Weak batteries, incorrect tires, and wear and tear to the motor are all potential causes of your cart’s slow speed. Tire Size – The size of your cart tires is another factor that may be impacting your speed uphill. The larger your tires are, the more work your carts needs to do to get uphill.
Why won’t my electric golf cart drive on inclines?
When you’re electric golf cart struggles on inclines for a variety of reasons, including weak batteries, incorrect tires, or worn-out motor or wiring, you could be in for a long day. You can restore your vehicle’s mobility by calling your local golf car service for help.
Why does my EZGO golf cart stop suddenly?
The main reason why a EZGO golf cart stops suddenly is because of a bad solenoid or low voltage levels causing a thermal cut.
Why does my EZGO RXV golf cart make a clicking noise?
EZGO golf cart rear end noise problems The bearings of a golf cart bare fixed to the differentials, so any problem in that part can create different types of sounds. This is the reason why damaged bearings are the common cause for all of the sounds that occurred at your cart’s rear end. EZGO RXV golf cart makes a clicking noise
What do you need to know about E-Z-GO golf carts?
The E-Z-Go golf cart is one of their premier products and is in use in several golf courses. If you are planning to purchase a fleet for your company, you need to know how they work and make necessary repairs. Here is a comprehensive guide on maintenance and troubleshooting E-Z-Go carts.
Why is my golf cart so bouncy?
One of the common issues associated with the golf cart bounce is the tire. If the tires are not aligned properly or the threading has worn out, it could cause the cart to bounce. Examine your tires carefully to identify the issue and if required get your tire replaced or realigned.
How can I make my golf cart climb hills better?
An older cart can be upgraded to perform better up hills. Adding larger 20"- 23" all terrain tires will help. 1) Tighten your terminal connections. 2) Clean any corrosion on battery terminals and cables.
Why does my electric golf cart surge?
A golf cart can be surging due to insufficient fuel levels, damaged motor brushes or a vacuum leak. The brushes in the motor are damaged or worn out. The MCOR is malfunctioning or a mismatch between the motor and controller results in torque bumps.
Why does my electric golf cart jerk when accelerating?
Why does my Club car golf cart jerk when accelerating? The main reason why a Club car golf cart jerks when you accelerate it is due to a misaligned Inductive Throttle Sensor or dirty clutch.
Why does my golf cart struggle up hills?
A golf cart is designed to carry two golfers and their equipment around the course with less effort than walking. When you're electric golf cart struggles on inclines for a variety of reasons, including weak batteries, incorrect tires, or worn-out motor or wiring, you could be in for a long day.
How do I get more torque out of my electric golf cart?
Change the Speed ControllerThe Speed Controller regulates the electric output of the motor; a higher voltage equals more RPM, and the faster your cart will travel. When you change the speed controller, you can reduce the voltage and increase the amperage of the motor, resulting in increased torque.
Why does electric golf cart sputter?
Golf carts can spit and sputter for several reasons, but mainly due to worn out spark plugs or dirty filters inside the fuel system. There might be something wrong with the fuel system of your cart. You could be having a spit and sputter problem because the filter, pump and injectors in your golf cart are very dirty.
How do I know if my golf cart controller is bad?
X Common Symptoms of Controller FailureTop Speeds Not Appropriate for Your Cart. Golf carts are designed to reach pretty specific speeds and to not go over them or beneath them. ... Sudden and Unexpected Slowing. ... Shuttering or Shaky Driving. ... Stalling Out and Refusing to Start. ... Surges in Speed When Driving.
How do I know if my electric golf cart motor is bad?
You have enough going on in your life without your golf car refusing to start when you turn the key in the ignition. If your golf car won't start, is slower than it used to be, or is experiencing other technical problems, you could have a bad motor on your hands.
How do you fix jerky in a golf cart?
One way to fix the jerky acceleration on a Club Car golf cart is to check if the battery charge is dropping and the battery is nearly dead under load. A load test will help you determine this. If recharging the batteries doesn't help, getting a new battery or new batteries fitted should work.
What does the MCOR do on a golf cart?
The club car MCOR or the motor controller output regulator works like a dimmer in the headlight. It determines how much power is needed to get the desired speed by modulating the voltage. The variation in the electric output is done by the MCOR to get the desired speed.
Where is the speed sensor located on a Club Car golf cart?
The speed sensor in a Club Car Precedent golf cart is located on the back of the motor. To remove the sensor, unplug the cables behind the motor. You can use a 5/16-inch socket to remove the pigtail connector and pop off the plastic housing that encases the speed sensor.
Which golf cart is best for hills?
More Terrain Versatility – A gas golf cart does much better with steep hills and rough terrain because it has more horsepower to do tougher tasks. Longer Use – A gas golf cart is going to last much longer on a full tank of gas compared to an electric golf cart on a full battery in almost every case out there.
Will a 36 volt golf cart climb hills?
A golf cart powered by a 36-volt motor would either move too slow or not at all when going up on a hill. It is recommended to use a 48-volt battery for optimum performance as it creates more low-end torque and faster acceleration.
How do you adjust the governor on a club car?
0:040:46How to remove governor on a Club Car golf cart - YouTubeYouTubeStart of suggested clipEnd of suggested clipSo the farther you bend that normally the faster it goes and then that's it basically when you wantMoreSo the farther you bend that normally the faster it goes and then that's it basically when you want to return your heart you just bend that back down and go back to normal speed.
Can you make a 36 volt golf cart go faster?
Simply put, most types of golf carts are designed to work with a range of different batteries. A new battery will increase a golf cart's motor output. The result of the motor output increase is higher speed. Purchasing new batteries with a higher voltage maximum will increase your golf cart's speed dramatically.
Why is my electric golf cart slow?
Your electric golf cart can struggle on inclines for a variety of reasons. Weak batteries, incorrect tires, and wear and tear to the motor and wiring are all potential causes of your cart’s slow speed.
Why does my golf cart go slow?
Our assessment of why does my electric golf cart goes slow uphill has yielded several answers. While battery problems tend to be the most common reason for slow speeds uphill. The size of your tires, speed, wire corrosion, and brake solenoid damage are also possible causes for your cart’s slow speeds. I recommend checking your batteries ...
What happens when a brake solenoid overheats?
When your brake solenoid overheats, it will pull all your power through the resistor spring, reducing the energy transmitted to your battery. YouTuber Mike Hughes found that disconnecting the two wires leading to the solenoid, along with the cart’s speed sensor, helped to improve the transmission of power to the motor.
What factors affect your speed uphill?
The size of your cart tires is another factor that may be impacting your speed uphill. The larger your tires are, the more work your cart needs to do to get uphill.
How to tell if a battery is going slow?
The best way to identify if the batteries are the root of your go slow is to use some alligator clip test leads. Link your meter to the positive and negative connection of the cart. Then do a test, driving uphill to simulate the problems you have had.
Can mud affect a cart's speed?
That impacts the ability of your cart to navigate slopes and may even struggle on flat terrain. The performance of your cart’s sensor can become impaired from mud build-up, which cover s the sensors and blocks their ability to determine speed. Cleaning the mud off the sensors should see it back up and running.
Why does my EZGO make a noise?
Why is my EZGO making noises from the rear end? The main reason a EZGO cart can start making noises in the rear end is because of loose bolts, or because the input shaft splines are dirty and need to be greased. Check the input shaft splines of the motor as over time they need to be cleaned or greased.
Why does my golf cart make a noise?
The common reason behind any sounds occurring from the rear end of a golf cart is damaged Motor bearings. But it is also for a coach to make noises after a certain period of usage. Well, when a cart gets old, it requires extra care anyway, so let’s get started.
How to check if your cart needs fluid oil?
Check if your cart needs fluid oil. Ensure the belt is not worn out; if it is, then replacing it could stop the noises. Check if the clutch shaft is alright. If it is damaged, then it will become loose whenever the clutch will open and start making noises.
Is a noisy steering wheel common?
A noisy steering wheel is not at all something only you are facing; it’s pretty common. Here is a step by step trouble mentioned below; see if it would work:
Is a golf cart dangerous?
A golf cart making weird noises is a very common issue. Sometimes, these noises reach such a high pitch that it becomes beyond annoying. If the cart is making whining noises, then it’s not that dangerous.
Why is my golf cart surging?
A golf cart may be surging due to faulty batteries, faulty battery cables, or because the speed sensor connection has become loose. There are one or more bad batteries or battery cables. Check the battery pack voltage when the cart is stationary.
Why is my carburetor backfiring?
There is backfiring because of incomplete closure of throttle shaft, improper accelerator cables adjustment, damaged carburetor gaskets or loose connection of the nuts that connect the airbox to the carburetor.
What happens if you don't slack your cart?
If there is no slack, the cart will run at full throttle when you press the pedal lightly. The linkage before the front timing cover must also not be too tight. The connections between the motor and controller are either incorrect or corroded. In case of incorrect connections, redoing them correctly will suffice.
How to check if rev limiter is reached?
To check this, you can fasten the belt followed by jacking the cart and flooring it. Check if the belt makes contact with the top of the primary clutch as well as goes down to the bottom of the secondary clutch. If so, loosening the governor spring can help.
How to troubleshoot a Yamaha G16?
You can use the steps given below to troubleshoot a Yamaha G16 that surges. The carburetor is dirty due to dust accumulation. Remove it from its place and clean it thoroughly ensuring that the float bowl and the small air compressor are clean. Disconnect the fuel line and drain off the old fuel.
Why is my carburetor float blocked?
The float bowl is accumulated with water or dirt. Alternatively, the main jet may be blocked because of old bad gas varnish. Cleaning the float bowl and main jet may be a good idea. The carburetor bowl is misaligned or the gasket is worn out. Fix the bowl back in position and replace the gasket.
Why are my pot pads burning out?
The contacts on the pot pads have burnt out. The water level in the batteries is insufficient. The batteries or their cables are old and due for a replacement. The connector of the speed sensor is not snapped tightly in position. The cables connected to the motor and the eyelets have become loose.
Why does my EZGO golf cart stop?
Why your EZGO golf cart stops suddenly? The main reason why a EZGO golf cart stops suddenly is because of a bad solenoid or low voltage levels causing a thermal cut.
What is the red wire on a golf cart?
The red wire with the connector is the bypass. Ensure that the solenoid gets started at one go and all wirings connected to it are in perfect order. In case of any sort of loose wirings or broken wires, that may cause the golf cart to malfunction and it may come to sudden halts at frequent intervals.
Do you need a key switch on a golf cart?
The key switch or the solenoid should be in perfect order to ensure the golf cart is working perfectly. Ensure there are no loose wirings in the solenoid, if the wirings get damaged then it is recommended to change the wirings. The RXV has been known to be very sensitive to battery voltage.
Can you remove plastic wiring from an EZGO RXV?
The plastic wiring can be removed by getting those untapped from the wires and inspecting those.