How To Tune Up A Yamaha Golf Cart
- Air Filter. The air filter is cylindrical with a foam prefilter sleeve that fits over the paper element. ...
- Spark Plugs. G1, G3 – (2-cycle) medium altitude – number NGK BP5HS. ...
- Fuel. Replace the spark plug and screw into place using the socket and your fingers to prevent cross-threading, because this is aluminum and strips out easily.
- Valve Adjustment. ...
Full Answer
How do you adjust the valves on a Yamaha golf cart?
0:431:38How to Check your Golf Cart's Valve Adjustment | Golf Cars UnlimitedYouTubeStart of suggested clipEnd of suggested clipYou do need to adjust them you can just there's adjusters right here on top of the rockers. You'llMoreYou do need to adjust them you can just there's adjusters right here on top of the rockers. You'll loosen them and adjust accordingly.
How do you adjust the carburetor on a Yamaha g2 golf cart?
How to Adjust Yamaha Golf Cart CarburetorPull out the pilot adjustment screw. ... Rethread the screw back until it's slightly seated.Turn the screw outwards by 1-1/2 turns.Push the throttle stop screw backward until the throttle shaft is closed completely.Turn the screw in by a 1/4 turn.
What engine is in a Yamaha golf cart?
At 357cc and 11.4 horsepower, it is Yamaha's most fuel-efficient carburetor engine. The PowerTech AC enables muscular hill climbing and a smooth ride. At 48 volts, its output is 5.0kw (6.7hp) for up to 60 minutes before recharging.
How do you adjust the governor on a Yamaha g2 golf cart?
0:004:32Yamaha Drive 2 Quietech Governor Adjustment - GET MORE SPEEDYouTubeStart of suggested clipEnd of suggested clipSo sometimes as you're pulling up you need to hit down on the body on each side to release thoseMoreSo sometimes as you're pulling up you need to hit down on the body on each side to release those clips. And then there's just two tabs that slide in in the front.
How do you adjust the carburetor on a Yamaha gas golf cart?
Find the pilot adjustment screw on the edge of your carburetor. Pay attention to this screw – it should be a sharp point and not flat. Carefully remove this screw and then carefully screw it back. Turn this screw out one and one-half turns to adjust it properly.
Why does my Yamaha golf cart backfire?
The golf cart backfires through the carburetor because of an open throttle plate. The accelerator cable at the scale is out of adjustment and, in turn, stops the vessel from closing when the microswitch makes contact with the ignition.
What's the horsepower of a Yamaha golf cart?
11.4 horsepowerOur Yamaha-built engine brings you over 60 years of proven performance featuring a filterless oil system for ease of maintenance. At 357cc's, producing 11.4 horsepower, it's the most fuel efficient carbureted engine in the industry with all the great features built into the Drive2 line of cars.
Where is the reset button on a Yamaha golf cart?
It should have a small reset button (Usually it will be red) located near the main battery supply. Hit the reset button and then put the cover back on the motor. The next step would be to recharge your cart and try turning it on again. If it starts up then you're in luck!
How fast does a Yamaha golf cart go?
19 mphMost electric golf carts are faster than gasoline golf carts. Although, new gasoline and electric golf cart versions of Yamaha all have the same top speed. The top speed of both versions of Yamaha golf carts is 19 mph (31 kph).
How do you adjust the governor on a Yamaha?
0:005:15Yamaha G29 Drive Golf Cart Governor Adjustment - MORE SPEED!!YouTubeStart of suggested clipEnd of suggested clipItself by tightening this nut down you're putting more pressure on the spring. So that the governorMoreItself by tightening this nut down you're putting more pressure on the spring. So that the governor has to work harder to pull back on the throttle.
How do you adjust the governor on a Yamaha electric golf cart?
1:042:57Yamaha G29/DRIVE Governor Speed Increase | ASK DAVE | Golf Cart ...YouTubeStart of suggested clipEnd of suggested clipAnd locating the governor under the service panel in the rear above the engine. For reference it'sMoreAnd locating the governor under the service panel in the rear above the engine. For reference it's just opposite the driven clutch at the rear of the engine. Compartment.
Where is the governor on a Yamaha golf cart?
0:273:57How to Adjust Governor on Yamaha G29 Drive Gas Golf Cart - YouTubeYouTubeStart of suggested clipEnd of suggested clipSo on your car you take the rear inspection panel off right underneath it here. You will have aMoreSo on your car you take the rear inspection panel off right underneath it here. You will have a spring actuated governor this is actually what speeds you up and slows you down.
How many times can a Yamaha engine be rebuilt?
Yamaha engines are durable and because of the simple design, they can be successfully rebuilt 3 or 4 times . Initially, the Yamaha G1 2-cycle gas was the standard-bearer and in 1985 the G2 4-cycle single-cylinder gas engine was introduced as the new standard.
What is a golf cart?
Golf carts are also known as golf cars. The term "cart", in its purest sense, refers to a vehicle that does not travel under its own power. Golf cars, however, are most commonly referred to as golf... link to Club Car DS Wiring Diagrams 1981 To 2002.
Yamaha Golf Cart won't start
did you leave the key on and kill the battery or a light or something double ck that battery , they will still light up the ignition and lights and ll but does not have enough to crank the starter , that is what is sounds like to me be put a jump on it or charge it and try again , when you turn on the ignition does the lights light up on the dash panal if so the batter is low.
Oil and fuel blowing out through top of motor in yamaha golf cart 4 stroke engine
Engine got to much oil in it? Worn engine allowing fuel down into engine diluting the oil and raising the oil level? Blocked engine breather, pressurising the crankcase. Oil change and clean the breather. Worth a try
How do i set the timing on a yz450
Set the piston to TDC (top dead center) this is the higest point the piston will rise before moving on to the down stroke, either by lining up the marks on the crank rotor or a long screw driver (large handle so it wont fall in) down the plug hole and watch for the highest point lock or hold at this point.
Yamaha 4 stroke golf cart back fires all the time..Replaced coils and the carby but no change
Very important... valves get out of adjustment and are easy to set. This is where I would start FOR SURE. Check out www.buggiesgonewild.com and an example of how to do it on EZ GO 295 http://www.buggiesgonewild.com/ezgo-gas-tech/1196-ezgo-295-350-engine-valve-adjustment.html
Vw golf 1.4 16v after changeing timing belt car idles eratticaly or not at all. Timing marks correct at crankshaft, cam pulleys locked as per haynes manual!
The timing could be 180 degrees out you will have to do it all over again. Bring #1 cylinder upto TDC check the distributor rotor arm that it is pointing to #1 plug wire, It is important that the cams are on the intake stroke and not on the exhaust stroke. The crank is no big deal just make sure the marks are lined up.
Will not start up I have no compression but i have fire and fule. It is a Yamaha 2 stroke engine in a yamaha golf cart . Just wondering if it has a compression release on it that i'm not seeing. Garry
I find with two stroke engines the carb gets all gummed up if you store it for the winter. A good carb cleaning usually does the trick
Geting the timing right for my 85 xj 700
86 nissan 4×4 3.0. V6 distributor set with number 1 tdc but timing marks on pulley are about 180 degrees off engine starts and runs
