Golf-FAQ.com

my golf cart stays running when pedal is up

by Mr. Jess Von MD Published 2 years ago Updated 2 years ago
image

Your Yamaha golf cart probably keeps running because of loose wires, a sticking accelerator stop switch or a sticking solenoid. It could also be a problem with the engine stop relay or a problem with the voltage regulator. Your Yamaha golf cart keeps running because of loose wires.

Full Answer

Why does my club car golf cart keep running?

Why does my Club Car golf cart keep running? Most club car users face this problem. Mainly the problem occurs if the OBC or On-Board Computer is not functioning correctly. OBC monitors and controls the overall functioning of the car.

Can you turn off a golf cart if it is not working?

If still, it’s not working, you can perform troubleshooting and turn off your car. Why won’t my Club Car golf cart shut off? The problems with a club car golf cart appear when either the OBC or the solenoid is not functioning correctly.

Why does my golf cart stall when I accelerate forward?

If a golf cart runs in reverse, but stalls when running forward and accelerating, this indicates a faulty f/r switch. Measure the battery voltages to check if they’re working fine. Check if the positive wire is in place. The positive wire is very often placed to the wrong battery from the charger receptacle.

How do I make my golf cart run again?

You may have tried to make it run by getting the choke on. The cart will generally oblige and run for a few minutes before shutting off again. By letting the engine cool off for a few hours, you may be able to start the cart and make it run for some time. After running the engine for a while, the cart may once again die.

image

What causes a golf cart to keep running?

Yamaha golf carts can keep running and not stop for many reasons. It's usually loose wiring, a sticking accelerator stop switch, a sticking solenoid or issues with the engine stop relay or the voltage regulator.

Why won't my golf cart shut off?

Troubleshooting. Switch the car to neutral before turning the key off. The problem with shut down may have occurred from the kill circuit, which is controlled by the top microswitch. You may have to replace the microswitches or solve the problem by tightening up the circuit.

How do you reset a golf cart controller?

Easily Reset the Club Car Golf Cart OBCKey switch to off.Set forward/reverse to neutral.Put tow/run switch to tow.Disconnect the negative battery terminal from the battery pack.Put the tow/run switch to run.Put forward/reverse switch to reverse.Put key switch to on.More items...

Where is the reset button on a golf cart?

Identify your main battery supply (usually the largest battery) on your motor. Check around this supply for a small red button that may or may not be labeled “Reset”. Press and hold this button for a few moments and then release it to reset the motor.

How do I know if my golf cart controller is bad?

X Common Symptoms of Controller FailureTop Speeds Not Appropriate for Your Cart. Golf carts are designed to reach pretty specific speeds and to not go over them or beneath them. ... Sudden and Unexpected Slowing. ... Shuttering or Shaky Driving. ... Stalling Out and Refusing to Start. ... Surges in Speed When Driving.

What does a solenoid do on a golf cart?

The solenoid is the small unit that rides on top of the starter in the engine. The solenoid brings power from the battery to the rest of your golf cart. With the use of an electric charge, a solenoid may generate a magnetic field.

How do you test a golf cart motor controller?

How to Test a Club Car Golf Cart Speed Controller? The simplest test to ascertain your golf cart controller's performance is to to watch whether it runs when the batteries are fully charged with a slight push of the pedal. If you hear a distinct clicking noise, then your golf cart is running correctly.

How do you test a controller on a club car?

2:5915:0248 Volt Club Car Diagnostics - YouTubeYouTubeStart of suggested clipEnd of suggested clipOut of the key switch. And into this micro switch. Now to make sure this micro switch is working.MoreOut of the key switch. And into this micro switch. Now to make sure this micro switch is working. Now this will also give us light even if it's not at 4-4 or reverse it's in neutral it gets light as

What are the 4 terminals on a golf cart motor?

If you're unsure if it is working, it is simple to test. There are four terminals on a solenoid: usually two large and two small. The small terminals are connected to the battery, and the large terminals are connected to the motor. Disconnect all wires from the two large terminals.

Does a gas golf cart have a reset button?

It should have a small reset button (Usually it will be red) located near the main battery supply. Hit the reset button and then put the cover back on the motor. The next step would be to recharge your cart and try turning it on again.

How do you reset the motor on a EZ Go golf cart?

Look in the area where several electrical wires enter the motor and locate a small red button. This is the reset button. Push the button to reset the motor. Put the panel in place and secure it with the screws.

How do you know if your club car motor is bad?

You have enough going on in your life without your golf car refusing to start when you turn the key in the ignition. If your golf car won't start, is slower than it used to be, or is experiencing other technical problems, you could have a bad motor on your hands.

How do I reset my EZGO controller?

Reset the battery cable Unplug the negative battery cable (the black wire) before beginning any work on the speed controller. Once disconnected, you should remove the speed controller cover and then reconnect the negative cable.

How do I reset my Club Car DS controller?

How to reset your Club Car's OBC after a faultKey Switch to Off.Forward/Reverse to Neutral.Tow/Run Switch to Tow.Disconnect the Battery NEGATIVE (–) wire from the Battery Minus terminal on the battery pack.Put the Tow/Run to Run.Forward/Reverse Switch to Reverse.Key Switch to On.Lock the throttle pedal down.

How do you test the speed controller on a EZGO golf cart?

Connect the negative probe to the controller's M terminal and positive probe to the B+ terminal. Press the accelerator and watch to see if the voltage increases. It should increase from a reading of 0 to the full voltage of the battery. If the motor is not turning, the problem may be in the directional switch or motor.

How do you fix a golf cart that won't move?

When the cart won't move, you have to be sure that the batteries are sending sufficient power to the circuit. You must check the fuse. Use the voltmeter to check the voltage at the key switch. In a cart with batteries rated at 48V, it must show 48V at the key switch.

How do you fix a Yamaha golf cart that keeps running?

It’s usually loose wiring, a sticking accelerator stop switch, a sticking solenoid or issues with the engine stop relay or the voltage regulator.

How to tell if a golf cart has a faulty stop relay?

Your golf cart has a faulty engine stop relay. You can check if your engine stop relay is faulty by unplugging it and then seeing if it shuts down . If you have a faulty engine stop relay, you need to replace it.

Why won’t your Yamaha golf cart shut off?

The reason why a Yamaha golf cart does not shut off can be because of loose wires or a faulty voltage regulator.

Why is my gold cart sticking?

There’s probably a sticking solenoid problem with your gold cart if there’s a noticeable lag between when you push the pedal and when your cart starts to crank. You can check and test for this problem using a voltmeter or test light. If you have a faulty solenoid, you need to replace it.

How to check if a Yamaha G9 has a sticky accelerator stop switch?

How to check if your Yamaha G9 golf cart has a sticky accelerator stop switch. Remove the floor mats from your Yamaha G9 golf cart. Take out the exposed floor plate and then unplug the stop switch. Next, open the wiring harness clip.

Why does my Yamaha G16 keep running?

Your Yamaha G16 golf cart can keeps running because of a accelerator switch that keeps sticking.

How to check if a G9 golf cart has a sticky solenoid?

How to check if your Yamaha G9 golf cart has a sticky solenoid. Unplug all the cables from the two large terminals. Wrap the cable ends in electrical tape and make sure to keep them separated. Put the cart direction switch in the neutral position with the key off.

Why is my golf cart not accelerating?

When your electric golf cart does not accelerate, the first thing you need to keep in mind is that it is not a regular vehicle like your car . That's why the methods and solutions you use to get your car to start are not the same as the solutions you can apply to your cart.

What happens if your golf cart doesn't accelerate?

Bad Solenoid. If your golf cart does not accelerate, there is a possibility of the damaged solenoid. The solenoid is basically an electrical switch that enables the battery's flow from the battery into the motor. Check out the signs of the bad solenoid.

Why is my golf cart speed controller not working?

There are many reasons behind a speed controller malfunction. The most common problem that happens in the controller has aged due to infrequent use. These are just some of the issues that could be affecting your vehicle's acceleration. If you have trouble finding the issue of your golf cart accelerator, don't be afraid to take it to the mechanic.

How does a golf cart solenoid work?

The golf cart speed controller and solenoid are both controlled by the accelerator. The pedal is connected to the potentiometer. That means when you are pressing the pedal for acceleration, you are actually going through the potentiometer by pushing a rod. The potentiometer works as a communicator and tells the speed controller how much voltage it ...

How do you know it's an Accelerator Problem?

If your cart does not start smoothly , hesitates before starting, or does not gain speed properly , these are all signs of a bad or damaged accelerator.

What to do if your golf cart wheels don't turn?

Jack up your golf cart and try to turn one of the rear wheels. If the wheels don't turn, you're probably looking at a stripped axle. This will require service and replacement. If the wheels do turn, there are a few other issues that may be occurring here, such as a problem with the input shaft. You may need to take the motor out to get ...

What If It Does Run, But Only For a Few Minutes?

If your golf cart starts up fine and you're able to take it short distances, but find that after a few minutes it simply comes to a stop, you may be looking at a problem with your solenoids. If these have begun to break down, you'll likely need to replace them in order to get your golf cart up and moving again. Luckily, replacing the solenoids is quick and usually doesn't present much difficulty.

Why does my golf cart spin out?

The brake bub will spin out when there is too much load to prevent any damage to the rear axles, causing the golf cart to stall on hills. Remove the covers from the rear wheel. Notice the castle nuts that are holding the hub to the axles. Apply the brakes.

Why do golf carts stall when accelerated?

If a golf cart runs in reverse, but stalls when running forward and accelerating, this indicates a faulty f/r switch.

Why does my EZGO golf cart hesitate?

The main reason why an EZGO Gas golf cart hesitates while accelerating, is because of a dirty carburetor. A dirty carburetor causes this hesitation. Regular cleaning can prevent this problem. Check the rubber boot and clean if you spot any dirt. In case it has worn out too much, you can replace the carburetor.

How to check for leaks in golf cart?

You can check for any leaks by following these steps: Crank up the golf cart and check every seal for leakage. You can also spray wd40 at the clutch to find leaks. When the cart becomes hot, the voltage also drops. So, make sure you provide enough voltage to the batteries so the cart can run.

How to check if a cart is stalling?

You can easily check that. Run your cart for a few feet and feel the temperature. The same loose ends can also cause the cart to stall. Check every connection inside the battery for proper connection.

Why does my golf cart stall?

The most common reason why your golf cart is stalling is due to a bad solenoid or a faulty speed controller. Batteries have lost charge. Faulty ignition. Problem with the direction switch. Faulty speed controller. Bad solenoid. The solenoid wears out every time the gas pedal is pressed down. The solenoid gets pressed down to a thin plate.

Why does my cart stutter?

If you change the battery, change the charger as well; otherwise, the battery will keep running down. If your cart seems to run fine for a few feet, and then it stutters, it is most likely the batteries. If it is not the battery, then check if it is the speed controller or the resistor.

What does it mean when a golf cart doesn't produce enough power?

Inspect the battery connections throughout the golf cart. If it doesn't produce this much power, then it indicates the battery is not outputting properly.

Why is my golf cart slow?

Usually, the most common reason golf carts slow down is when they don't get enough power output from the battery. If the battery pack charge is very low and your cart is out of power, your cart will run slow.

How to Increase your golf cart speed?

Are you looking to increase your golf cart speed? Learn more about how to make your golf cart go faster.

Why is my Ampacity controller not working?

Usually, this issue arises when the controller has not been installed correctly. Consult with a professional to ensure that you don't run into any problems. Sometimes repair experts may use aftermarket items that don't fit properly on your ampacity controller and cause it to run poorly or fail and leave you with a cart that runs slow.

What happens if your golf cart speed sensor breaks?

So, it will send less power to your engine and cause it to produce less speed as well as cause accelerator problems in the golf cart .

How to check battery connections?

Take a digital voltmeter and connect it to your battery pack and check the connections.

Why does my cart slow down?

Check Mud and Dirt Build-up: Although the speed sensor is a tricky part that withstands some wear and tear, there's a good chance that your cart will slow down because of dirt or mud build-up.

Why does my golf cart keep powering off?

If the cart starts powering off after a new installation, then you will know that the issue is caused due to errors with the installation.

What happens if you charge your golf cart?

You would have charged up your cart fully but after driving it around for an hour or two, the power would have got drained off completely. If this is a frequent occurrence with your cart, then you will need to take a look at the batteries.

What does the first beep sound on a cart mean?

The manual will have the list of beeps and their respective fault codes. The first beep sound will indicate the performance factor.

How to check battery water level in golf cart?

How to Check Battery Water Levels in a Golf Cart. Check if the voltages in both the batteries are at the designated levels. Also, if the water in the batteries has dried up, it could cause this issue. Check for the electrolyte and water levels in the batteries. Make sure that you are not overcharging or undercharging your batteries as these could ...

Why does my cart have a loose solenoid?

If the connections from the solenoid have become loose or if there is some other loose contact, the cart might behave in this manner. It can also be caused by a faulty motor or a faulty key switch.

What causes a cart engine to die?

If your cart engine dies suddenly, it may be the carburetor causing the issue. Read the following steps to fix it:

Why does my golf cart cut out?

Another reason why golf carts can cut out is due to problems with the battery voltage or water levels.

image
A B C D E F G H I J K L M N O P Q R S T U V W X Y Z 1 2 3 4 5 6 7 8 9