Yes a solenoid that is stuck will cause the cart to run with the key off. It could also be the key switch itself but it's more than likely the solenoid. Welcome to the forum.
Full Answer
Why does my golf cart run with the key switch off?
The golf cart also runs with the key switch off and the cart in neutral. Would this be a solenoid issue? I'm most certain that the switch is setup correctly as everything is working. It's a two position switch. Thanks. Yes a solenoid that is stuck will cause the cart to run with the key off.
Can you turn off a golf cart if it is not working?
If still, it’s not working, you can perform troubleshooting and turn off your car. Why won’t my Club Car golf cart shut off? The problems with a club car golf cart appear when either the OBC or the solenoid is not functioning correctly.
Where does the key switch wire go on a golf cart?
This wire goes from the golf cart key switch assembly to your cart's starter. Visually inspect the solenoid area of the starter, where the key switch wire plugs into the cart. On some cart models, this end of the key switch wire can become dislodged during use on rough terrain.
What are the problems with a club car golf cart?
The problems with a club car golf cart appear when either the OBC or the solenoid is not functioning correctly. OBC regulates the car’s batteries’ charge, and the solenoid supplies the electrical current from the battery to the entire vehicle. Resetting the OBC should solve the problem but if not, check whether the solenoid is okay.
Why won't my golf cart shut off?
Troubleshooting. Switch the car to neutral before turning the key off. The problem with shut down may have occurred from the kill circuit, which is controlled by the top microswitch. You may have to replace the microswitches or solve the problem by tightening up the circuit.
Why does my golf cart keep running?
Yamaha golf carts can keep running and not stop for many reasons. It's usually loose wiring, a sticking accelerator stop switch, a sticking solenoid or issues with the engine stop relay or the voltage regulator.
Where is the reset button on a golf cart motor?
First, you'll want to reset your motor. It should have a small reset button (Usually it will be red) located near the main battery supply. Hit the reset button and then put the cover back on the motor. The next step would be to recharge your cart and try turning it on again. If it starts up then you're in luck!
How do I reset my club car motor?
Easily Reset the Club Car Golf Cart OBCKey switch to off.Set forward/reverse to neutral.Put tow/run switch to tow.Disconnect the negative battery terminal from the battery pack.Put the tow/run switch to run.Put forward/reverse switch to reverse.Put key switch to on.More items...
What are the symptoms of a bad solenoid in a golf cart?
The most common side effect on a gas golf cart is the starter failing to connect, resulting in the engine not turning over and a succession of useless tapping sounds. If your golf cart fails to turn on when you turn the key on, this is the most obvious sign of solenoid failure.
How do I know if my golf cart motor is bad?
You have enough going on in your life without your golf car refusing to start when you turn the key in the ignition. If your golf car won't start, is slower than it used to be, or is experiencing other technical problems, you could have a bad motor on your hands.
Do all electric golf cart motors have a reset button?
Electric golf cart motors have a reset button on their chassis which is designed to put your motor back into its original factory state. While it doesn't repair damage that may have occurred to the motor over the years, obviously, it does help to overturn any changes to the operation which may have occurred.
How do you test a club car motor controller?
To test a club car precedent controller, connect a voltmeter between the negative terminal of your cart's battery and the M terminal on the controller. Then push the pedal down and look for a clicking noise from the solenoid. Your batteries should read as full.
How do I reset my golf cart?
If you've charged and cleaned your battery and you're still having electric golf cart problems, your next step is to check the motor. Believe it or not, it may be as simple as pressing a reset button. Use a screwdriver to expose the motor. Look for a small red button located near the main power supply.
How do I know if my Club Car controller is bad?
X Common Symptoms of Controller FailureTop Speeds Not Appropriate for Your Cart. Golf carts are designed to reach pretty specific speeds and to not go over them or beneath them. ... Sudden and Unexpected Slowing. ... Shuttering or Shaky Driving. ... Stalling Out and Refusing to Start. ... Surges in Speed When Driving.
Why did my electric golf cart just stop?
When there is a disruption in the flow of the electrical current, your cart will not operate. A common reason for current disruption is solenoid wear. Each time the solenoid activates as you press down on the gas pedal, the solenoid compounds down onto a thin metal contact plate.
How do you troubleshoot an electric golf cart motor?
There are a few simple problems that you can fix yourself that will not necessitate professional maintenance.Test the wall socket where you charge your cart. ... Expose your golf cart batteries. ... Test the batteries for voltage. ... Replace dead batteries. ... Expose the motor for inspection. ... Reset the motor. ... Test the cart.
Where is the speed sensor located on a Club Car golf cart?
The speed sensor in a Club Car Precedent golf cart is located on the back of the motor. To remove the sensor, unplug the cables behind the motor. You can use a 5/16-inch socket to remove the pigtail connector and pop off the plastic housing that encases the speed sensor.
Where is the micro switch on golf cart?
In a golf cart, you're going to find a large number of these switches throughout its build. For example, there is a micro switch located on the accelerator pedal. This switch activates when you push the pedal and sends a signal to the solenoid.
How do you adjust the carburetor on a Club Car golf cart?
Find the pilot adjustment screw on the edge of your carburetor. Pay attention to this screw – it should be a sharp point and not flat. Carefully remove this screw and then carefully screw it back. Turn this screw out one and one-half turns to adjust it properly.
Where is speed sensor on EZ Go golf cart?
The speed sensor on an EZGO TXT golf cart is located close to the motor. This sensor is present on the rear side of the motor on the driver's side of the golf cart.
Why does my golf cart keep turning off?
When a Golf Car is shutting off without warning, it’s because of low battery voltage, dead batteries, or because the solenoid coil is overheating. Low battery voltage: Sometimes a dip in the minimum voltages of both batteries causes the Golf Cart to turn off randomly. It is best to use a voltmeter and check if the voltages ...
What happens if the voltage goes down on a golf cart?
Again, when the voltages go down, it will hit minimum and all the power that is gained shall be lost.
Why does my Yamaha G2 keep shutting off?
Yamaha G2 golf cart keeps shutting off: The Yamaha G2 Golf Cart may keep shutting off due to one of the following reasons: Loose solenoid wiring: The first check should be done whether the wiring on the golf cart is in right condition.
How to fix an EZGO golf cart?
The ways to fix a EZGO are stated below: Check the Solenoid contacts: The wires connecting the solenoid may not have electricity flowing due to which the Golf cart is getting abruptly shut off. It is recommended to change the wires connecting the solenoid and check if the problem gets sorted.
Why does my golf cart cut out?
A golf cart may cut out at full throttle due to a faulty solenoid that needs replacing, or having too low of a battery voltage. Solenoid needs replacing: It may be that the solenoid of the Golf Cart may have developed some glitches due to which it is not responding at full throttle.
Why is my controller not connecting to the solenoid?
It is advisable to check the connections out there to check if the wires are getting disconnected.
Can you replace solenoid on golf cart?
Replacing the solenoid helps in most cases but it is advisable to get it checked at an authorized service center. Battery voltage is too low: In many instances, the batteries may not be carrying adequate amounts of voltage to keep the Golf Cart in running order. The voltages of the batteries should be checked via a voltmeter to see ...
Why won't my Yamaha golf cart shut off?
The reason why a Yamaha golf cart does not shut off can be because of loose wires or a faulty voltage regulator. Check to see if the engine wire connections are faulty. Also check the connection of the black and blue wires at the front of your cart’s engine. If you find that the wires are just disconnected, you only need to reconnect them ...
How to tell if a golf cart has a faulty stop relay?
Your golf cart has a faulty engine stop relay. You can check if your engine stop relay is faulty by unplugging it and then seeing if it shuts down . If you have a faulty engine stop relay, you need to replace it.
What to do if your solenoid is not clicking?
If you didn’t get a clicking sound, take your voltmeter and set it to DC volts on the 200 scale. Place a probe on each small terminal. With the cart in the forward position and the key on, step on your cart’s accelerator.
Why is my gold cart sticking?
There’s probably a sticking solenoid problem with your gold cart if there’s a noticeable lag between when you push the pedal and when your cart starts to crank. You can check and test for this problem using a voltmeter or test light. If you have a faulty solenoid, you need to replace it.
How to check if a Yamaha G9 has a sticky accelerator stop switch?
How to check if your Yamaha G9 golf cart has a sticky accelerator stop switch. Remove the floor mats from your Yamaha G9 golf cart. Take out the exposed floor plate and then unplug the stop switch. Next, open the wiring harness clip.
Why does my Yamaha golf cart keep running?
Your Yamaha golf cart probably keeps running because of loose wires, a sticking accelerator stop switch or a sticking solenoid. It could also be a problem with the engine stop relay or a problem with the voltage regulator. Your Yamaha golf cart keeps running because of loose wires. If you suspect the issue is loose wires, ...
How to check if a G9 golf cart has a sticky solenoid?
How to check if your Yamaha G9 golf cart has a sticky solenoid. Unplug all the cables from the two large terminals. Wrap the cable ends in electrical tape and make sure to keep them separated. Put the cart direction switch in the neutral position with the key off.
Why replace the key wire on a golf cart?
Replace the golf cart key switch wire if the connector to the key switch or solenoid is significantly frayed or corroded. Over time, corrosion will build up on the ends of the wire due to exposure to damp weather. Significant corrosion build-up can prevent your cart from starting consistently and ultimately result in the cart failing to start.
What direction does a golf cart transmission selector go?
Confirm that your golf cart transmission selector switch is set fully to the forward, reverse or park direction , depending on your model of golf cart. If the switch is partially set in between modes, it can result in your cart failing to start correctly.
Why is my golf cart speed controller not working?
There are many reasons behind a speed controller malfunction. The most common problem that happens in the controller has aged due to infrequent use. These are just some of the issues that could be affecting your vehicle's acceleration. If you have trouble finding the issue of your golf cart accelerator, don't be afraid to take it to the mechanic.
What happens if your golf cart doesn't accelerate?
Bad Solenoid. If your golf cart does not accelerate, there is a possibility of the damaged solenoid. The solenoid is basically an electrical switch that enables the battery's flow from the battery into the motor. Check out the signs of the bad solenoid.
Why is my golf cart not accelerating?
When your electric golf cart does not accelerate, the first thing you need to keep in mind is that it is not a regular vehicle like your car . That's why the methods and solutions you use to get your car to start are not the same as the solutions you can apply to your cart.
How does a golf cart solenoid work?
The golf cart speed controller and solenoid are both controlled by the accelerator. The pedal is connected to the potentiometer. That means when you are pressing the pedal for acceleration, you are actually going through the potentiometer by pushing a rod. The potentiometer works as a communicator and tells the speed controller how much voltage it ...