Full Answer
Where can I buy replacement parts for my EZGO golf cart?
Replacement parts for EZGO golf cart can be purchased on the Ezgo website. They can also be purchased through nivelparts, golflink or blockbustergolfcarts. How much oil does a ezgo golf cart engine hold?
Why are my EZGO RXV golf cart lights not working?
A blown-out headlight fuse is the main reason that your EZGO RXV golf cart lights are not working. An incorrect circuit connection to the headlight fuse can also cause the lights to stop working. There are times when the circuit wires are torn or worn out.
How do you wire an LED light bar to an EZGO?
How do you wire an LED light bar to an EZGO golf cart? 1 Remove the rivets in the front splash by drilling them. 2 Loosen the screws so that the light bar can slide into it easily. 3 Disconnect the wire harness. 4 Connect the headlight bar brackets. 5 Use the bolts on the brackets to tighten the light bar. More ...
Can you drive a golf cart on the street with lights?
The cardinal rule before taking your golf cart out on the street, EVEN WITH the proper lighting/indicators is: CHECK YOUR LOCAL LAWS. Laws and rules are constantly changing, so before taking your golf cart out on the roads, ALWAYS check with your local municipality. What is the deal with Club Car Precedent 2004-2008.5 and 2008.5+ light kits?
What size fuses for a golf cart?
Replacement ATC-10, 10 amp fuse. This fuse is commonly used for 12VDC, 10Amp accessory loads in Club Car gas & electric DS & Precedent model golf carts as well as Yamaha gas & electric G9-Up model golf carts. However, this fuse can be used in many other applications for accessory loads.
Is there a fuse for the lights on a golf cart?
Many of the electrical components in a golf cart use fuses, including lights, cigarette lighters, power outlets, fans, horns and turn signals. Keep in mind that fuses blow for a reason. If a fuse burns out for the same application more than once a year, there is something wrong with your cart's electronics.
How do I fix the lights on my EZ Go golf cart?
How to Fix EZGO RXV headlights not workingFirst, check all the wires used to establish a circuit connection.Check if the wires are torn or not connected properly.Use the DVOM to check the amount of power going to the fuse.If there is no power, then the fuse is blown.More items...
What size fuse do I need for LED lights?
However, we must also allow for an additional 20% higher Amperage fuse, much like we would add to our LED Strip calculation when determining the correct Drivers. We would then suggest that a 5A fuse will be perfectly suitable. Using this formula, we can now move on to LED Strips.
Is there a fuse on an ezgo golf cart?
Most EZ-GO carts will the fuse located in the charging receptacle.
What voltage are golf cart lights?
36-volt or 48-volt Voltage Reducer Brake lights, tail lights, turn signals, horns, headlights, radios, GPS and similar accessories on your golf cart use 12-volts. But, most golf carts have either four 12-volt batteries, six 8-volt batteries or eight 6-volt batteries which are considered 48 volt system golf carts.
How do you wire golf cart headlights?
1:413:27Updates to a Club car Golf Cart wiring up some headlights and taillights ...YouTubeStart of suggested clipEnd of suggested clipBut there is a light switch. And over here we have a fusible link tied in and what I did was this toMoreBut there is a light switch. And over here we have a fusible link tied in and what I did was this to tie. In these two batteries in the front they're going to be different from 36 volt and 48 volt.
How do you wire a 12 volt light to a 36 volt golf cart?
2:0714:30Wiring a One Wire 12 Volt Light On a 36 Volt Golf Cart - YouTubeYouTubeStart of suggested clipEnd of suggested clipBy from two to six volt batteries that's a consecutive order to give me 12 volts I have the hot wireMoreBy from two to six volt batteries that's a consecutive order to give me 12 volts I have the hot wire wired in at the main positive lead then get to the negative terminal.
Do golf cart chargers have fuses?
Golf Cart Issues If the Club Car's computer is working correctly, the relay should make a “click” sound when you plug in your charger. If it does not, then you could easily have a blown fuse. If you check the fuse and it is okay, then you could also have a damaged relay, although this is rare.
What fuse to use for lights?
A lighting circuit is protected by a 5- or 6-amp fuse or circuit breaker. This fuse size allows bulbs with a maximum combined wattage of 1150 watts (5 amps x 230 volts) or 1380 watts (6 amps x 230 volts) to be run off the circuit.
How do I know what size fuse I need?
To calculate a fuse rating, manufacturers work from a simple equation:Power (watts) = Voltage x Current (amps) What we really want to know with this equation is the current (amps). ... Amps = Watts / Voltage. So, let's say we need to work out the fuse rating for a washing machine. ... 850/120 = 7.08 amps.
How do you know what size fuse to use?
The voltage and current ratings are paramount. A fuse should be de-rated by 25% at room temperature, meaning if there is a 7.5 amp circuit, a 10 amp fuse should be used at 25˚C. Voltage ratings on a fuse can be higher than the voltage on the circuit, but not lower.