Both the fill plug and the drain plug use the 17mm size, so if you are checking the fluid, or changing the fluid in the transmission - then you will need the hex key / allen wrench. For the oil pan - it's a normal drain plug - like a bolt. Uses something like 19mm just as they said.
Full Answer
How to drain the oil from a VW Golf?
Allow the oil to drain from the engine into the oil drain pan container. While the oil is draining from your VW Golf, inspect the oil pan drain plug and sealing washer. If the threads on the plug look worn, replace the oil drain plug.
What size wrench do you use to remove the oil pan nut?
Figure 3 Use a 19mm wrench and remove the nut. The threads are approximately an inch in length so be prepared as you are unthreading it. Figure 4 Drain all the oil from the pan (red arrow). Don't forget the oil stream will change its flow as the oil drains so don't leave it unattended.
What's the VW Golf oil filter housing location?
The VW Golf oil filter housing is located under the decorative engine cover. There are four grommets in each corner holding it in place. To remove the cover, gently pull up on each corner. One at a time. Be careful not to crack any of the plastic.
What kind of oil does a VW Golf take?
5 Liters of German Ravenol Motor Oil - VW motor oil quality standard 507 00 required for 2.0 TDI diesel engines. Allow your engine oil to warm up. Drive your VW Golf for approximately 5-10 minutes, allowing the old motor oil to warm up for optimal oil flow and thorough drainage.
What size is VW oil drain plug?
Dorman - Autograde - Oil Drain Plug Pilot Point With Floating Washer M14-1.50, Head Size 19mm (Part No. 090-171.1)
What size socket fits oil drain plug?
3/8-inchPlace a 3/8-inch (0.9 centimeters) socket in the socket wrench, fit it over the drain plug's nut and turn it counterclockwise. The oil drain plug should open easily, draining the used oil from the engine. Make sure to place a bucket and some newspaper under the car's engine to catch all the draining oil.
What size is the oil drain bolt?
Oil Drain Plug Standard M14-1.50, Head Size 17mm.
What kind of wrench do I need to change oil?
You'll need a ratchet and socket set to remove the oil drain plug, an oil filter wrench (or maybe just a strong grip) to remove and install the filter, a drain pan to catch the spent oil, and a funnel to refill it.
How do I know what size socket I need?
Look through the table's decimal column and select the first decimal larger than your caliper reading. Select the corresponding fraction. The website Sizes has a table showing Imperial (American) socket sizes. If the fraction is listed, it's the size of your nut and required socket.
How do I unscrew my oil drain plug?
0:061:47How to Loosen the Oil Drain Plug - YouTubeYouTubeStart of suggested clipEnd of suggested clipWe will remove the oil drain plug by turning it counterclockwise the old saying lefty looseyMoreWe will remove the oil drain plug by turning it counterclockwise the old saying lefty loosey indicates the um leftwards turning of the nut to loosen it and then they say right tight.
How do you remove an oil filter without the tool?
0:421:36Loosen oil filter without wrench - I used a belt - YouTubeYouTubeStart of suggested clipEnd of suggested clipPut it over the filter. Tighten it then just pull pull down. There you go. And just like that thingsMorePut it over the filter. Tighten it then just pull pull down. There you go. And just like that things loose I believe it is all right perfect good luck.
Are oil drain plugs reverse threaded?
it is regular-threaded. Righty tighty. Also, as the plug is threaded into aluminum, I like to use a torque wrench on mine so as not to over tighten.
Are oil plugs universal?
This plug is universal. It should fir on any oil pan. The only thing about it is that it is intended to be permanent.
What is 19mm in standard?
1/2"Metric / Standard Wrench Conversion ChartBolt DiameterMetricStandard1/2"19mm3/4"9/16"21mm13/16"22mm7/8"5/8"24mm15/16"39 more rows•Apr 9, 2020
What tool is used to remove an oil filter?
An oil-filter wrench is a tool for removing spin-on type oil filters.
Do you need a torque wrench for oil change?
Just get it tight but not too tight and you are good to go. Doubtful that your mechanic uses a torque wrench. I did my oil for the first time on my 997.2 this weekend. Though I did use two torque wrenches I already own, I would say they are not necessary.
What size is the oil drain plug on a 2010 f150?
Dorman - Autograde - Oil Drain Plug Pilot Point M14-1.50, Head Size 16mm (Part No. 090-053CD)
What size is the oil drain plug on a 2012 f150?
Dorman - Autograde - Oil Drain Plug Pilot Point M12-1.75, Head Size 15mm (Part No. 65430)
What size is the oil drain plug on a 2010 Chevy Silverado?
15mmDorman - Help - Oil Drain Plug Pilot Point M12-1.75, Head Size 15mm (Part No. 69011)
What size is Ford f150 oil drain plug?
Dorman - Autograde - Oil Drain Plug Standard M14-1.50, Head Size 17mm (Part No. 090-033.1)
Where is the oil filter on a VW Golf?
The VW Golf oil filter housing is located under the decorative engine cover. There are four grommets in each corner holding it in place. To remove the cover, gently pull up on each corner. One at a time.
What happens if the oil drain plug is worn?
A worn oil drain plug can also inhibit the factory torque causing a poor seal and possible oil leaks.
What happens if you overfill your oil?
When the engine oil is overfilled, excessive engine oil burn and damage to the catalytic converters can occur. If the oil level is over the max dipstick level, the excess oil needs to be removed from the engine. [The VW oil capacity on a VW Golf 2.0 TDI is 5 liters.]
Can a worn oil drain plug cause a leak?
A worn oil drain plug can also inhibit the factory torque causing a poor seal and possible oil leaks. If the washer looks crushed it should also be replaced. Failure to do so could allow for oil leaks. While the oil is draining, inspect the oil drain plug.
Joe Blow
The tiptronic is not the DSG - two separate transmissions. You don't need to service the tiptronic every 40k like you do the DSG. VW considers the fluid in a Tiptronic tranny as "lifetime" fluid - it doesn't need to be changed.
Joe Blow
It is a drop in -sort of. It's on the bottom side of the engine, under the plastic skip plate. It's still a canister filter, but the housing is upside down. So you slide it up into the housing instead of dropping into it. Does that make any sense? This is a step by step oil change with photos: http://forums.vwvortex.com/zerothread?id=2570457
paul proctor
hi, how do you mean drain the oil from the oil filter you need to replace the oil filter not just drain it.
Bob Kovalak
Consult the Owner's Manual, or view the oil specifications on the fill cal or dipstick (usually the fill cap) located under the hood. Depending upon mileage you may not want to vary from manufacture specifications, or risk voiding your vehicle's warranty should any remain. The VW TDI's are typically high maintenance engines.
Anonymous
This means that your vehicle requires service. Something is wrong. You can take it to Autozone and they will put it on their diagnostic machine for free. And tell you what is wrong. Usually nothing major. Just needs to be checked out. PLEASE RATE by checking one of the 4 thumbs ups! Thanks! Have a GREAT DAY!!!