How to Test a Golf Cart Solenoid
- The very first thing you must do is to disable the mobility of your golf cart. ...
- After disconnecting the solenoid, use electric tape and seal each cable end separately. ...
- Turn on the engine of the cart and press the pedal downwards. If you hear a clicking sound, then it means that the low side voltage is working. ...
- Use a voltmeter and engage the solenoid. You should hear a click sound when the engaging is done properly.
- Check for continuity between the two high side terminals on the solenoid using a multimeter. ...
- Set the multimeter reading to ohms and place a lead on each of the two terminals. ...
- Check the power getting delivered to the solenoid. Set the multimeter reading to volts and activate the solenoid circuit by connecting the multimeter leads to the small terminals of the ...
How to check your golf cart for a bad solenoid?
What Are The Symptoms Of A Bad Solenoid In A Golf Cart?
- The first and most obvious symptom is the golf cart won’t start. ...
- The engine on the gas-powered cart starts, but the starter doesn’t disengage after starting. ...
- The solenoid clicks and works sometimes, and sometimes it doesn’t. ...
- The golf cart solenoid doesn’t click when the accelerator is pressed. ...
- The golf cart solenoid clicks, but nothing happens. ...
How to test for a bad solenoid?
Testing the solenoid
- Safety first. The first step that you should undertake, which should be ingrained into your memory, is taking the right safety precautions before beginning.
- Equip yourself. The next step is to have the appropriate tools with yourself that you’ll be using. ...
- Read the manual. ...
- Raise the vehicle. ...
- Locate the plugs. ...
- Activate the voltmeter. ...
- Grab the black wire. ...
How to install a voltage reducer on a golf cart?
- Park the golf cart on a level, hard surface and activate the parking brake. ...
- Keep a jack below the frame at the back of the golf cart. ...
- Lift the golf cart seat upwards until the batteries are exposed.
- Turn on the voltmeter and set the reading to 20 volts. ...
- Check the voltage reading on the voltmeter. ...
How to properly drive a golf cart?
- When you go for your backswing, you should shift your weight backward. This will give your swing more power.
- A lot of times your instinct might be to have a fast backswing thinking that it will give you more power to crush the ball. ...
- Stay flat. ...
- Take a steady backswing and pause at the top to reset before begin your downswing. ...
How do you test a 48v solenoid?
Set your multimeter to ohms and insert a probe on each large terminal with the key off and the cart direction switch in the neutral position. Press on the accelerator with the cart's movement control in the forward position, and the key is turned on. A click should be heard first from the solenoid.
How do I know if my ezgo solenoid is bad?
First, turn on the ignition while looking for a reading on the smaller terminals. If nothing is appearing, then press on the accelerator. If the needle doesn't move, then the problem is not with the solenoid. If it jumps and displays full voltage, then the solenoid is the problem and should be replaced with a new one.
How do I know if my electric golf cart motor is bad?
You have enough going on in your life without your golf car refusing to start when you turn the key in the ignition. If your golf car won't start, is slower than it used to be, or is experiencing other technical problems, you could have a bad motor on your hands.
How do you test a solenoid on a 36 volt EZ Go golf cart?
This can Also be tested by putting a test lead on each small terminal and pressing the gas pedal. The meter should read 36 V when the gas is pressed. If this voltage does exist when the gas pedal is pressed then the solenoid should click and engage.
What are the signs of a bad solenoid?
As a result, the common signs of a bad starter solenoid include:Engine Doesn't Crank or Start. ... No Clicking Noise When Trying to Start the Engine. ... Starter Spins Without Fully Engaging the Flywheel (Rare) ... Engine Cranks Slowly (Rare) ... Test the battery. ... Check That Power is Getting to the Starter Solenoid.More items...•
How do I test a golf cart solenoid?
Turn on the engine of the cart and press the pedal downwards. If you hear a clicking sound, then it means that the low side voltage is working. But, if there is no such sound, it means that either there is no low side voltage or there is a problem with the solenoid. Use a voltmeter and engage the solenoid.
How do you test a golf cart electric motor?
3:5410:28You just want to connect the two together with this again a2 to s1 with this jumper cable. And youMoreYou just want to connect the two together with this again a2 to s1 with this jumper cable. And you want to take the battery box or positive cable and put it on the s2.
How do I test my electric golf cart?
Look for a small red button located near the main power supply. Press the button and put your cart back together before hooking it up to charge. In many cases, this will solve the problem. If it doesn't, try removing the motor and testing it with a separate, fully charged battery.
How do you reset a golf cart electric motor?
First, you'll want to reset your motor. It should have a small reset button (Usually it will be red) located near the main battery supply. Hit the reset button and then put the cover back on the motor. The next step would be to recharge your cart and try turning it on again. If it starts up then you're in luck!
How do I test my EZ GO 36 volt controller?
Check Power Output From the Controller Connect the negative probe to the controller's M terminal and positive probe to the B+ terminal. Press the accelerator and watch to see if the voltage increases. It should increase from a reading of 0 to the full voltage of the battery.
How do you bypass the electric solenoid on a golf cart?
Bypassing Golf Cart Solenoid Method If you do decide to bypass the solenoid, this is what you need to do: Take the two larger wires that connect to the solenoid and connect them directly (keeping all safety precautions in place). This should do the trick and if it does not work then the solenoid is not the problem.
What would cause an electric golf cart not to move?
Solenoid Wear When there is a disruption in the flow of the electrical current, your cart will not operate. A common reason for current disruption is solenoid wear. Each time the solenoid activates as you press down on the gas pedal, the solenoid compounds down onto a thin metal contact plate.
How to test golf cart solenoid?
A diode allows current to run in one direction, but not in the other. Testing the diode is a simple procedure. Remove the diode from the circuit and check the leads with a continuity tester.
How to tell if solenoid is bad on golf cart?
The common symptom of a bad solenoid is no clicks when the cart’s ignition is on and you press the accelerator.
Why doesn't my golf cart solenoid click?
This can be a faulty wire connection, but can also mean the solenoid is beginning to fail. The golf cart solenoid doesn’t click when the accelerator is pressed. This again can be faulty wiring or a failed solenoid.
What to do if your solenoid is not zero?
If the reading is not zero, then the solenoid is stuck and needs to be replaced. If the ohmmeter does read zero, set the cart to forward travel and turn the key switch on. Press the accelerator pedal (or have a friend do it) and you should hear a click. If you don’t hear a click, measure the resistance anyway.
How to tell if a golf cart won't start?
The first and most obvious symptom is the golf cart won’t start. If it is a gas-powered cart, the engine doesn’t turn over, and if it is an electric cart, the cart doesn’t move. Now, on to the next symptoms…. The engine on the gas-powered cart starts, but the starter doesn’t disengage after starting.
Where are the solenoids on a golf cart?
In all golf carts, new and old, the solenoids can be found under the seat or in the engine well and are easily identifiable by the wires that lead to them. Banks of heavy duty solenoids, as in the previous illustration, are mounted on the side or back panel near the electric motor.
How to check if a battery is low?
First, follow these steps: Step 1 – Check the battery voltage from the positive connection to the battery negative. A solenoid uses 12-18volts and low voltage will not activate the solenoid. Step 2 – If the voltage is low, check the cable ends for corrosion. Clean and charge the battery.
How to tell if golf cart solenoid is bad?
One of the most common and obvious signs of the bad solenoid is the golf cart's failure to start when you initiate the ignition process. Once you click the accelerator and turn on the ignition switch, it is supposed to send a signal to activate the solenoid and start the cart. If the cart does not start, there is a big possibility ...
What is a solenoid in golf carts?
Simply put, a solenoid is a device that can transform electrical energy into mechanical energy. It's a coil of wire which is used as an electromagnet. The solenoid has the capability of creating a magnetic field with the help of an electric current. Solenoids work as the “go switch”, which is a must for any golf cart.
Why is my golf cart not starting?
If the cart does not start, there is a big possibility of a damaged solenoid. Another reason for a bad solenoid is that the contacts are starting to get damaged due to overheating or high current passing through them. Note: You may not necessarily experience all of these issues to recognize bad solenoids on your golf cart.
Why won't my golf cart turn over?
For a gas golf cart, the most common symptom is the starter failing to engage, so the engine doesn't turn over. Starters have the responsibility of activating the flywheel. When the flywheel starts to work, the starter is supposed to disconnect.
How to test gold cart solenoid?
You can test the solenoid by simply disconnecting the main circuit high wires and by using a multimeter.
Where is the solenoid located on a golf cart?
The solenoid is located inside the controller box connected to it.
Why is my Ezgo golf cart not clicking?
A EZGO golf cart that is not making a clicking sound can be due to a failed solenoid. If there is no sound in the cart while igniting the switch, then the problem can be the cart’s control circuitry. This means the solenoid has stopped working. Then it is required to replace the solenoid.
What to do if your solenoid is damaged?
Here the formula is simple; if one thinks that the solenoid is damaged, then jump the solenoid from the circuit and check. If the cart starts then, the problem could be the solenoid. If the cart doesn’t start even after jumping the solenoid, then the issue lies somewhere else and not in the solenoid.
Why is my cart solenoid getting hot?
If the cart solenoid is getting hot, then the problem can be with the solenoid or the circuit wiring. It is better to check the solenoid thoroughly. Use proper solenoid, which matches the amperage and voltage of the cart system. Use high-quality solenoid to avoid the heating problem.
What to do if solenoid is not working?
If the solenoid is not working after checking and testing the solenoid using a voltmeter, then it is time to replace the solenoid all together. Always be sure of the model and year of the cart. Check online to get all specifications. Compare the online picture of the new solenoid with the older one.
What happens if a cart starts with a solenoid?
If the cart starts, then the solenoid is the problem and, if it does not, then the problem is not solenoid but something else. A cart owner should remember that bypassing the solenoid can damage the ignition system and central circuit of the cart. Also, bypassing should only be used for checking the solenoid and not permanently.
How to Tell if a Golf Cart Solenoid is Bad
Many golf cart owners had solenoid problems and delay as a result of them. To examine and repair a golf cart, you must first know what a solenoid is.
What Happens To Your Golf Cart When The Solenoid Goes Bad?
The large contacts in a gas golf cart may refuse to release, causing the starter to run even after turning off the ignition. Furthermore, the springs that pull the gear back to its resting state may start to break down, making the starters remain disengaged all of the time. (Starters are designed to get the engine running, then disconnect.)
How Do You Test A Golf Cart Solenoid?
The following steps will tell you how you can test a golf cart solenoid.
Can You Replace The Solenoid On A Golf Cart?
Changing the solenoid on your golf cart is normally easy, but you need a few types of equipment and a basic understanding of how the system operates. The ignition circuit connects to the solenoid, in the engine bay. When turning the key, the solenoid acts as a switch, energizing the ignition coil and igniting the fuel-air mixture.
How Often Does A Golf Cart Solenoid Go Bad?
Your solenoid is prone to overheating as a result of its regular use. As a result, you may notice irregular operation after a while — it may work one time, but not the next. Loose cables or dusty interiors could cause your cart’s inability to start.
