On gas motors, they will be attached to the large starter/alternator bolted to the engine. On newer electric models of golf carts, an EzGo for example, the solenoid has its own compartment under the seat and is accessed by removing a protective cover. Troubleshooting A Golf Cart Solenoid
How to start a gas golf cart?
Method 1 Method 1 of 2: Driving a Golf Cart
- Understand golf carts. Golf carts are classified under Neighborhood Electric Vehicles. ...
- Use the key. Like the golf cart’s older cousin, the automobile, you will need a key to start it. ...
- Put your seat belt on. ...
- Once everyone is seated, you’re ready to accelerate in the golf cart. ...
- Use the brake. ...
- Drive backwards. ...
How do you slow down a gas Yamaha golf cart?
Yamaha Golf Cart Running Slow with New Batteries
- Ensure that the distilled water levels are always above 50% inside the battery. New batteries do usually have enough distilled water levels but might drain out in a short while.
- Ensuring proper series wiring is important while installing a new battery in your Yamaha golf cart. ...
- Check the user guide manual for instructions on setting up a new battery. ...
How do you convert electric golf cart to gas?
How to Convert a Golf Cart to Gas
- Purchase a gas engine, transmission and tank. If you deem these new parts too expensive, then you can strip a used gas powered golf cart of these parts.
- Place the cart up on the car jacks, so you can work comfortably. ...
- Remove your golf cart battery and starter. ...
- Remove your engine and transmission. ...
What is the biggest motor on a gas golf cart?
Specifications
- With 14 horsepower, this personal transportation vehicle gives you a speed of 19 mph.
- The fuel tank included has a capacity of 6 gallons.
- This golf cart can carry up to 2 people and is ideal for covering long distances over the golf course.
How do you fix a golf cart accelerator?
Open up your cart hood and find the wires connected to your controller. Check to make sure each of these wires is properly screwed down and held in place. Inspect all other wires throughout your engine and accelerators. Tighten the connections on these wires to ensure that they run smoothly.
How does a gas pedal golf cart work?
In a gasoline-powered golf cart, the engine starts when you step on the gas pedal, and it shuts off when you take your foot off the gas. That feature helps save gas, cuts down on emissions and helps keep the course quiet, too.
Why does my golf cart not accelerate?
Bad Solenoid If your golf cart does not accelerate, there is a possibility of the damaged solenoid. The solenoid is basically an electrical switch that enables the battery's flow from the battery into the motor. Check out the signs of the bad solenoid.
What is an MCOR on a golf cart?
Club Cars use an MCOR throttle device. This translates your foot movement at the pedal into electric impulse that the motor controller reads. MCOR stands for "Motor Controller Output Regulator".
What causes a golf cart not to move?
Solenoid Wear When there is a disruption in the flow of the electrical current, your cart will not operate. A common reason for current disruption is solenoid wear. Each time the solenoid activates as you press down on the gas pedal, the solenoid compounds down onto a thin metal contact plate.
How do you fix a golf cart that won't move?
When the cart won't move, you have to be sure that the batteries are sending sufficient power to the circuit. You must check the fuse. Use the voltmeter to check the voltage at the key switch. In a cart with batteries rated at 48V, it must show 48V at the key switch.
What does a solenoid do in a golf cart?
The solenoid is the small unit that rides on top of the starter in the engine. The solenoid brings power from the battery to the rest of your golf cart. With the use of an electric charge, a solenoid may generate a magnetic field.
How does a golf cart potentiometer work?
It sends an electrical signal to the speed controller from the accelerator pedal, indicating the pedal's position. When it is working properly, the potentiometer allows your golf cart to accelerate smoothly. Find your potentiometer and inspect it for any cracks, broken parts, or disconnected wires.
How do you troubleshoot a gas golf cart?
InstructionsCheck the gas tank to make sure there is enough fuel for operation. ... Remove the oil dipstick and check that the oil level is at or just above the add or fill maker. ... Inspect the battery of the golf cart. ... Examine the wiring and switches. ... Remove the air filter from the engine to access the carburetor.
Where is the MCOR located on Club Car?
The MCOR is placed on the side of the batteries.
What does DS stand for in club car?
What does DS stand for in Club Car golf carts? The Club Car DS model type, in production from 1980 to 2014, was named after Dom Saporito, a vehicle designer at Club Car in the 1980s.
Does ezgo have MCOR?
E-Z-GO - MCOR Part # 5857 - EZ GO Golf Cart Parts.
What is a golf cart?
Golf carts give you the ability to ride around in a comfortable car and finish your round quicker. Golf carts come in a variety of models and power methods. Gas-powered carts were the first to hit the market.
How fast can a golf cart go?
Some golf carts can make it to 25 miles per hour if they're used on a and not on a golf course. They usually come with low-emission engines with a single cylinder. They also only have a 1-quart oil capacity with splash lubrication.
Do golf carts have reverse gears?
Make sure that the parking brake is pushed all the way down or the engine will not start. Golf carts only come with forward and reverse gears. They usually have a lever or a button that allows you to switch from forward to reverse and back again.
What does it mean when your engine idles?
This means that you wont be using much (if any) of your factory wiring and your engine will idle/stay running after it has been started or until you turn it off. This also means that you will likely have to "wire" your new engine from scratch or buy a pre-made wiring harness.
Can a GX390 be pedal start?
The engines idle screw is backed out so the engine will not idle. This method does not require any additional wiring but typically the only engines that will be pedal start are the smaller GX390/Clone engines and the factory engine. Most other aftermarket engines are too large to also incorporate the Starter/Gen and retain the pedal start.
