What size are the terminals on an electric golf cart motor?
Sepex motors also have two different sized terminals connections. The A1 and A2 terminals are 5/8″ and the F1 and F2 terminals are 1/4″. It sounds absurd, but if your electric golf cart is not running, the very first thing I would check is the reset button on the side of the motor, if your cart is so equipped.
What does A1 A2 and F2 mean on a motor?
Sepex or Separately excited motors are almost always marked A1, A2 and F1, F2 The F stands for field and that also is the stationary windings in the motor. You must log in or register to reply here.
What does series mean on a golf cart?
Series Carts – ” Golf carts with series motors. “ If you look under the seat and you Do NOT have a Run / Tow or Run / Maint. Switch it is a Series Motor System.
What does A1 A2 A2 S1 S2 mean?
Hopefully I can get out to the garage this weekend and get this thing moving Series motors are almost always marked A1,A2 and S1, S2 S stands for stater and that is the stationary windings of the motor.
What is A1 a2 and S1 s2 on DC motor?
DC motor terminal leads are labeled for easy identification in the motor's terminal box. For example, leads labeled "A1" and "A2" are connected to the armature through the motor's brushes; leads labeled "S1" and "S2" are the ends of the series field; and leads labeled "F1" and "F2" are the ends of the shunt field.
What are the 4 terminals on a golf cart motor?
If you're unsure if it is working, it is simple to test. There are four terminals on a solenoid: usually two large and two small. The small terminals are connected to the battery, and the large terminals are connected to the motor. Disconnect all wires from the two large terminals.
How do you reset a golf cart electric motor?
First, you'll want to reset your motor. It should have a small reset button (Usually it will be red) located near the main battery supply. Hit the reset button and then put the cover back on the motor. The next step would be to recharge your cart and try turning it on again. If it starts up then you're in luck!
How do I know if my electric golf cart motor is bad?
You have enough going on in your life without your golf car refusing to start when you turn the key in the ignition. If your golf car won't start, is slower than it used to be, or is experiencing other technical problems, you could have a bad motor on your hands.
Are all electric golf cart motors the same?
Electric golf carts have two different types of motor options: DC and AC motors. The first type was the most commonly used for years, but a growing number of cart manufacturers are shifting to AC motors.
How do you test a golf cart motor series?
4:1210:28Testing 36 volt golf cart motor with 12 volt battery - YouTubeYouTubeStart of suggested clipEnd of suggested clipAgain i'm going to take the jumper cable from a2 to s1 you're going to take the positive cable fromMoreAgain i'm going to take the jumper cable from a2 to s1 you're going to take the positive cable from the jumper. Box to s2 i'm going to take the negative from the jumper box and put it on a1.
Do all electric golf cart motors have a reset button?
Electric golf cart motors have a reset button on their chassis which is designed to put your motor back into its original factory state. While it doesn't repair damage that may have occurred to the motor over the years, obviously, it does help to overturn any changes to the operation which may have occurred.
Where is the reset button on EZGO motor?
Locate the motor Remove the panel so the electric motor is visible. Electric motors usually include reset buttons that can perform similar to circuit breakers. Look in the area where several electrical wires enter the motor and locate a small red button. This is the reset button.
What would cause an electric golf cart not to move?
Solenoid Wear When there is a disruption in the flow of the electrical current, your cart will not operate. A common reason for current disruption is solenoid wear. Each time the solenoid activates as you press down on the gas pedal, the solenoid compounds down onto a thin metal contact plate.
Will an electric golf cart run with a bad solenoid?
The ability of your golf cart to function properly depends largely on the solenoid. If the solenoid is broken and not working correctly, you may notice your golf cart won't start, picking up speed, or even working at all (issues with acceleration could also be caused by a bad speed controller).
How long do electric golf cart motors last?
Golf Cart Motor Just like solenoids (mentioned above), your golf cart motor works HARD. When properly taken care of, the typical gas or electric golf cart motor can last many, many years (20 to 30+).
Why does my golf cart click but not move?
A Club Car golf cart can start clicking but not move, due to dust accumulating inside the battery ports. Opening the battery ports and checking whether there is any dust accumulation can tell you if this is the case. Cleaning it thoroughly with a cloth can resolve the problem.
How does a golf cart electrical system work?
The electric motor receives electric current through the electrical system to move faster or slow down. When the electric motor receives the electric current, it turns the wheel to get the golf cart to move. The more current it produces, the faster it turns!
How does a golf cart motor controller work?
Essentially, your golf cart's speed controller sends its current and battery voltage to its motor. This process depends on your golf cart's input device, which includes its throttle. That's how your golf cart's speed controller lets you operate its acceleration rate, as well as its deceleration rate.
How do you test a golf cart motor controller?
How to Test a Club Car Golf Cart Speed Controller? The simplest test to ascertain your golf cart controller's performance is to to watch whether it runs when the batteries are fully charged with a slight push of the pedal. If you hear a distinct clicking noise, then your golf cart is running correctly.
How do you wire a solenoid on a golf cart?
0:062:30Upgrading Your Golf Cart Solenoid - Heavy Duty Solenoid Installation ...YouTubeStart of suggested clipEnd of suggested clipThere we'll have our resistor. So what we're going to do is go to remove our to activation circuitMoreThere we'll have our resistor. So what we're going to do is go to remove our to activation circuit wires we have our negative. And now we're positive. And if will notice the diode.
What is a regen golf cart?
If your golf cart motor has wires coming out the end and has a speed sensor it is a Regen Motor. If your golf cart has a toggle switch for the Forward / Reverse Selector you have a regen cart.
What motor do you have if you don't have wires?
If you do not have wires coming out the end of the motor or speed sensor you have plain motor or Series motor system. If your golf cart has a handle and throw lever for the Forward / Reverse Selector you have a Series Motor. Lastly if you are under the golf cart and you see two different sets of threaded anchor bolts but all are ...
When did golf carts start having separate excited motors?
In 1999, some golf cart manufacturers started offering Separately Excited Motors. Sepex (Regenerative) Motor carts have a toggle switch F&R device as opposed to the lever-action. In addition to this identifier, they have a tow/run or tow/maintenance switch which cuts power to the controller. Most of the modern-day carts are equipped ...
What is wrong with my electric golf cart?
Electric golf carts are usually trouble-free and do their job efficiently and with no fuss, but sometimes you suspect your golf cart is experiencing a problem. If the speed seems to be off, or your cart gives off a burning wire smell, your golf cart motor might have a problem. Using a multimeter, a jumper wire, and a 12-24 volt power source, ...
What is a series motor?
A series motor has field and armature windings that have the power fed to them from the same source, either in series or parallel. A SePex motor, as the name indicates, is a motor that has a separately excited field and armature windings. These two motor functions are sent to the PDS or DCS giving greater control over the motor.
How to check if electric golf cart is running?
It sounds absurd, but if your electric golf cart is not running, the very first thing I would check is the reset button on the side of the motor, if your cart is so equipped. Check around the outside of the motor and see if you can find a small button to press. This is usually a safeguard against overheating.
What is a golf cart?
Golf carts are also known as golf cars. The term "cart", in its purest sense, refers to a vehicle that does not travel under its own power. Golf cars, however, are most commonly referred to as golf... link to Club Car DS Wiring Diagrams 1981 To 2002.
Why is it important to test a motor before replacing a controller?
This is an important test to do on your motor before replacing the controller because a short could damage the new controller irreparably. Please note that this test will not find a short in the armature. Note that continuity testing is not directional, so it doesn’t matter if the red and black are reversed.
What are the two studs on a motor?
Two studs are for the field coil and two studs have the brushes connected to them . The studs on the motor have nothing to do with fast and slow speed. If the studs are getting to hot to touch you may have a bad connection, bad cable or bad brushes in the motor. J.
How many studs are in a motor?
The motor will have 4 studs. Two studs are for the field coil and two studs have the brushes connected to them. The studs on the motor have nothing to do with fast and slow speed. If the studs are getting to hot to touch you may have a bad connection, bad cable or bad brushes in the motor.
How does amperage affect golf carts?
It determines how far you can travel before having to fill up the tank. Well, Amperage in a golf cart is like the gas tank in your car. It will determine how far you can travel on a single charge in an electric Golf Car. The more amperage in a battery pack, the further you can drive before having to charge. Click here to learn how ...
Why is it important to know the difference between golf cart batteries?
The reason understanding their differences is so important is due to the large expense of replacement batteries. By knowing their differences ahead of time, you will be able to decipher which battery pack is suitable for you when making your golf cart purchase.
How many volts are in a golf cart battery?
Now that we understand the differences between Amperage and Voltage, we can begin to break this down so we can locate the differences between various battery packs. For standard golf carts, we will typically see a Six Eight Volt Battery System. This can be visually determined by locating six batteries with 8 cells per battery. A cell is distinguished by a battery cap that is used for watering the batteries. With batteries used in Golf Carts, each cell will represent 2 Volts. Let’s take a look at the 5 most common battery packs we see in the market:
What is the relationship between horsepower and MPG?
To get a better idea of what amperage is like in a car, let us discuss the relationship between Horsepower and MPG. Horsepower within a car determines the acceleration and power of your car . If there is no fuel in the car though, then the vehicle is not going to go anywhere. That is the importance of MPG and also how big your gas tank is in your ...
Is voltage in a golf cart battery similar to horsepower?
Therefore, Voltage in a battery pack inside of an electric vehicle has to do with power. It does not have to do with fuel. Therefore, voltage in a battery pack within a golf cart will be comparable to the horsepower in a car.
What does S2 stand for in motors?
Oct 24, 2019. #10. Series motors are almost always marked A1,A2 and S1, S2 S stands for stater and that is the stationary windings of the motor. Sepex or Separately excited motors are almost always marked A1, A2 and F1, F2 The F stands for field and that also is the stationary windings in the motor.
How many turns does a regen cart have?
Usually, the wire is rectanular in shape (cross-section). These coils have a much lower number of turns (usually 5 to 15 turns) per field coil. Note: A Regen cart will normally automatically slow down when you hit approximately 15 MPH going down a hill. This is for safety reasons (as not to over-spin the armature).