The most common among golf cars are a mechanical, adjustable, spring-loaded governor, which is usually inline with the accelerator cable, a driven clutch activated cable which pulls back the carburetor throttle lever (more common on 2 cycles), and an rpm or rev limiter.
How do you loosen the governor on a golf cart?
The governor is often housed on top of the engine. Locate the gas pedal that is fitted to the governor and remove the connection. Re-route the gas pedal to the carburetor. Remove the bolt present on the shaft of the gas pedal. Slide the shaft upwards so that the gas pedal has more play. Tighten the bolt and start the golf cart.
Can you drive a golf cart without a governor spring?
Step 3. Locate the golf cart’s governor; you can find the governor by tracing the thickest cable running from the gas pedal. This cable runs through the governor on its way to the carburetor. Use a screwdriver—or in some cases a wrench—to loosen the tension on the governor’s springs. You have now adjusted the governor for faster speed ...
How do you adjust the governor on a club car G16?
Spring Adjustment: The first common golf cart governor type is mechanical and is common on many makes and models. You’ll see some type of spring loaded mechanism in line with the golf cart’s accelerator system. Whether it’s located at the carburetor or sticking out as a pivot point from the differential, the principle is the same.
What are the different types of Governor on a Yamaha golf cart?
Mar 31, 2010 · The governor will look like a spring loaded device coordinated with the vehicle's accelerator. Use the screwdriver to turn the bolts that hold the governor in place. Turning them clockwise will increase the tension, and turning them counter-clockwise will decrease the tension.
How do I know if my golf cart has a governor?
0:101:28Golf Tips & Etiquette : Where Is a Golf Cart Governor Located? - YouTubeYouTubeStart of suggested clipEnd of suggested clipWell a golf carts governor located is actually down in the motor compartment some of them there'sMoreWell a golf carts governor located is actually down in the motor compartment some of them there's electric ones nowadays.
Where is the governor on an EZ Go golf cart?
The engine is in the front of golf carts, underneath this panel. Take off the plastic cover and set it aside with the seats. Follow the thickest cable coming from the gas pedal until your find a small spring wrapped around a metal rod. This is the governor.
How do you adjust the governor on a golf cart?
If you find this rod, then your governor can be easily adjusted by accessing the cart's inner workings. Simply adjust the cable coming from this metal protrusion, turning the nut counterclockwise to make the cable longer, effectively adjusting the cart's governance to increase the overall speed.
How do you override a golf cart governor?
0:000:46How to remove governor on a Club Car golf cart - YouTubeYouTubeStart of suggested clipEnd of suggested clipIt looks up look inside. There's 12 cable down right here this lever you want to lift up and BendMoreIt looks up look inside. There's 12 cable down right here this lever you want to lift up and Bend and that pulls on the cable a little more.
Does an electric golf cart have a governor?
Considering electric golf carts don't have governors like gas powered carts, the old-school method of simply removing the governor is not an option.
How can I speed up my EZ Go golf cart?
One way to increase the speed of EZ Go golf carts is to incorporate an octane booster when you fill the tank. The cart will have more pick-up, and it could gain as much as 5 mph. A different approach is to take out the throttle linkage governor on the carburetor.Jun 16, 2015
Can you make a golf cart go faster?
Another word of advice: shift your gear ratio from 12.5:1 to 6:1 to make it go 12 miles per hour faster than it did before! But there's a catch: you have to give up some torque in order to increase the speed of your golf cart.Aug 29, 2019
Why is my gas golf cart slow?
Low Battery Usually, the most common reason golf carts slow down is when they don't get enough power output from the battery. If the battery pack charge is very low and your cart is out of power, your cart will run slow.Jul 14, 2021
How does a carburetor governor work?
The speed-sensing device on a pneumatic governor is a movable air vane, made of metal or plastic. This small engine part registers the change in air pressure around the spinning flywheel. The pneumatic governor also relies on one or two springs to pull the throttle toward the open position.
How can I make my electric golf cart go faster without upgrading?
How to Make an Electric Golf Cart Faster Without UpgradesWash Your Cart Properly. ... Inspect the Batteries. ... Refill the Battery Water. ... Check the Gas Pedal and Linkage. ... Measure the Tire Pressure. ... Charge Up Your Battery Unit. ... Lighten Up Your Cart's Weight.
What does a speed controller do on a golf cart?
A controller works like a dimmer switch for a light. It varies “power” by modulating voltage. By using a controller, it allows the user to vary the current to the motor thus adjusting the speed of the vehicle. A larger controller is capable of providing more current thus allowing the motor to produce more torque.
How do I change the speed on my club car?
1:1811:46Club Car precedent speed code 5 - YouTubeYouTubeStart of suggested clipEnd of suggested clipAnd it should take about 45 seconds first decide which speed you want to use.MoreAnd it should take about 45 seconds first decide which speed you want to use.
How to get to the engine on a golf cart?
Open up your golf cart’s access panel to get to the engine. In many cases, the panel pops open like a car hood, but in some instances you’ll need to unscrew the panel first.
Who is Richard Kalinowski?
Richard Kalinowski began writing professionally in 2006. He also works as a website programmer and graphic designer for several clients . Kalinowski holds a Master of Fine Arts from Goddard College and a Bachelor of Science in education from the University of Wisconsin-Whitewater.
Can a golf cart be a nuisance?
In practice, golf carts can be more of a nuisance than a help, as many standard carts creep along at unbearably slow speeds. Luckily, you don’t have to stick with these standard speeds. Golf cart speed is often controlled by a device called a governor, and you can adjust the governor on a golf cart relatively easily to make the cart faster.
How fast can a golf cart go?
Adjusting the governor can make your golf cart go 5–10 mph (8 .0–16.1 km/h) faster. If you do this to an E-Z-GO golf cart, you might be able to go from 15 mph (24 km/h) to 22 mph (35 km/h). It will only take about 5 minutes to do it. Steps.
How to make a golf cart go faster?
Loosen the small nut and tighten the larger nut. The more you tighten the larger nut, the faster your cart will go. Start slowly, only tightening the nut a quarter turn to start. You can over-stress the engine if you try to run it too quickly, and it will skip and potentially burn out if you are too eager.
How to get a cart to move faster?
1. Remove the seat and plastic covering over the engine. Sometimes you'll need to remove screws while some models have seats that pop right out. Expose the engine so that you can get to work adjusting the motor. If you don't have a central governor spring, you can still get your cart to move a little faster.
How to change the speed of a car?
Locate your clutch pedal and line. The clutch is the pedal (sometimes a handle near your knee) that you use to put the car into reverse or change speeds. You can adjust the clutch to send more gas to your engine, moving you faster. ...
Where is the governor on a car?
The governor generally sits on top of the engine . This is the easiest way to find the carburetor. Once you've followed the cable up to the governor, disconnect it there as well. You can save this cable for later use or throw it away.
How fast can a golf cart go?
Golf carts are governed to go anywhere from 12 to 14 miles per hour. But if you've got a few minutes, some simple mechanical know-how and a wrench, you can double the speed of your cart and zip through your round.
Where is Patrick Cameron?
He works out of his home in Denver, Colo. He received his Bachelor of Arts in mass communication from the University of Minnesota.
