Golf-FAQ.com

what causes a yamaha golf cart to shut down then restart after switching to tow then run

by Mr. Bradley Toy DDS Published 3 years ago Updated 2 years ago

Full Answer

Why does my Yamaha golf cart keep starting and stopping?

Your Yamaha golf cart keeps running because of loose wires. If you suspect the issue is loose wires, check that the TCI wire connector which is at the front of the engine hasn’t been pulled out of the wire harness connector. Sticking accelerator.

Why won't my Yamaha G1 stop and shut off properly?

Your Yamaha G1 golf cart might not be able to stop and shut off properly because of loose wires, a sticky solenoid or a sticky accelerator stop switch.

Why won’t my G29 Yamaha golf cart start?

Check if the Tow/Run switch is working fine in your G29 Yamaha golf cart. Replace if faulty. The problem could also be with the controller. Some experts think that faulty batteries are the main reason for G29 Yamaha golf carts not moving when started. With the batteries, there can be multiple issues. Keeping them charged to the full is important.

Why does my golf cart keep shutting off?

Why Does My Golf Cart Keep Shutting Off? When a Golf Car is shutting off without warning, it's because of low battery voltage, dead batteries, or because the solenoid coil is overheating. Low battery voltage: Sometimes a dip in the minimum voltages of both batteries causes the Golf Cart to turn off randomly.

Where is the reset button on a Yamaha golf cart?

It should have a small reset button (Usually it will be red) located near the main battery supply. Hit the reset button and then put the cover back on the motor. The next step would be to recharge your cart and try turning it on again. If it starts up then you're in luck!

Is there a reset button on Yamaha electric golf cart?

The reset button acts as a mini circuit breaker for the motor, so it will correct any minor errors. Expose the motor (you'll probably need a screwdriver to remove the cover), and look for a red button. It is usually near the main power source, where most of the wires are connected.

What does the tow switch do on a Yamaha golf cart?

Any time the cart is going to be stored for significant periods of time without being attended or charged, the vehicle should first be fully charged, and then the switch should be turned to “TOW”. This will ensure that your charge lasts as long as possible during your absence without the controller draining them.

How do I know if my golf cart solenoid is bad?

If your golf cart fails to turn on when you turn the key on, this is the most obvious sign of solenoid failure. The solenoid clicks a little with the ignition system in regular operation; in most cases, a failing solenoid will not snap.

How do I test my Yamaha drive controller?

How do I test my Yamaha g16 speed controller?Keep the key on.Press down the accelerator.If you hear a clicking noise, the solenoid is working. Otherwise, there is a problem.Next, examine the controller for defects. ... If the wires are damaged, replace them to get back the speed.

How do you test a Yamaha electric golf cart solenoid?

Turn on the engine of the cart and press the pedal downwards. If you hear a clicking sound, then it means that the low side voltage is working. But, if there is no such sound, it means that either there is no low side voltage or there is a problem with the solenoid. Use a voltmeter and engage the solenoid.

How do I know if my electric golf cart motor is bad?

You have enough going on in your life without your golf car refusing to start when you turn the key in the ignition. If your golf car won't start, is slower than it used to be, or is experiencing other technical problems, you could have a bad motor on your hands.

Where are the fuses on a Yamaha electric golf cart?

In a G2 electric cart, the fuses are present on the rear inner fender. This is on the front of the driver's side of the cart. They're round in shape and made of glass. The blue fuse block in a Yamaha G29 golf cart is below the cup holder and secured on the shelf.

Should you charge your golf cart in tow mode?

Your golf cart needs to be charged in Run. Tow should only be used in long term storage or if you are going to remove the battery.

What happens when you tow a golf cart in run mode?

First of all, leaving your cart in run mode during storage will cause your battery to slowly drain, as your cart's computer and its regenerative braking system will be active, causing a slow drain that will leave your battery dead after a long-term storage situation.

How do you tow a Yamaha golf cart?

1:042:017F Towing - YouTubeYouTubeStart of suggested clipEnd of suggested clipUnder the seat into the toe position. This will allow the rear wheels to freely roll. Once allMoreUnder the seat into the toe position. This will allow the rear wheels to freely roll. Once all vehicles are connected disengage the parking brake of each vehicle that is being towed.

Why won't my Yamaha golf cart shut off?

The reason why a Yamaha golf cart does not shut off can be because of loose wires or a faulty voltage regulator. Check to see if the engine wire connections are faulty. Also check the connection of the black and blue wires at the front of your cart’s engine. If you find that the wires are just disconnected, you only need to reconnect them ...

Why does my Yamaha golf cart keep running?

Your Yamaha golf cart probably keeps running because of loose wires, a sticking accelerator stop switch or a sticking solenoid. It could also be a problem with the engine stop relay or a problem with the voltage regulator. Your Yamaha golf cart keeps running because of loose wires. If you suspect the issue is loose wires, ...

What to do if your solenoid is not clicking?

If you didn’t get a clicking sound, take your voltmeter and set it to DC volts on the 200 scale. Place a probe on each small terminal. With the cart in the forward position and the key on, step on your cart’s accelerator.

Why is my gold cart sticking?

There’s probably a sticking solenoid problem with your gold cart if there’s a noticeable lag between when you push the pedal and when your cart starts to crank. You can check and test for this problem using a voltmeter or test light. If you have a faulty solenoid, you need to replace it.

How to check if a Yamaha G9 has a sticky accelerator stop switch?

How to check if your Yamaha G9 golf cart has a sticky accelerator stop switch. Remove the floor mats from your Yamaha G9 golf cart. Take out the exposed floor plate and then unplug the stop switch. Next, open the wiring harness clip.

How to check if a G9 golf cart has a sticky solenoid?

How to check if your Yamaha G9 golf cart has a sticky solenoid. Unplug all the cables from the two large terminals. Wrap the cable ends in electrical tape and make sure to keep them separated. Put the cart direction switch in the neutral position with the key off.

How to check if a Yamaha G1 has a stop switch?

To check if your Yamaha G1 golf cart has a sticky accelerator stop switch: Take out the floor mats from your cart. Take off the exposed floor plate and then unplug the stop switch. Look for the wiring harness clip which you then need to open up.

Why does my golf cart keep powering off?

If the cart starts powering off after a new installation, then you will know that the issue is caused due to errors with the installation.

Why does my golf cart cut out?

Another reason why golf carts can cut out is due to problems with the battery voltage or water levels.

How to check battery water level in golf cart?

How to Check Battery Water Levels in a Golf Cart. Check if the voltages in both the batteries are at the designated levels. Also, if the water in the batteries has dried up, it could cause this issue. Check for the electrolyte and water levels in the batteries. Make sure that you are not overcharging or undercharging your batteries as these could ...

Why does my cart have a loose solenoid?

If the connections from the solenoid have become loose or if there is some other loose contact, the cart might behave in this manner. It can also be caused by a faulty motor or a faulty key switch.

What happens if you charge your golf cart?

You would have charged up your cart fully but after driving it around for an hour or two, the power would have got drained off completely. If this is a frequent occurrence with your cart, then you will need to take a look at the batteries.

Can you fix a golf cart on your own?

Under NO circumstances should you attempt to fix your golf cart on your own. Doing so is dangerous and could result in serious bodily harm. The information on this website has not been verified for accuracy and should only be used for general information purposes only. Use this information at your own risk.

Is my speed sensor broken?

There is a magnet associated with the speed sensor. Sometimes your speed magnet may be broken but will still be clinging on; only being held by the screw. Unfortunately, you may not realize it is broken until you take the mechanism apart. The speed sensor may not even show any issues. Check if the magnet is broken and if it is, ...

Why is my Yamaha golf cart not moving?

The main cause of a Yamaha golf cart clicking but not moving, is a faulty controller or solenoid. The battery has to be checked first to see if it’s delivering the right voltage while in the idle state as well as when the pedal is pressed. There can be other reasons for the Yamaha golf cart not moving though you hear the click.

What to do if your G9 golf cart is not clicking?

If you find your G9 Yamaha golf cart not starting nor clicking, check the key components for damage. If you find the parts to in good condition, check the brushes in the starter/generator.

Why is my solenoid not clicking?

The reason why the solenoid is not clicking could be that it is faulty or has no grounding. Experts recommend checking all wiring and cable connections to rule out this possibility. Batteries on your G16 Yamaha golf carts should raise sufficient power to reach the solenoid and the starter/generator.

What is a faulty controller?

The controller is one major component that may have to be replaced. A faulty controller can stall the cart and the click you hear must be from the solenoid. Test the solenoid to see if it is functioning properly. You will require a multimeter, preferably a digital one, or a DVM for this.

How to check solenoid on G9 Yamaha?

The solenoid can be checked using an old screwdriver to jump the terminals. Your G9 Yamaha golf cart’s key must be in the start position. If the starter turns when you do this, your solenoid needs to be replaced. You must be careful while doing this crude test; there could be sparks when the two terminals touch.

Why do you need a wiring diagram?

A clear wiring diagram will help in ensuring that the cables are properly reconnected if you remove them for testing. In the solenoid, for example, the contacts inside can get jammed over a period. These have to be checked, cleaned, and re-fixed. If it still doesn’t work it has to be replaced.

Why does my golf cart keep turning but not starting?

Solenoid problems: A solenoid can wear out after using your golf cart regularly. A faulty solenoid can cause your golf cart to turnover but not start. Your golf cart solenoid is a coil of wire cylindrical in shape, but in reality it functions as magnet carrying electricity.

What happens when a spark plug is taken out on a Yamaha golf cart?

You can check the oil for a possible contamination of gas.

Why won't my Club Car Precedent Golf Cart start?

Club Car Precedent golf cart turns over but won’t start. A faulty spark plug, bad battery or low compression levels are the main reasons why a Club Car Precedent golf cart will turn over but not start. Lack of spark in the coil: in this case, you have to replace the coil if it doesn’t spark. Spark plug: Also look whether ...

Why is my golf cart starting with a key switch?

Key switch problems: Keyswitch issues is a common cause of golf cart starting problems as the key switch will wear out over time. You have to check the keyswitch area for any loose or broken piece of wiring. Be very careful while doing this since you might get a nasty shock.

What to do if golf cart doesn't start?

If you find any moisture, you have to replace the plug. If the golf cart doesn’t start, you will want to clean the carburetor with some cleaning fluid. You can also take a look at the fuel bowl to check if it’s empty. If not, open and drain it.

Why won't my golf cart start?

Faulty brakes: Very often, faulty brakes are the reason why a golf cart won’t start. You should be able to adjust the breaks at home. However for more complicated repairs, it is better to pay a visit to your nearest professional mechanic.

Can a Yamaha G2 golf cart start?

Yamaha G2 golf cart turning over but not starting. A good spark, air and gas is usually sufficient to get a Yamaha G2 golf cart started. But if it’s not, then check out for a crack in the spacer of the carburetor. Next check if the ignition coils are connected to the two wires that are there. Then check for spark.

A B C D E F G H I J K L M N O P Q R S T U V W X Y Z 1 2 3 4 5 6 7 8 9