Easily Reset the Club Car Golf Cart OBC Resetting the OBC must be performed in this order: Key switch to off Set forward/reverse to neutral Put tow/run switch to tow Disconnect the negative battery terminal from the battery pack
Full Answer
How to fix a golf cart that won’t start?
Turn off the golf cart engine and allow it to cool for a couple of hours before you start working. This cooling down prevents damage to the cart and injury to yourself when you’re at work. Turn off the fuel-supply valve and remove the fuel line to prevent flooding of the fuel and other complications.
What causes a golf cart carburetor to overheat?
The engine starts overheating or backfiring that causes the carburetor to produce a lean mixture with insufficient fuel. The exhaust emanates black smoke because the engine utilizes excess fuel or runs rich. The golf cart experiences hard starting because of an improper air-fuel ratio. Troubleshooting Golf Cart Carburetor Problems
How to start a golf cart with a bad starter solenoid?
Find the ignition wire on your golf cart. This runs from your ignition switch to the starter solenoid. Check this over for corrosion on either end and make sure you’ve got a tight connection. If the connections use a spade lug, pull the connection loose, wipe off the terminal, and plug it back in again.
How to reset the club car golf cart OBC?
Easily Reset the Club Car Golf Cart OBC 1 Reconnecting the OBC into the system: 2 Key switch to off 3 Set forward/reverse switch to neutral 4 Put tow/run switch to tow 5 Reconnect the negative battery terminal from the battery pack
How do you reset a gas golf cart?
Easily Reset the Club Car Golf Cart OBCKey switch to off.Set forward/reverse to neutral.Put tow/run switch to tow.Disconnect the negative battery terminal from the battery pack.Put the tow/run switch to run.Put forward/reverse switch to reverse.Put key switch to on.More items...
How do you fix a gas golf cart that won't start?
2:164:39How To Fix Almost any Golf Cart that won't start - YouTubeYouTubeStart of suggested clipEnd of suggested clipThe ground wire now jiggle that. And with your key on step on the gas just keep jiggling. It up seeMoreThe ground wire now jiggle that. And with your key on step on the gas just keep jiggling. It up see that now it's running my hand's still on the ground. Now when i let go it's just clicking. Again.
How do I reset my golf cart?
Expose the motor (you'll probably need a screwdriver to remove the cover), and look for a red button. It is usually near the main power source, where most of the wires are connected. Once you've pressed the button to reset the motor, reassemble the cart, charge up the batteries, and give it a test run.
Where is the reset button on golf cart motor?
First, you'll want to reset your motor. It should have a small reset button (Usually it will be red) located near the main battery supply. Hit the reset button and then put the cover back on the motor. The next step would be to recharge your cart and try turning it on again. If it starts up then you're in luck!
Can a gas golf cart overheat?
A lot of slow moving around while playing a round of golf can overheat your cart engine. In this case, the motor as well as the controller are highly likely to get very hot.
What would cause a gas golf cart not to fire?
First, try this: turn the key switch on, hit the accelerator, and check for a clicking noise. If you don't hear clicking, it's time to take a look at your cart's batteries. Make sure the battery is fully charged and the terminals are cleaned and secure. Next, see how the water level in the battery is holding up.
Do all golf cart motors have a reset button?
Electric golf cart motors have a reset button on their chassis which is designed to put your motor back into its original factory state. While it doesn't repair damage that may have occurred to the motor over the years, obviously, it does help to overturn any changes to the operation which may have occurred.
What starts a gas golf cart?
In a gasoline-powered golf cart, the engine starts when you step on the gas pedal, and it shuts off when you take your foot off the gas. That feature helps save gas, cuts down on emissions and helps keep the course quiet, too.
Why do golf carts overheat?
One of the most common reasons for the overheating is the dirty fins. The obstruction in the fins leads to excessive heat. The best solution, in this case, would be to first try to clean them, if that does not work, get them replaced. Another common reason for overheating can be the dragging breaks.
Why did my golf cart stop working?
When there is a disruption in the flow of the electrical current, your cart will not operate. A common reason for current disruption is solenoid wear. Each time the solenoid activates as you press down on the gas pedal, the solenoid compounds down onto a thin metal contact plate.
How do I know if my golf cart solenoid is bad?
If your golf cart fails to turn on when you turn the key on, this is the most obvious sign of solenoid failure. The solenoid clicks a little with the ignition system in regular operation; in most cases, a failing solenoid will not snap.
Where are the fuses on a golf cart?
Locate the service panel of the golf cart. This is usually found behind the battery on the driver's side on the rear fender. Make a note of the current ratings supported for each fuse at the highest voltage.
What happens if you disconnect the controller from a golf cart?
If you disconnect the controller from the golf cart will cause a soft reset of the of the OBC when the battery power is removed. Once the battery powered is removed, the OBC internals will clear any faults. Once the controller is reinstalled, everything should work fine.
What is an OBC in golf carts?
Club Car uses the On Board Computer or OBC to monitor and control functions of their golf carts. If it functions properly it controls the charging and the drive system. If the OBC detects a problem with the charging system or the drive systems it shut down.
How long does it take for the OBC to reset?
Lock the throttle pedal down with a second set of hands or object. The reverse buzzer will sound and go off in approximately 30 seconds. Leave the cart like that for 5 min to cause the OBC to reset.
Is tidewater cart responsible for golf cart problems?
Tidewater Carts is not responsible for any malfuntions or problems that you incur directly or indirectly from folowing these procedures. Keep in mind that testing and troubleshooting should be done by trained and paid golf cart tech's.
How to tell if a golf cart starter is bad?
The following are four common symptoms that of a bad golf cart starter generator. Turning the Key Doesn’t Turn the Cart On. This can happen if either your cart’s battery or starter generator is out of order. Check if the lights on your cart are working. If yes, then it’s a bad starter generator.
Why is my golf cart starting with a bad starter generator?
You might even find yourself stranded once it fails to turn over the motor and start your golf cart. The starter generator generates current for the cart to operate on. It relies on the electromotive force supplied by the battery.
How does a starter generator work?
The starter generator generates current for the cart to operate on. It relies on the electromotive force supplied by the battery. It consists of a coil of wire, which when moved produces a current in the coil. The coil is connected to the main axle of the cart for the necessary movement of wires. The starter generator doesn’t just generate current ...
Why won't my golf cart turn over?
A golf cart starter generator will not turn over due to low battery voltage, misaligned rotation or mechanical damage to the pulley and brushes. Although you may not be able to identify the exact reason, failure to turn the motor over could be due to any of the three reasons mentioned here. Low Battery Voltage.
What happens if a starter pulley is jammed?
Jammed Pulley of Starter. The pulley that connects the starter generator to the main axle of the cart can get rusted and jammed. This can impede its free movement . The rust may reach the starter generator as well making it necessary for you to replace the whole setup immediately.
What does it mean when your cart lights are not working?
Check if the lights on your cart are working. If yes, then it’s a bad starter generator. If no, then something is wrong with your cart’s battery. If your cart is taking longer than expected to start cranking, then you probably have a bad starter generator. This might happen due to a battery issue as well.
Which way does a Starrer generator turn?
For an engine that requires the starrer generator to turn clockwise, the starter generator has to be aligned in such a way that it does turn clockwise. Any misalignment will prevent the engine from turning over. Mechanical Damages.
How to tell if a golf cart won't start?
The first and most obvious symptom is the golf cart won’t start. If it is a gas-powered cart, the engine doesn’t turn over, and if it is an electric cart, the cart doesn’t move. The engine on the gas-powered cart starts, but the starter doesn’t disengage after starting. When the contacts weld together, the power to the starter never stops ...
How to tell if a golf cart is bad?
Symptoms Of A Bad Solenoid 1 The first and most obvious symptom is the golf cart won’t start. If it is a gas-powered cart, the engine doesn’t turn over, and if it is an electric cart, the cart doesn’t move. 2 The engine on the gas-powered cart starts, but the starter doesn’t disengage after starting. When the contacts weld together, the power to the starter never stops and will result in destroying the starter, the wiring, or the flywheel. 3 The relay clicks and works sometimes, and sometimes it doesn’t. This can be a faulty wire connection, but can also mean the solenoid is beginning to fail. 4 The golf cart solenoid doesn’t click when the accelerator is pressed. This again can be faulty wiring or a failed solenoid. 5 The golf cart solenoid clicks, but nothing happens. This will sometimes be the result of burned contacts or contacts no longer coming in contact with each other as shown in the illustration at the bottom of this page. This can also be the result of not enough voltage amps reaching the solenoid control connection due to a low battery.
Why does my golf cart not click?
This can be a faulty wire connection, but can also mean the solenoid is beginning to fail. The golf cart solenoid doesn’t click when the accelerator is pressed. This again can be faulty wiring or a failed solenoid.
What causes a car to start when the spark plug is replaced?
If it sputters and tries to start, then the likely culprit is the fuel pump followed by the carburetor. The fuel pump on most gasoline powered carts usually has three hoses going to it.
How to check if a gas cart battery is charged?
First, you turn the key, press the pedal, and listen for a click. If nothing happens, it’s most likely an electrical issue. On gasoline carts, check the battery that turns the engine over to make sure it is charged. On Electric carts, the battery pack should be checked for a full charge.
What to do if a gas cart key switch fails?
There should be a reading or continuity between any combination. If this is a gasoline cart, set the switch to “ON” and take a reading between the terminals. There should be continuity. If the key switch fails any of these tests, it’s worn out and should be replaced.
How to tell if a battery is leaking?
It can begin with the batteries taking longer and longer to charge, and the charge they take, they don’t keep very long. Physical signs can include bulging sides, cracks or, in extreme cases, leaking battery acid. If the engine or motor turns over slowly, get out a multimeter and make this quick test.
How to adjust carburetor on golf cart?
In most cases, you’ll need to adjust the jet pilot screw, perform a valve clearance adjustment and then clean the carburetor.
How to cool down a golf cart?
Procedure. Turn off the golf cart engine and allow it to cool for a couple of hours before you start working. This cooling down prevents damage to the cart and injury to yourself when you’re at work. Turn off the fuel-supply valve and remove the fuel line to prevent flooding of the fuel and other complications.
How to replace carburetor float?
Remove the carburetor and turn it upside down. Remove the nut that is used to secure the bowl on. Check the float for a puncture as this prevents the activation of the fuel cut-off needle valve. Replace the float if there is a puncture. Check for dirt accumulation in the needle valve.
Why does an EFI carb require more maintenance than an EFI?
The carb requires more maintenance than an EFI because of the cleaning and rebuilding of the carburetor involved.
Why does my carburetor flood on my golf cart?
The reason why a carburetor floods on a golf cart is usually due to a faulty fuel pump. The pump must be repaired or replaced accordingly. Seek professional assistance if required. This is usually due to the proximity of the fuel line to an exhaust manifold, a radiator hose or a heat source.
How to remove cable from carburetor?
Remove the cable from the carburetor and cover its sheath opening using duct tape. To do this, make a small funnel with the tape and ensure that the wire sticks out from its middle. Loosen the nut that fixes the cable on to the mount housed on the motor just before its entry into the carburetor.
Which is more powerful, carb or EFI?
The carb model is more powerful as well as starts and goes faster when compared to the EFI. The EFI experiences delay to start moving when the pedal is pressed.