- Switch OFF the golf cart’s engine.
- Reach to where the drive belt is located and use your fingers to press the drive belt between the two clutches.
- The belt must deflect at least one and a half inches under the pressure of your fingers.
- If it doesn’t yield, the drive belt is too tight. If the deflection is more than 1½ inches, then the belt is too loose and it is recommended that you ...
Full Answer
How to tighten drive belt on club car golf carts?
To check if the drive belt is too tight, follow these steps: Switch OFF the golf cart’s engine. Reach to where the drive belt is located and use your fingers to press the drive belt between the two clutches. The belt must deflect at least one and a half inches under the pressure of …
How to adjust the drive belt on an EZGO golf cart?
· Tightening a starter belt on an EZGO GOLFCART. You will need a 9/16 wrench...
How do I know if my golf cart drive belt is bad?
· Quick and easy way to tightened your start v-belt on your Golf Cart.
How do you remove a loose drive belt from a car?
· How Tight Should a Golf Cart Drive Belt Be? The drive belt should not be too tight. If it’s too tight it can risk wearing off faster and it’s also harder to shift gears. To check if your drive belt is set just right make sure your golf cart is turned off then check the drive belt by pressing it down between the two clutches with your finger.
Can you tighten a belt on a golf cart?
And EZGO is no different – there are no screws, knobs, or any other type of adjustment item that you can use to tighten up your belt. Once the belt is one, it has the same tightness and can only be changed if you swap the belt for another one either the proper length and width for your specific cart engine.
How do you tighten the belt on a club car?
Slide the old drive belt off the front drive clutch pulley, and then the rear clutch pulley. Slip the new belt around the golf cart's clutch pulley, and then stretch it out over the front pulley. Pull the front pulley forward slightly to increase the belt tension, and then tighten the tension bolt with the wrench.
How do you tighten the belt on a Yamaha gas golf cart?
0:002:03How to tighten a loose Starter Belt on Yamaha Golf Cart YDRA. G29YouTubeStart of suggested clipEnd of suggested clipAnd wiggle this belt here yeah she's loose. All right my 12 mil uh socket here grab that loosen thatMoreAnd wiggle this belt here yeah she's loose. All right my 12 mil uh socket here grab that loosen that up 17 mil wrench here wrap this down. There you go.
How do I increase the torque of my golf cart?
Change the Speed ControllerThe Speed Controller regulates the electric output of the motor; a higher voltage equals more RPM, and the faster your cart will travel. When you change the speed controller, you can reduce the voltage and increase the amperage of the motor, resulting in increased torque.
How do I know if my golf cart belt is bad?
0:152:00How to Check the Belts in your Gas Golf Cart | Golf Cars UnlimitedYouTubeStart of suggested clipEnd of suggested clipDown below and you don't want to press the moderate pressure on that belt you're gonna want to seeMoreDown below and you don't want to press the moderate pressure on that belt you're gonna want to see about 3/16 to 1/4 inch of deflection. There no more than that that'll be your proper.
How do I know if my golf cart clutch is bad?
What Kinds of Problems Can a Golf Cart Clutch Have?A sudden inability to maintain even slow speeds when heading uphill or changing elevation.Slowing down to a crawl, then speeding up, then slowing again, seemingly without reason.Jolting during startup.A 'cranking' sound when starting up the golf cart.
How do you change the drive belt on a 2018 Yamaha Golf Cart?
0:462:46Yamaha Drive Belt | How to Install on G29 Golf Cart - YouTubeYouTubeStart of suggested clipEnd of suggested clipNow to wet do this on the back clutch or the secondary clutch take the belt and slowly lay it overMoreNow to wet do this on the back clutch or the secondary clutch take the belt and slowly lay it over the top of this outer chief like this just slowly roll it over. And. It will come right.
How do you measure golf cart belts?
0:002:04How to measure for a go-kart drive belt. - YouTubeYouTubeStart of suggested clipEnd of suggested clipCover. Now the first measurement we're going to take on this is we're going to measure from theMoreCover. Now the first measurement we're going to take on this is we're going to measure from the centerline of the crankshaft. To the centerline of the jack shaft.
How can I make my golf cart stronger?
6 Ways You Can Make a Golf Cart FasterAdd More Torque to Your Golf Cart.Upgrade Your Golf Cart's Motor.Improve the High-Speed Controller of the Cart.Add Better Golf Cart Tires.Use a Higher Powered Golf Cart Battery.Watch the Weight in Your Golf Cart.
Why is my gas golf cart running slow?
Low Battery Usually, the most common reason golf carts slow down is when they don't get enough power output from the battery. If the battery pack charge is very low and your cart is out of power, your cart will run slow.
How fast can a golf cart go without a governor?
A typical electric cart without an upgraded speed control tops out around 12 mph.
How to tell if golf cart drive belt is too tight?
To check if your drive belt is set just right make sure your golf cart is turned off then check the drive belt by pressing it down between the two clutches with your finger. If it deflects less than 1.5” it’s too tight.
What is the belt on a golf cart?
The drive belt on a golf cart connects the two clutches (the drive clutch and the driven clutch) and distributes the power from the engine to the rear wheels.
Why is my Ezgo golf cart belt so loose?
The reason your EZGO drive belt is too loose could be because it’s worn out, or you’re simply using the wrong size drive belt. In this case, need to find a replacement immediately. A loose drive belt can result in your EZGO Golf Cart to lose top speed and underperform.
Why is my EZGO belt so tight?
The reason your EZGO drive belt is too tight can be because you’re not using the right size drive belt.
Why is my clutch too tight?
It can also be too tight because the drive/driven clutch is misplaced or broken. A drive belt that’s too tight can damage the drive and driven clutches and can also result in the drive belt being worn out too fast. To check, whether the drive/driven clutch is misplaced or broken call a certified technician to have a look.
What does it mean when the drive belt is misaligned?
Check and see if the drive belt appears misaligned? If so, is it misaligned more towards the driven clutch (the one on the axle) or the drive clutch (the one on the motor)? If it’s misaligned there is something wrong with the drive clutch.
How to stop a EZYGO drive belt from slipping?
How to stop a EZYGO drive belt slipping: Make sure that you have the right drive belt. Sometimes the wrong drive belt will not be as wide as the clutch you are putting it on. This gives it an unwanted room to move back and forth when you are using the golf cart.