Speed Adjustments for the EZ Go Golf Cart
- Gasoline Engines. One way to increase the speed of a gasoline-powered EZ Go golf cart is to add an octane booster when you fill the gas tank.
- Electric Motors. Looking at the specifications for EZ Go electric golf carts, you notice a cart with a 36-volt motor is capable of 12 to 14 mph top speed.
- Speed Controllers. ...
- Gearing and Chips. ...
How do you change oil on EZGO golf cart?
Insert the key in the cart’s keyhole and turn it to the right to start it. If you notice that the vehicle’s engine is cold, engage the choke knob by pulling it out. Hold it in the engaged position till the vehicle comes to life, then push the choke knob back. If you’re driving during the night time, ensure that the headlights are switched on.
How to test motor on EZGO electric golf cart?
· Link to part on our website: http://www.diygolfcart.com/EZGO-Throttle-Cable-p/cbl-051(6429).htmLearn how to adjust your governor or throttle cable on an EZGO...
How to install EZGO TXT clays basket on golf cart?
How much does an EZ-GO golf cart cost?
How do you adjust the speed on a gas golf cart?
Tighten the governor spring located in the engine of most golf carts to adjust your cart's top speed. 90% of EZ Go Carts have simple springs which limit the speed of the engine. To raise the top speed of your golf cart, all you need to do is locate this spring and tighten it slightly.
How do I get more power out of my EZ Go gas golf cart?
Change the Speed ControllerThe Speed Controller regulates the electric output of the motor; a higher voltage equals more RPM, and the faster your cart will travel. When you change the speed controller, you can reduce the voltage and increase the amperage of the motor, resulting in increased torque.
How do you adjust the governor on a EZ Go golf cart?
How to Adjust the Governor on a Gas E-Z-Go Golf CartLocate the governor arm mounted on top of the rear axle case underneath the cart. ... Loosen the adjusting locknut on the end of the governor spring. ... Retighten the adjusting locknut.More items...
How do you bypass the governor on a gas golf cart?
0:000:46How to remove governor on a Club Car golf cart - YouTubeYouTubeStart of suggested clipEnd of suggested clipSo the farther you bend that normally the faster it goes and then that's it basically when you wantMoreSo the farther you bend that normally the faster it goes and then that's it basically when you want to return your heart you just bend that back down and go back to normal speed.
Why is my gas golf cart slow?
Low Battery Usually, the most common reason golf carts slow down is when they don't get enough power output from the battery. If the battery pack charge is very low and your cart is out of power, your cart will run slow.
Where is the governor on a gas golf cart?
0:061:28Where Is a Golf Cart Governor Located? - YouTubeYouTubeStart of suggested clipEnd of suggested clipWell a golf cart's governor located is actually down in the motor. Compartment. Some of them theseMoreWell a golf cart's governor located is actually down in the motor. Compartment. Some of them these electric ones nowadays. Actually the governor isn't a true governor. It is a control speed.
Where is the speed controller on an ezgo golf cart?
Flip the maintenance switch All EZ-GO speed controllers are equipped with a maintenance switch that needs to be flipped before you begin work on repairing the problem. You will likely find the switch under the seat of your golf car,t but if you're having trouble finding it, consult your owner's manual.
How do I unlock Freedom mode on EZ Go?
Toggle the forward/reverse switch from the "neutral" position to "reverse" five times in quick succession. After a few seconds, the computer controller will beep four times, indicating it has shifted into the freedom mode.
How to adjust EZ Go cart governor?
To adjust an EZ Go Cart Governor engine, start by removing the seat so that you can access the engine. Once the seat is off, remove the screws from the black plastic cover at the rear of the seat and then set the cover aside.
How to make a golf cart go faster?
Loosen the small nut and tighten the larger nut. The more you tighten the larger nut, the faster your cart will go. Start slowly, only tightening the nut a quarter turn to start. You can over-stress the engine if you try to run it too quickly, and it will skip and potentially burn out if you are too eager.
How to get a cart to move faster?
1. Remove the seat and plastic covering over the engine. Sometimes you'll need to remove screws while some models have seats that pop right out. Expose the engine so that you can get to work adjusting the motor. If you don't have a central governor spring, you can still get your cart to move a little faster.
How to tell if a gas pedal is a governor?
Follow the thickest cable coming from the gas pedal until your find a small spring wrapped around a metal rod. This is the governor. The spring apparatus will have two nuts, one small nut and one larger nut, holding it onto the rod.
How fast can a golf cart go?
Adjusting the governor can make your golf cart go 5–10 mph (8 .0–16.1 km/h) faster. If you do this to an E-Z-GO golf cart, you might be able to go from 15 mph (24 km/h) to 22 mph (35 km/h). It will only take about 5 minutes to do it. Steps.
How to change the speed of a car?
Locate your clutch pedal and line. The clutch is the pedal (sometimes a handle near your knee) that you use to put the car into reverse or change speeds. You can adjust the clutch to send more gas to your engine, moving you faster. ...
How to remove the black plastic cover on a golf cart?
Remove the screws from the black plastic cover at the rear of the seat. There should be five screws in most models. The engine is in the front of golf carts , underneath this panel. Take off the plastic cover and set it aside with the seats.
How to get a golf cart moving?
To get the golf cart moving, first disengage the parking brake. Place your feet on the accelerator and apply minimal force. Increase the acceleration gradually as the vehicle begins to move . The wider pedal next to the accelerator is the brake.
What happens if you don't engage the switch on a golf cart?
If you do not engage the switch, your batteries will drain at a faster rate owing to the charge used by the controller. Solution 2: In the event of complete discharge of your batteries, your golf cart charger might not be able to recharge them.
How to know if your golf cart is rusting?
If you find rust on the wires, make sure to wear gloves before you wipe the rust off. Once you’re done placing the wires in their correct positions, test drive the cart to check if it runs.
Why does my golf cart stop?
Such uneven and jumpy tracks can mess up your ignition wires and displace them. This can cause your cart to stop in the middle of a run. This is a good place to first look when your golf cart dies suddenly.
Why won't my golf cart start up?
Golf carts that run on gas refuse to start up if you idle them away for long periods. Gas becomes unstable when you store it away for long. Once the last trip of the golf cart before winter is done, mix fuel stabilizer to the gas tank to stabilize the gas while the vehicle idles away.
What is worse than hopping on a golf cart on a Sunday morning?
Nothing is worse than hopping on your golf cart on a Sunday morning all excited for a round of golf, only to find your golf cart not starting! If you’re a golf cart owner, there will come a point where you find you and your cart stuck on the golf course. There will come a day where you lose your golf cart key; yet still want to start your golf cart.
What is hot wiring in golf carts?
Hot-wiring is a sure-shot technique to get your golf cart started when you lose or misplace your cart’s key. When all else fails, you can always rely on this technique. The logic behind this technique is simple. The ignition in your golf cart is nothing but a circuit.
Why won't my EZGO golf cart start?
EZGO golf carts may not start due to a transmission problem, corroded battery terminals or a faulty wiring coming from the ignition. Transmission Problem For safety reasons, many EZGO golf carts won’t start if its transmission is not in the Park position. Check and make sure the gear is in the Park position.
Why won't my EZGO RXV move?
Brake Problems: Many times the reason your RXV won’t move is because of brake problems. The RXV is designed to be disabled when there is a problem with the break. Many times, the wiring that connects the brakes to the controller gets loose or is damaged. This can disable your EZGO RXV.
How to unclog a golf cart muffler?
To unclog it, simply make a fire and remove your muffler and put it there.
What to do if replacing ignition wire doesn't work?
To check the continuity of the ignition wire you’ll need to use an ohmmeter or a continuity tester. To do this, set the switch to off and set your ohmmeter to X1.
Why does my golf cart make a clicking noise?
When you press your golf cart pedal you should hear a clicking noise, if you don’t hear a clicking noise there might be a problem with the solenoid. To make sure your solenoid is functioning properly check it with a voltmeter. If you hear a click then you need to check its power with the voltmeter.
Why is my golf cart ignitor failing?
The most common reason for a failed ignitor is a bad voltage regulator. Therefore, when you replace or fix the ignitor on your golf cart, make sure you also check the voltage regulator and see if it needs to be replaced. There have also been cases where the battery has switch polarity for some reason.
What do you need to troubleshoot a golf cart?
While both types of golf cart are different, there are two things you need to troubleshoot whether you have a gasoline or an electric golf cart; the fuse and ignition.
How to adjust a governor spring?
Loosen the adjusting locknut on the end of the governor spring. Rotate the locknut to expand or compress the spring until its length is 2 1/2 inches.
How to increase maximum governed speed?
Check manufacturer's specifications for the maximum governed speed and adjust the governor spring locknut if necessary. Tightening the spring locknut increases maximum governed speed, while loosening the locknut decreases maximum governed speed.
Why won't my TXT golf cart charge?
A TXT golf cart may not charge because of loose or broken wires, a dirty charging port, a blown fuse, or problems with the auxiliary contact.
Why does my golf cart stop moving?
This Golf cart is very temperamental, and even things like over-tightening a stud can make it stop moving. Check the F/R switch stud for overtightening. If it is over-tightened, the contact will not connect with the switch. Adjust this, and your golf cart will start working.
Why does my carburetor smoke?
Excessive amounts of white smoke are a sign that you have a problem with your cooling system. It could also be a sign that you have water in your cart system, so make sure you take the time to clean the carburetor.
Why is my cart sluggish?
If your cart has a dirty carburetor, it may be sluggish during acceleration. You can prevent these issues by regularly cleaning the carburetor.
Why are my golf cart drum brakes stuck?
Drum brakes can get stuck due to rust and corrosion. To remove your E-Z-Go golf cart drum brakes, follow these steps.
What to do if your charger is defective?
If your charger is defective, replace it with a DPI charger.
What does it mean when your cart has blue exhaust?
If you have blue exhaust, something is wrong with your cart. It can be a sign of a problem with your engine oil. Address this problem immediately, as it could lead to an engine fire.
