Could be a wheel bearing, motor bearing, rear end bearing, brakes, etc. You need to jack the golf cart up and spin each tire and if you can't hear the click run the cart at low speed with the back tires ff the ground. Welcome to the forum.
Full Answer
Do your golf carts make noise?
Let’s Start with Noises in Your Golf Cart. Here is one such instance I will describe that I experienced a few years ago. This customer had a ParCar, and said it made a noise all the time. I took the golf cart for a ride and no noise was detected.
Why is my golf cart bouncy?
A bad axle could easily cause your tire to shake, therefore making the golf cart bounce. If the tires are exactly round, it could cause the bounce issues. It would be a good idea to get your tires checked and then see if the problem persists. Are your front tires bouncy?
Why does my golf cart beep when I stop?
The first beep sound will indicate the performance factor. The second set of beep sounds will indicate the fault code. Take note of the beep sounds and look up the manual to see what the problem is, signified by the beeps. The golf cart speed sensor could also be responsible for sudden stops, followed by beeps.
Why is my golf cart surging at low speeds?
Why Golf Cart is Surging at Low Speeds A golf cart may be surging due to faulty batteries, faulty battery cables, or because the speed sensor connection has become loose. There are one or more bad batteries or battery cables. Check the battery pack voltage when the cart is stationary.
Why is my golf cart jolting?
A Club Car golf cart jerking from the front end of the golf cart occurs due to poor quality of tires. If the tires are worn out or loose, the golf car can start jerking. The uneven height of your front tires can also cause jerking.
Why does my electric golf cart stutter?
If your cart seems to run fine for a few feet, and then it stutters, it is most likely the batteries. If it is not the battery, then check if it is the speed controller or the resistor. If it is the controller, then you will need a replacement. Otherwise, upgrading the resistor can also solve the problem.
How do you know if you have a bad solenoid on a golf cart?
If your golf cart fails to turn on when you turn the key on, this is the most obvious sign of solenoid failure. The solenoid clicks a little with the ignition system in regular operation; in most cases, a failing solenoid will not snap.
How do I know if my golf cart motor is bad?
You have enough going on in your life without your golf car refusing to start when you turn the key in the ignition. If your golf car won't start, is slower than it used to be, or is experiencing other technical problems, you could have a bad motor on your hands.
What happens when golf cart solenoid goes bad?
If the solenoid is broken and not working correctly, you may notice your golf cart won't start, picking up speed, or even working at all (issues with acceleration could also be caused by a bad speed controller).
Should you charge a golf cart after every use?
Yes. New golf cart batteries should be charged every time they are used as this will extend their lifespan, help them retain their capacity for longer, and prevent discharge. It is vitally important to charge new golf cart batteries, even after their first use.
How do I know if my club car controller is bad?
X Common Symptoms of Controller FailureTop Speeds Not Appropriate for Your Cart. Golf carts are designed to reach pretty specific speeds and to not go over them or beneath them. ... Sudden and Unexpected Slowing. ... Shuttering or Shaky Driving. ... Stalling Out and Refusing to Start. ... Surges in Speed When Driving.
Where is the reset button on a golf cart motor?
First, you'll want to reset your motor. It should have a small reset button (Usually it will be red) located near the main battery supply. Hit the reset button and then put the cover back on the motor. The next step would be to recharge your cart and try turning it on again. If it starts up then you're in luck!
How do I know if my EZ GO controller is bad?
Press the accelerator and watch to see if the voltage increases. It should increase from a reading of 0 to the full voltage of the battery. If the motor is not turning, the problem may be in the directional switch or motor. If there is no voltage, the controller is bad and must be replaced.
How do you diagnose a golf cart problem?
There are a few simple problems that you can fix yourself that will not necessitate professional maintenance.Test the wall socket where you charge your cart. ... Expose your golf cart batteries. ... Test the batteries for voltage. ... Replace dead batteries. ... Expose the motor for inspection. ... Reset the motor. ... Test the cart.
How long do golf cart motors last?
Golf Cart Motor Just like solenoids (mentioned above), your golf cart motor works HARD. When properly taken care of, the typical gas or electric golf cart motor can last many, many years (20 to 30+).
What does the MCOR do on a golf cart?
Club Cars use an MCOR throttle device. This translates your foot movement at the pedal into electric impulse that the motor controller reads. MCOR stands for "Motor Controller Output Regulator".
Why does my golf cart make a grinding noise?
If your golf cart is making a weird grinding noise while it is running, the issue could be due to bearings. Normally, we find that the cart makes a kind of groaning and grinding noise that can be very irritating. This is usually due to a problem with one of the physical or mechanical parts.
Where is the spacer on a car?
There is a spacer attached to the vehicle under the rear tire on the driver’s side. This can be found between the transaxle and the tire. If the spacer is loose, it could cause some grinding noise from the rear end. Check whether the axle is spinnable by hand and if so, it is indeed loose.
Is the Ping G25 adjustable?
Is the Ping G25 driver adjustable? The Ping G25 driver is adjustable. It’s possible to do four adjustments using the hosel adapter of the driver apart from the stated loft setting and...
Can a golf cart make a noise?
Golf carts can sometimes make some very weird noises. While these noises may not be particularly dangerous, they can be irritating and possible a sign of damage. If you want your golf cart to last you for many years to come, you’ll want to investigate and fix such noises. I have created this handy guide to help you troubleshoot any golf cart noises ...
Why does my golf cart jerk?
The most common reason why are golf cart jerks could be that the water has entered some of the components . There are a sensor and a micro-switch under the driver’s side floor mat. If water enters these components, especially the switch, it could cause the cart to jerk while starting.
Why is my cart bouncing?
If the cart is still bouncing, you will know that the problem is not with the tire. Instead, the issue could be due to a bent wheel. In this case, you will just have to get the wheel replaced. If both these cases do not seem to be the cause, then it could be due to the axle or the wheel bearing.
What happens if your golf cart clutch is bad?
If the clutch is bad, you could experience some jerking movement during the start or stopping stage of the golf cart. Consider getting the clutch checked and possibly replaced if any issues are there. This should help resolve the problem of the cart jerking when accelerating or taking off.
Why does my clutch jerk?
Well, the issue could be related to the clutch. The primary clutch weights could be broken, which might be causing the jerks. It would be a good idea to get your clutch checked to help resolve the problem. Another cause of this issue could be the accumulation of dirt or dust particles in the clutch.
Can you use an ohmmeter to calibrate a cart?
In such cases, you will have to use an ohmmeter to calibrate the readings and make the necessary adjustments. Any technical manual of your cart model will have details about the various parts. You can either use them to recalibrate it or take your cart to a service center. They can easily fix it for you.
Why is my golf cart surging?
A golf cart may be surging due to faulty batteries, faulty battery cables, or because the speed sensor connection has become loose. There are one or more bad batteries or battery cables. Check the battery pack voltage when the cart is stationary.
Why is my carburetor float blocked?
The float bowl is accumulated with water or dirt. Alternatively, the main jet may be blocked because of old bad gas varnish. Cleaning the float bowl and main jet may be a good idea. The carburetor bowl is misaligned or the gasket is worn out. Fix the bowl back in position and replace the gasket.
Why is my carburetor backfiring?
There is backfiring because of incomplete closure of throttle shaft, improper accelerator cables adjustment, damaged carburetor gaskets or loose connection of the nuts that connect the airbox to the carburetor.
What happens if you don't slack your cart?
If there is no slack, the cart will run at full throttle when you press the pedal lightly. The linkage before the front timing cover must also not be too tight. The connections between the motor and controller are either incorrect or corroded. In case of incorrect connections, redoing them correctly will suffice.
How to troubleshoot a Yamaha G16?
You can use the steps given below to troubleshoot a Yamaha G16 that surges. The carburetor is dirty due to dust accumulation. Remove it from its place and clean it thoroughly ensuring that the float bowl and the small air compressor are clean. Disconnect the fuel line and drain off the old fuel.
What happens if the butterfly valve is loose?
If it’s a loose connection, tightening it will solve the problem. However, you may have to replace the cable if it’s faulty or damaged.
Why are my pot pads burning out?
The contacts on the pot pads have burnt out. The water level in the batteries is insufficient. The batteries or their cables are old and due for a replacement. The connector of the speed sensor is not snapped tightly in position. The cables connected to the motor and the eyelets have become loose.
Why is my golf cart not clicking?
On an electric golf cart, the most common symptom is the solenoid is not delivering electricity to the controller when the vehicle’s ignition is turned on. In normal operating conditions, the solenoid clicks on and off with the ignition switch. A failing solenoid will generally not click. Two things could be going on here.
How to check if a golf cart solenoid is silent?
On an electric golf cart, if the solenoid is silent – no clicking – use the setting voltmeter to DC volts using the 200 range. First, turn on the ignition while looking for a reading on the smaller terminals. If nothing is appearing, then press on the accelerator. If the needle doesn’t move, then the problem is not with the solenoid.
What does it mean when a golf cart solenoid goes bad?
Technically, in fact, a solenoid is a shape – a shape in which the length of something coiled is longer than the diameter of the coils. In engine starters, this refers to the smaller motor ...
Why do golf carts have solenoid?
The solenoid is simply there to allow electricity to flow freely to the controller and motor which will result in a running golf cart. RELATED: 4 Signs you need to Replace your Golf Cart Batteries.
Why won't my solenoid click?
The solenoid might not be getting enough electricity to do its work – which could be caused by loose connections, a weak battery or the coil wearing out.
What does a solenoid do when you turn the ignition?
Step by step, it looks like this: When you turn the ignition key, a small amount of electricity goes to the solenoid. The solenoid uses that small amount of juice to close two heavy-duty contacts that allows a large jolt of electricity to pass through the starter. The solenoid also sends a pinion gear forward, which is the device ...
Why does my club car shudder in reverse?
Answer: The “shuddering in forward but seems to run fine in reverse” is a very common issue with the 36-volt resistor coil for Club Cars. The reason for this is this system uses all the batteries for forward and only four for reverse. First, you will need to check for any loose or bad battery cable connections.
How to check if a battery is bad?
First, you will need to check for any loose or bad battery cable connections. Second, conduct a load test on the batteries one at a time . This will determine if a bad battery is an issue. To perform this test: Jack up the rear of the cart and turn the key switch on.
Why doesn't my golf cart solenoid click?
This can be a faulty wire connection, but can also mean the solenoid is beginning to fail. The golf cart solenoid doesn’t click when the accelerator is pressed. This again can be faulty wiring or a failed solenoid.
How to tell if solenoid is bad on golf cart?
The common symptom of a bad solenoid is no clicks when the cart’s ignition is on and you press the accelerator.
How to test golf cart solenoid?
A diode allows current to run in one direction, but not in the other. Testing the diode is a simple procedure. Remove the diode from the circuit and check the leads with a continuity tester.
How to check if a battery is low?
First, follow these steps: Step 1 – Check the battery voltage from the positive connection to the battery negative. A solenoid uses 12-18volts and low voltage will not activate the solenoid. Step 2 – If the voltage is low, check the cable ends for corrosion. Clean and charge the battery.
How to tell if a golf cart won't start?
The first and most obvious symptom is the golf cart won’t start. If it is a gas-powered cart, the engine doesn’t turn over, and if it is an electric cart, the cart doesn’t move. Now, on to the next symptoms…. The engine on the gas-powered cart starts, but the starter doesn’t disengage after starting.
Where are the solenoids on a golf cart?
In all golf carts, new and old, the solenoids can be found under the seat or in the engine well and are easily identifiable by the wires that lead to them. Banks of heavy duty solenoids, as in the previous illustration, are mounted on the side or back panel near the electric motor.
What to do if your solenoid is not zero?
If the reading is not zero, then the solenoid is stuck and needs to be replaced. If the ohmmeter does read zero, set the cart to forward travel and turn the key switch on. Press the accelerator pedal (or have a friend do it) and you should hear a click. If you don’t hear a click, measure the resistance anyway.
Why does my golf cart keep powering off?
If the cart starts powering off after a new installation, then you will know that the issue is caused due to errors with the installation.
Why does my golf cart cut out?
Another reason why golf carts can cut out is due to problems with the battery voltage or water levels.
How to check battery water level in golf cart?
How to Check Battery Water Levels in a Golf Cart. Check if the voltages in both the batteries are at the designated levels. Also, if the water in the batteries has dried up, it could cause this issue. Check for the electrolyte and water levels in the batteries. Make sure that you are not overcharging or undercharging your batteries as these could ...
Why does my cart have a loose solenoid?
If the connections from the solenoid have become loose or if there is some other loose contact, the cart might behave in this manner. It can also be caused by a faulty motor or a faulty key switch.
What happens if you charge your golf cart?
You would have charged up your cart fully but after driving it around for an hour or two, the power would have got drained off completely. If this is a frequent occurrence with your cart, then you will need to take a look at the batteries.
Can you fix a golf cart on your own?
Under NO circumstances should you attempt to fix your golf cart on your own. Doing so is dangerous and could result in serious bodily harm. The information on this website has not been verified for accuracy and should only be used for general information purposes only. Use this information at your own risk.
Is my speed sensor broken?
There is a magnet associated with the speed sensor. Sometimes your speed magnet may be broken but will still be clinging on; only being held by the screw. Unfortunately, you may not realize it is broken until you take the mechanism apart. The speed sensor may not even show any issues. Check if the magnet is broken and if it is, ...
