Well check at the starter side of solenoid with test light.Push pedal and see if it dims there if not go directly to starter and check there.If you have 12 volts could be starter,sometimes rotate belt or rock the cart back and forth.Then try again. roger, Small Engine Technician Category: Small Engine
Full Answer
How to fix my Yamaha golf cart that won’t turn off?
Also check the connection of the black and blue wires at the front of your cart’s engine. If you find that the wires are just disconnected, you only need to reconnect them to get your golf cart to shut off properly. Your Yamaha golf cart has a sticking accelerator switch.
Why does my Yamaha G9 golf cart have no power?
Your Yamaha G9 golf cart might have no power because of a clutch problem, a dirty carburetor, or low engine compression. The throttle not opening properly or improperly seated air filter box lid can also be a reason for the golf cart to have no power.
Why is my Yamaha golf cart sticking accelerator switch?
Your Yamaha golf cart has a sticking accelerator switch. If your cart has problems stopping, you might have a sticking accelerator switch on your hands. This will make you need to push the gas pedal multiple times to get it to work properly.
How to tell if a Yamaha golf cart battery pack is failing?
If the spin occurs doing the same test with a big jumper and on the larger posts on the solenoid, then the solenoid is not functioning. The absence of a spin in this test could mean your Yamaha golf cart’s battery pack is failing.
How do I make my Yamaha golf cart idle?
0:523:44How to get your club car to idle - YouTubeYouTubeStart of suggested clipEnd of suggested clipThe black wires gonna be on the bottom half down here you can't see it but just disconnect it onceMoreThe black wires gonna be on the bottom half down here you can't see it but just disconnect it once you disconnect that you're gonna have to get your flat-head screwdriver and turn up the idle.
How do you keep a Yamaha gas golf cart running?
Yamaha G9 golf cart won't stay runningCheck for dirt or dust accumulation in the air filter and if so, clean it. ... Inspect the airbox and check if it has come off loose. ... Check for cracks or leaks in the plastic carb spacer. ... Make sure that the gas is not adulterated with ethanol or water and doesn't have condensation.
How do you bypass the governor on a gas golf cart?
0:000:46How to remove governor on a Club Car golf cart - YouTubeYouTubeStart of suggested clipEnd of suggested clipSo the farther you bend that normally the faster it goes and then that's it basically when you wantMoreSo the farther you bend that normally the faster it goes and then that's it basically when you want to return your heart you just bend that back down and go back to normal speed.
Why does my golf cart only run with choke on?
Dwight Coleman there are usually only a few possibilities if it only runs with the choke. One cause could be an air leak on the carb, head gasket, crankshaft seal. The other could be a clogged low speed and idle circuit.
How do you adjust the governor on a Yamaha golf cart?
0:005:15Yamaha G29 Drive Golf Cart Governor Adjustment - MORE SPEED!!YouTubeStart of suggested clipEnd of suggested clipItself by tightening this nut down you're putting more pressure on the spring. So that the governorMoreItself by tightening this nut down you're putting more pressure on the spring. So that the governor has to work harder to pull back on the throttle.
How do you take the governor off a Yamaha golf cart?
General InstructionsDetach the cable from the carburetor. The cable is about the width of a straw. ... Follow the disconnected cable up to the governor. ... Disconnect the gas pedal cable from the governor and reroute it to the carburetor. ... Using your wrench, remove the bolt on the gas pedal shaft.
How do I turn off speed governor?
1:072:00How to remove your car's speed limiter como sacar limitacion de ...YouTubeStart of suggested clipEnd of suggested clipSelect on that and then. When you press cancel it means you're done and the tune will start toMoreSelect on that and then. When you press cancel it means you're done and the tune will start to upload you'll hear the fan kick on and then when you're all done it'll say the press select to enter.
What does removing the governor do?
Removing the governor will increase the maximum rpm of the engine, but the internal parts of the Predator 212 are designed for 3600 rpm. Generally, this isn't an issue with just the governor removal, the internal parts can usually withstand 5000 rpm without breaking apart (unless you go full throttle for too long).
Where is the governor on a gas golf cart?
0:061:28Where Is a Golf Cart Governor Located? - YouTubeYouTubeStart of suggested clipEnd of suggested clipWell a golf cart's governor located is actually down in the motor. Compartment. Some of them theseMoreWell a golf cart's governor located is actually down in the motor. Compartment. Some of them these electric ones nowadays. Actually the governor isn't a true governor. It is a control speed.
Where is the choke on a Yamaha golf cart?
Choke Cable – Yamaha G22 is a brand new choke cable that mounts to the front of the rear body on a Yamaha G22 gas golf cart. It's an absolutely essential part that's needed to get the engine started. Pull it out to choke the carburetor and release it when the engine begins to run.
How does a Yamaha golf cart fuel pump work?
The fuel pump has several nozzles on it to accept the vacuum line, and both the Fuel In and Fuel Out lines. Inside the pump, there are several diaphragms which use the pulsing action created by the vacuum of the crankcase pressure to draw fuel from the storage tank and push it onward to the carburetor of the golf cart.
How do you adjust the carburetor on a golf cart?
Find the pilot adjustment screw on the edge of your carburetor. Pay attention to this screw – it should be a sharp point and not flat. Carefully remove this screw and then carefully screw it back. Turn this screw out one and one-half turns to adjust it properly.
Why does my Yamaha golf cart have no power?
A Yamaha electric golf cart usually has no power on its solenoid due to a faulty controller, cut wires, or blown-out fuses. Remove the small black wire connected to the solenoid and check if the voltage of its small red wire connection rises to the battery pack voltage. If yes, you have to do a controller replacement.
Why won't my Yamaha golf cart go uphill?
Your Yamaha golf cart will not have power while going uphill if it has a fuel related problem, a worn-out, cracked, or loose drive belt or tension cable, malfunctioning clutches, or low battery voltage.
Why is my Yamaha G16 losing power?
Your Yamaha G16 could be losing power because of a malfunctioning secondary clutch, a broken secondary spring, a worn-out drive belt, or bad fuel. Sometimes, loose wire connections or cable ends, dirty air and fuel filters, a faulty spark plug, or an improper valve adjustment may trigger the problem.
How to check if golf cart is running out of power?
Do a compression test on the golf cart using a compression tester. Low compression can also cause the golf cart to run out of power. Also, check the fuel pressure and ensure that it’s as desired. Check the clutch to see if it’s functioning properly. It should shift out when the cart is on jacks.
Why is my Yamaha G1 golf cart not turning on?
Your Yamaha G1 golf cart may have no power because of cracked seals, a plugged muffler, a fouled spark plug, or low compression. A malfunctioning clutch, an improperly adjusted carburetor, or a worn-out drive belt can also cause this problem.
What to do if a cylinder is not working?
Check the cylinder to see if compression is taking place as desired and note the timing. If it is not working as desired, you may have to change the cylinder.
Where is the fuel filter on a golf cart?
Check if the fuel filter of your golf cart is damaged and do a replacement if necessary. This filter is usually located in the fuel tank of the cart. If it’s not damaged, this is a good chance to get it cleaned.
Why is my Yamaha golf cart not moving?
The main cause of a Yamaha golf cart clicking but not moving, is a faulty controller or solenoid. The battery has to be checked first to see if it’s delivering the right voltage while in the idle state as well as when the pedal is pressed. There can be other reasons for the Yamaha golf cart not moving though you hear the click.
What to do if your G9 golf cart is not clicking?
If you find your G9 Yamaha golf cart not starting nor clicking, check the key components for damage. If you find the parts to in good condition, check the brushes in the starter/generator.
Why is my solenoid not clicking?
The reason why the solenoid is not clicking could be that it is faulty or has no grounding. Experts recommend checking all wiring and cable connections to rule out this possibility. Batteries on your G16 Yamaha golf carts should raise sufficient power to reach the solenoid and the starter/generator.
How to check solenoid on G9 Yamaha?
The solenoid can be checked using an old screwdriver to jump the terminals. Your G9 Yamaha golf cart’s key must be in the start position. If the starter turns when you do this, your solenoid needs to be replaced. You must be careful while doing this crude test; there could be sparks when the two terminals touch.
What is a faulty controller?
The controller is one major component that may have to be replaced. A faulty controller can stall the cart and the click you hear must be from the solenoid. Test the solenoid to see if it is functioning properly. You will require a multimeter, preferably a digital one, or a DVM for this.
Why does my golf cart keep powering off?
If the cart starts powering off after a new installation, then you will know that the issue is caused due to errors with the installation.
How to check battery water level in golf cart?
How to Check Battery Water Levels in a Golf Cart. Check if the voltages in both the batteries are at the designated levels. Also, if the water in the batteries has dried up, it could cause this issue. Check for the electrolyte and water levels in the batteries. Make sure that you are not overcharging or undercharging your batteries as these could ...
Why does my cart have a loose solenoid?
If the connections from the solenoid have become loose or if there is some other loose contact, the cart might behave in this manner. It can also be caused by a faulty motor or a faulty key switch.
Why does my golf cart cut out?
Another reason why golf carts can cut out is due to problems with the battery voltage or water levels.
What happens if you charge your golf cart?
You would have charged up your cart fully but after driving it around for an hour or two, the power would have got drained off completely. If this is a frequent occurrence with your cart, then you will need to take a look at the batteries.
Can you fix a golf cart on your own?
Under NO circumstances should you attempt to fix your golf cart on your own. Doing so is dangerous and could result in serious bodily harm. The information on this website has not been verified for accuracy and should only be used for general information purposes only. Use this information at your own risk.
Is my speed sensor broken?
There is a magnet associated with the speed sensor. Sometimes your speed magnet may be broken but will still be clinging on; only being held by the screw. Unfortunately, you may not realize it is broken until you take the mechanism apart. The speed sensor may not even show any issues. Check if the magnet is broken and if it is, ...