The reason your EZGO golf cart won’t start and has no spark is that there is a fault with the ignitor/key switch. The most common reason for a failed ignitor is a bad voltage regulator. Therefore, when you replace or fix the ignitor on your golf cart, make sure you also check the voltage regulator and see if it needs to be replaced.
Full Answer
Why does my EZGO golf cart have no spark?
EZGO Golf Cart Won’t Start No Spark The reason your EZGO golf cart won’t start and has no spark is that there is a fault with the ignitor/key switch. The most common reason for a failed ignitor is a bad voltage regulator.
Why is my golf cart spark plug not firing?
There is a faulty RPM limiter in the golf cart. The igniter has failed because of a bad voltage regulator. Your can fix a golf cart spark plug not firing by replacing the igniter coils and cleaning the carburetor.
What is the spark plug gap on a EZGO TXT?
EZGO TXT /RXV with NGK BP4HS spark plugs have a spark plug gap between 0.025 and 0.030 inches. EZGO golf carts with NGK BPR4ES spark plugs typically have a spark plug gap between 0.028 and 0.030 inches. EZGO golf carts with NGKBP5HS spark plugs have a spark plug gap of about 0.025 inches. 94 Club Car Spark Plug Gap
Why won’t my EZGO RXV run?
A broken connector can also cause your 2005 EZGO not to run. In which case you’ll need to have it replaced by a certified technician. The reason your 2008 EZGO RXV won’t move can be due to a faulty charger port, a disconnected buzzer or loose battery connections.
How do you test an ezgo coil?
Attach the red lead to the positive terminal. Select the "Ohm" setting on your volt/ohm meter and read the display. The golf cart coil should register as more than 3.7 ohms, but less than 5.2 ohms. If the coil registers outside this range, replace the coil with a new unit.
How do you check the igniter on a EZ Go golf cart?
Take the voltmeter's black and red probe and place it on the –ve and +ve terminal of the coil. Take the readings. It should be between 3.7-5.2 ohms. If outside the range, the coil should be replaced.
Why does my ezgo gas golf cart lose power?
The main reason why a EZGO golf cart can lose power is because the battery is not charging due to loose cables or the corrosion of the connecting terminals. If they become loose or some of the electrical circuits' connecting wires snap, the battery loses power.
How do you check for spark on a golf cart?
Ground the threaded portion of the spark plug that is connected to the engine. Crank the engine and check for spark. If there is no spark, unplug the white plug with blue and black wires that are at the bottom of the engine under the valve cover. Check for spark once again.
What does ezgo ignitor do?
EZGO Ignition Switch, Ignitor, Coil Parts Ignition coils transfer voltage from your battery into spark for your engine to fire. We carry ignition coils for EZGO TXT, RXV, Marathon, and ST350 Workhorse golf cart models.
What does the igniter do on a golf cart?
The ignitor boosts the signal and sends it to the ignition coil. The coil then creates the large spark that goes to the spark plug and fires the gas mixture in the cylinder. Ignitors can be the cause of a weak spark or they may fail completely and then the coil cannot create any spark at all.
What would cause a golf cart to lose power?
If you're lucky, the problem could be as simple as a loose wire or a broken coil. In some cases, corrosion can also be a factor. If you suspect a faulty solenoid, your best bet is to take your cart to a repair shop. A mechanic can diagnose the problem and replace the solenoid if necessary.
Why does my golf cart keep losing power?
For example, you must make sure that your batteries are fully connected to ensure that they are able to send power. If their connections are loose, the power flow may not be properly connected and may cause your cart to sputter and drive poorly as it rides, losing power and stopping sporadically during each trip.
How do you check the voltage regulator on a gas club cart?
Testing the voltage regulator on a gas Club CarConnect the voltmeter to the battery and get the golf cart running. ... Check if the voltage rating is between 14 volts and 16 volts. ... Use a jumper and connect it from the ground of the cart to the stud of the starter generator.
Where is the reset button on a ezgo golf cart motor?
Locate the motor Remove the panel so the electric motor is visible. Electric motors usually include reset buttons that can perform similar to circuit breakers. Look in the area where several electrical wires enter the motor and locate a small red button. This is the reset button.
What would cause a gas golf cart not to fire?
First, try this: turn the key switch on, hit the accelerator, and check for a clicking noise. If you don't hear clicking, it's time to take a look at your cart's batteries. Make sure the battery is fully charged and the terminals are cleaned and secure. Next, see how the water level in the battery is holding up.
How do you test a ignition coil?
1:525:53How to Test Ignition Coils - YouTubeYouTubeStart of suggested clipEnd of suggested clipAnd simple test that can be done you use a circuit test which is also called a test lighting. AndMoreAnd simple test that can be done you use a circuit test which is also called a test lighting. And what you do you connect the negative up to the negative cable still disconnected.
Why Won’t My EZGO Golf Cart Start?
EZGO golf carts may not start due to a transmission problem, corroded battery terminals or a faulty wiring coming from the ignition.
Why won't my EZGO RXV move?
Brake Problems: Many times the reason your RXV won’t move is because of brake problems. The RXV is designed to be disabled when there is a problem with the break. Many times, the wiring that connects the brakes to the controller gets loose or is damaged. This can disable your EZGO RXV.
How to unclog a golf cart muffler?
To unclog it, simply make a fire and remove your muffler and put it there.
What to do if replacing ignition wire doesn't work?
To check the continuity of the ignition wire you’ll need to use an ohmmeter or a continuity tester. To do this, set the switch to off and set your ohmmeter to X1.
Why does my golf cart make a clicking noise?
When you press your golf cart pedal you should hear a clicking noise, if you don’t hear a clicking noise there might be a problem with the solenoid. To make sure your solenoid is functioning properly check it with a voltmeter. If you hear a click then you need to check its power with the voltmeter.
Why is my golf cart ignitor failing?
The most common reason for a failed ignitor is a bad voltage regulator. Therefore, when you replace or fix the ignitor on your golf cart, make sure you also check the voltage regulator and see if it needs to be replaced. There have also been cases where the battery has switch polarity for some reason.
What do you need to troubleshoot a golf cart?
While both types of golf cart are different, there are two things you need to troubleshoot whether you have a gasoline or an electric golf cart; the fuse and ignition.