how to tighten golf cart belt

by Abbey Cole Published 3 years ago Updated 2 years ago

Switch OFF the golf cart’s engine.
Reach to where the drive belt is located and use your fingers to press the drive belt between the two clutches.
The belt must deflect at least one and a half inches under the pressure of your fingers.
If it doesn’t yield, the drive belt is too tight. If the deflection is more than 1½ inches, then the belt is too loose and it is recommended that you ...

Part of a video titled Changing the Drive Belt and Starter Generator Belt 2008 ...

3:10

5:57

First put the belts on and then tilt the starter generator as far as you can and tighten that nut upMoreFirst put the belts on and then tilt the starter generator as far as you can and tighten that nut up. By hand first and then use the wrench to get it a little bit. Tighter.

Full Answer

How to tighten drive belt on club car golf carts?

Feb 28, 2020 · Tightening a starter belt on an EZGO GOLFCART. You will need a 9/16 wrench...

How to adjust the drive belt on an EZGO golf cart?

To check if the drive belt is too tight, follow these steps: Switch OFF the golf cart’s engine. Reach to where the drive belt is located and use your fingers to press the drive belt between the two clutches. The belt must deflect at least one and a half inches under the pressure of …

How do I know if my golf cart drive belt is bad?

May 19, 2021 · Quick and easy way to tightened your start v-belt on your Golf Cart.

How to replace a clutch on a golf cart?

Jul 14, 2020 · The drive belt should not be too tight. If it’s too tight it can risk wearing off faster and it’s also harder to shift gears. To check if your drive belt is set just right make sure your golf cart is turned off then check the drive belt by pressing it down between the two clutches with your finger. If it deflects less than 1.5” it’s too tight.

How do you tighten a clutch belt on a Club Car golf cart?

Slide the old drive belt off the front drive clutch pulley, and then the rear clutch pulley. Slip the new belt around the golf cart's clutch pulley, and then stretch it out over the front pulley. Pull the front pulley forward slightly to increase the belt tension, and then tighten the tension bolt with the wrench.Sep 19, 2011

How do you tighten the belt on a Yamaha gas golf cart?

Part of a video titled How to tighten a loose Starter Belt on Yamaha Golf Cart YDRA. G29

0:00

2:03

And wiggle this belt here yeah she's loose. All right my 12 mil uh socket here grab that loosen thatMoreAnd wiggle this belt here yeah she's loose. All right my 12 mil uh socket here grab that loosen that up 17 mil wrench here wrap this down. There you go.

Why does my golf cart belt squeal?

Your belt may also be wearing down and even fraying which is a problem that can cause the belt to both squeak and whine as it runs. Replace any frayed belts right away, before they break, to avoid damaging your engine, and lubricate or replace any pulleys which continue to squeak on your cart.

Why does my golf cart bog down going uphill?

The Reason Your Electric Golf Cart Goes Slow Uphill? Your electric golf cart can struggle on inclines for a variety of reasons. Weak batteries, incorrect tires, and wear and tear to the motor and wiring are all potential causes of your cart's slow speed.

How does the clutch work on a golf cart?

Both golf cart clutches look similar to a large pulley but each clutch has a sliding sheave that moves in & out along a central shaft as the clutch spins. The other sheave is fixed to either the crankshaft or the differential input shaft and it does not slide, it just spins.Apr 4, 2012

How do you change the drive belt on a 2018 Yamaha Golf Cart?

Part of a video titled Yamaha Drive Belt | How to Install on G29 Golf Cart - YouTube

0:46

2:46

Now to wet do this on the back clutch or the secondary clutch take the belt and slowly lay it overMoreNow to wet do this on the back clutch or the secondary clutch take the belt and slowly lay it over the top of this outer chief like this just slowly roll it over. And. It will come right.

How do you fix a squeaky cart wheel?

Spray each of the wheels, bearings, and axles with the lubricating oil, allowing the oil to penetrate the wheel and wheel mechanisms for five minutes. Push the cart a few feet and apply a little more lubricating oil to the wheel, if the squeak persists.

How can I make my golf cart ride smoother?

How to Make a Golf Cart Ride Smoother

Correct Tire Pressure. ...
Replace Worn Out Shocks and Struts. ...
Check the Fluid and Filter. ...
Replace the Clutch. ...
Flat Spot in Tire. ...
Tire Damaged or Out of Line. ...
Worn Out Suspension Bushings. ...
Check Your Lift/Tire Combo.

More items...

Why does my gas golf cart go slow uphill?

A fully charged battery can create up to 24 volts. With a voltmeter, determine how much current you need by checking if your cart will move on flat ground with a dead battery. If your golf cart's speed drops significantly as it ascends an incline, your batteries may be weak and need replacement.

How do I increase the torque on my electric golf cart?

Change the Speed ControllerThe Speed Controller regulates the electric output of the motor; a higher voltage equals more RPM, and the faster your cart will travel. When you change the speed controller, you can reduce the voltage and increase the amperage of the motor, resulting in increased torque.Dec 2, 2016

What causes a golf cart to run slow?

Low Battery

Usually, the most common reason golf carts slow down is when they don't get enough power output from the battery. If the battery pack charge is very low and your cart is out of power, your cart will run slow.Jul 14, 2021

What is slipping drive belt on 1985 golf cart?

The 1985 Club Car golf cart is no exception to this. The way the clutches are designed for these golf carts is that there is the drive belt connecting the two, the driven and the drive clutches. It has to be of the appropriate size and tension for it to provide a smooth ride.

Why is my club car belt loose?

The drive belt on your Club Car golf cart may be loose if the belt you have fitted is too large for the golf cart. Some belts can overheat with overuse, or even stretch after a few months and become too loose.

How to remove drive belt?

Removing the drive belt involves holding the belt with both hands in the center between the driven and drive clutches and lifting the belt. You must now rotate the driven clutch counter-clockwise and slip the belt off the sheave. You can then slide the drive belt off the drive clutch.

Why is my club car drive belt so tight?

The reason for a Club Car drive belt being too tight can be because the drive belt is too small for the golf cart. The way to check if the belt is fitted correctly is to push the belt down with one finger at the center between the clutches. It should not deflect more than 1.5inches. It should not be less as well.

Why does my golf cart drive belt slip?

The reason for the drive belt slipping could be that it is of a larger/longer size and therefore loose. You may start feeling the slippage after driving for a while. This is because the belt gets heated up after the golf cart runs for some time and loosens further .

What is the primary function of a golf cart drive belt?

To primary function of a golf cart drive belt is to connect the primary clutch and the secondary clutch. The primary clutch drives the cart and the belt helps it to rotate the secondary clutch (they are referred to as the drive clutch and the driven clutch respectively). The drive belt, unlike some of the other automotive belts, are very thick.

What happens if a golf cart belt is too tight?

If the belt is too tight then your starter will be under strain and this should be avoided. The best test to see if a golf cart drive belt has the correct tension is to use the Finger Test.

Why is my Ezgo golf cart belt so loose?

The reason your EZGO drive belt is too loose could be because it’s worn out, or you’re simply using the wrong size drive belt. In this case, need to find a replacement immediately. A loose drive belt can result in your EZGO Golf Cart to lose top speed and underperform.

How to tell if golf cart drive belt is too tight?

To check if your drive belt is set just right make sure your golf cart is turned off then check the drive belt by pressing it down between the two clutches with your finger. If it deflects less than 1.5” it’s too tight.

What is the belt on a golf cart?

The drive belt on a golf cart connects the two clutches (the drive clutch and the driven clutch) and distributes the power from the engine to the rear wheels.

Why is my EZGO belt so tight?

The reason your EZGO drive belt is too tight can be because you’re not using the right size drive belt.

Why is my clutch too tight?

It can also be too tight because the drive/driven clutch is misplaced or broken. A drive belt that’s too tight can damage the drive and driven clutches and can also result in the drive belt being worn out too fast. To check, whether the drive/driven clutch is misplaced or broken call a certified technician to have a look.

What does it mean when the drive belt is misaligned?

Check and see if the drive belt appears misaligned? If so, is it misaligned more towards the driven clutch (the one on the axle) or the drive clutch (the one on the motor)? If it’s misaligned there is something wrong with the drive clutch.

How to stop a EZYGO drive belt from slipping?

How to stop a EZYGO drive belt slipping: Make sure that you have the right drive belt. Sometimes the wrong drive belt will not be as wide as the clutch you are putting it on. This gives it an unwanted room to move back and forth when you are using the golf cart.

Golf-FAQ.com