How do you adjust the shift cable on an EZ GO golf cart?
At times, the cable connecting the forward-reverse shift in the E-Z-GO golf cart may need adjustments that are a little tough to carry out without a proper manual or instructions. A golf cart shift cable adjustment is 1 3/8-inch from the washer and is to be made till the end of the threads.
Why is the shift not working on my EZGO?
Some EZGO owners have experienced the shift working in one direction and not the other. The belt has been seen as one possible reason for the shift not moving freely. You can also check if the belt is of the right length. Some people removed the belt and say the shift worked fine afterward.
How to adjust the shift cable on a Yamaha G16 golf cart?
The adjustment of the shift cable in the Yamaha G16 golf cart is made easy with the nuts on the reverse and forward cables. The most common issue is cables sticking together not allowing easy movement. Use the WD40 or a special lube to free up the cables. The shift cable will function perfectly now.
How to adjust the shift cable on a club car DS?
The procedure for adjusting the shift cable in the club car DS is as follows (you can follow the manual if you have a copy). Ensure that the shift lever is in the neutral position. Loosen up the nuts to make minor adjustments. Once you have the cable in position, tighten the nuts and the job is done.
Ezgo gas golf cart model st350 workhorse. When it sits overnight or longer and I start it, the engine turns briefly but then stops and the vehicle doesn't move
weak battery of voltage drain in the morning take the cable loose look for a tiny spark when you lift the cable end and touch the post repeated ly no tiny sprk key off ? get a battery from something else put in see if it runs down over nite if ? it dosnt maybe time to buy battery
Shifter not working properly on 2008 Jeep Patriot. when put into drive, sometimes drive does not engage
sounds like the shift cable is going or needs to be adjusted go pas drive then return to drive
How do I REPLACE SHIFT CABLE
rtm? no symptoms so i must guess, ill say , cant shift. and is not park lock out causing that.
My 2008 corvette is giving a harsh downshift as I am coming downhill and the manual shift is not in gear?
I am assuming you have an automatic transmission. If you put in neutral and you feel a down shift, then adjust the shift cable. Your probably going to have to do this at/under the console. If you have a manual transmission, then it is internal. Shift forks could be bent, plastic guides are worn out or gone.
My jeep wrangler 2008 - I shifted to reverse then to parking, when i release the breaks it kept going in reverse. So i turn off the engine. now it wont start the engine, neither the shifter will move
The shifter cable has broken more than likely ,Find the shift shaft on the transmission,,block the wheels and remove the shift cable from the shift shaft,put the gear shift in park,then shift the shift shaft in park,then it will start,Then of course you will have to replace the shift cable.
EZGO golf cart won't go forward
Your batteries have died. The reason it will barely move in reverse is that current is being supplied to the motor is a direction that it spends very little time using. There is a slight change in the armature over time, and reverse tends to work better over time. Check the voltage when under load.
My transmission will not go into park. how do i fix that
Install the shift cable end of the shift cable to the transmission shift lever stud ball.