Golf-FAQ.com

what is an obc on a golf cart

by Dr. Laila Metz Published 3 years ago Updated 2 years ago
image

What is the On Board Computer (OBC)? Since 1995, 48 volt Club Cars come with an OBC. The OBC is a small device that is wired into the golf cart that's purpose is to regulate the batteries charge.

Do all golf carts have OBC’s?

The OBC is a small device that is wired into the golf cart that’s purpose is to regulate the batteries charge. As you use and drive your golf cart, the OBC records the amount of energy consumed and then directs the charger to replace exactly the amount of energy needed to fully replenish the batteries.

What does the OBC do on a club car?

Jun 29, 2017 · All Club Car golf carts newer than 1995 have an OBC or ” On Board Computer ” in the charge circuit to monitor and control several functions on the golf cart. The tutorial below explains a little about the OBC, how to reset it after charging problems, and what to do if its completely failed.

Does the on board computer (OBC) disable the golf cart while charging?

Apr 26, 2022 · The easiest way to tell is to lift up the seat and look inside the battery area. Look for the main negative wire coming off of the last battery in sequence (it will be the only negative wire not going to another battery). If you have an OBC (on board computer) the wire will come off of that negative wire and through the middle of a small box about 4" inches square.

Does the OBC charge the battery?

Measure from battery pack positive terminal to the negative socket on the charger receptacle. There should be a few less volts than entire pack voltage. If not the On Board Computer that the controls the charging system on the golf cart has failed. If the voltages are OK and the relay in the charger is not clicking once, there is a problem with ...

image

How do you reset the OBC on a Club Car golf cart?

Resetting the OBC must be performed in this order:
  1. Key switch to off.
  2. Set forward/reverse to neutral.
  3. Put tow/run switch to tow.
  4. Disconnect the negative battery terminal from the battery pack.
  5. Put the tow/run switch to run.
  6. Put forward/reverse switch to reverse.
  7. Put key switch to on.

Where is the OBC on a golf cart?

Look for the main negative wire coming off of the last battery in sequence(it will be the only negative wire not going to another battery). If you have an OBC(on board computer) the wire will come off of that negative wire and through the middle of a small box about 4" inches square. The small box is the OBC.Apr 26, 2022

Can you bypass Club Car OBC?

To bypass the OBC you will need to connect a 12 gauge black wire from the negative terminal of this battery to where the black wire attaches to the back of the receptacle. That's it folks; you're done!

How do I test my OBC golf cart?

Measure from battery pack positive terminal to the negative socket on the charger receptacle. There should be a few less volts than entire pack voltage. If not the On Board Computer that the controls the charging system on the golf cart has failed.

What is BMW OBC?

The On Board Computer (OBC) was a digital meter unit offered by BMW. It provided live data such as time, average speed and fuel range, and was mounted in the centre console.Mar 10, 2013

How do I tell what year my club car golf cart is?

Club Car Golf Carts manufactured after 1981 will have their serial numbers positioned just under the glove box on the passengers side of the vehicle and you will need this serial number to identify the year of your Club Car. The first two numbers will indicate the year your cart was made.Jun 2, 2021

How do you remove the speed limiter on a electric golf cart?

Part of a video titled How to remove governor on a Club Car golf cart - YouTube
0:00
0:46
You open up this box lap. Here. It looks up look inside. There's 12 cable down right here this leverMoreYou open up this box lap. Here. It looks up look inside. There's 12 cable down right here this lever you want to lift up and Bend and that pulls on the cable a little more.

What is the tow run switch on Club Car?

TOW / RUN switches are basically kill switches designed to disable the golf cart. there are several reasons for this switch. Usually, a TOW / RUN switch is only used on electric golf carts, specifically those with a separately excited electrical system with regenerative braking.

Where is the speed sensor located on a Club Car golf cart?

Typically, the speed sensor can be found on the backside of the motor. When removing the speed sensor, unplug all the cables that are on the backside of the motor. To do this, use a socket to take off the connector pigtail. Then, remove its plastic housing over the sensor.

What year club cars have OBC?

1995
Since 1995, 48 volt Club Cars come with an OBC. The OBC is a small device that is wired into the golf cart that's purpose is to regulate the batteries charge.

How do I know if my golf cart motor is bad?

You have enough going on in your life without your golf car refusing to start when you turn the key in the ignition. If your golf car won't start, is slower than it used to be, or is experiencing other technical problems, you could have a bad motor on your hands.May 14, 2021

How do I know if my golf cart controller is bad?

When your golf cart's speed controller isn't operating correctly, your cart will show it by running erratically or failing to drive at one constant speed. If your cart starts showing these symptoms, the first thing you should look at is your speed controller.Mar 7, 2018

Why is my cart not starting?

If your cart doesn’t start even when your batteries are full, and no clicking sound comes from the solenoid, it means your solenoid is defective or accelerator. If you hear a distinct clicking sound, this means that there is nothing wrong with solenoid as it allows power to flow to the controller.

Is the Ping G25 adjustable?

Is the Ping G25 driver adjustable? The Ping G25 driver is adjustable. It’s possible to do four adjustments using the hosel adapter of the driver apart from the stated loft setting and...

What is a speed controller?

The speed controller helps the rider adjust the current going to the golf cart motor, therefore adjusting the speed. This adjustment is performed by modulating voltage by the controller such that the user has full control over their club car golf cart.

Is the Taylormade M4 driver adjustable?

Is the TaylorMade M4 driver adjustable? Yes, the TaylorMade M4 driver is adjustable. It’s possible to have twelve different options for the loft, lie angle and face angle, including the standard...

image
A B C D E F G H I J K L M N O P Q R S T U V W X Y Z 1 2 3 4 5 6 7 8 9