t start. If it is a gas-powered cart, the engine doesn’t turn over, and if it is an electric cart, the cart doesn’t move. Now, on to the next symptoms…. The engine on the gas-powered cart starts, but the starter doesn’t disengage after starting.

Why doesn't my golf cart solenoid click?

This can be a faulty wire connection, but can also mean the solenoid is beginning to fail. The golf cart solenoid doesn’t click when the accelerator is pressed. This again can be faulty wiring or a failed solenoid.

How to tell if solenoid is bad on golf cart?

The common symptom of a bad solenoid is no clicks when the cart’s ignition is on and you press the accelerator.

Where are the solenoids on a golf cart?

In all golf carts, new and old, the solenoids can be found under the seat or in the engine well and are easily identifiable by the wires that lead to them. Banks of heavy duty solenoids, as in the previous illustration, are mounted on the side or back panel near the electric motor.

What to do if your solenoid is not zero?

If the reading is not zero, then the solenoid is stuck and needs to be replaced. If the ohmmeter does read zero, set the cart to forward travel and turn the key switch on. Press the accelerator pedal (or have a friend do it) and you should hear a click. If you don’t hear a click, measure the resistance anyway.

image
A B C D E F G H I J K L M N O P Q R S T U V W X Y Z 1 2 3 4 5 6 7 8 9