- Overview. Replacing your own golf grips is easy, rewarding and can save you a lot of money. ...
- Paint Thinner / Mineral Spirits. Paint thinner or Mineral Spirits are cheap alternatives to grip solvent and also dry quickly. ...
- Rubber Cement. Another affordable substitute is rubber cement. You do not need grip tape when using rubber cement, which increases the savings.
- Water. Water works as a solvent when used with water-soluble tape. After completely removing the old grip, apply water-soluble tape to the shaft where the new grip will be.
- Air Compressor. A 120 volt or higher air compressor can be used to install and remove grips. ...
- WD-40. Everybody has a can of this all-purpose lubricant/cleaner in their garage. WD-40 is not the most economical solvent to use, but it is good in an emergency.
How to regrip a golf club?
If you are regripping more than one club, use the excess solvent on the other clubs. 4. Slide grip into place While the grip tape is still wet, roughly align the grip and pull it down over the butt end of the shaft. Make sure the end of the shaft nestles into the very end of the grip. Fine-tune the alignment so the clubface and grip are square.
What are the best solvents for cleaning a golf grip?
Traditional golf grip solvent is the most versatile and safest to work with. But if you run out of solvent and do not have the time to wait for another shipment, there are plenty of alternative household solvents you can use. Paint thinner or Mineral Spirits are cheap alternatives to grip solvent and also dry quickly.
What can I use instead of Golf Grips?
1 Overview. Replacing your own golf grips is easy, rewarding and can save you a lot of money. ... 2 Paint Thinner / Mineral Spirits. Paint thinner or Mineral Spirits are cheap alternatives to grip solvent and also dry quickly. ... 3 Rubber Cement. Another affordable substitute is rubber cement. ... 4 Water. ... 5 Air Compressor. ... 6 WD-40. ...
How do you fix a hole in a golf grip?
Use a golf tee to plug the hole at the end of the grip. Pour solvent into the open end of the grip. Cover the open end with your hand and shake to distribute the solvent. Remove the tee and pour the excess solvent onto the grip tape on the shaft.
What solvent do you use to replace golf grips?
Mineral spirits, denatured alcohol, acetone, nail polish remover or charcoal lighter fluid, all provide adequate deactivation of grip tape to install new grips. They also evaporate relatively quickly to allow the grip tape to bond to the grip in a relatively short amount of time, often less than an hour.
What do you put on golf grips?
Grip solvent is the right choice, and generally is non-toxic and works well enough. Through the years, I've used the following solutions to help slide new grips on: lighter fluid, mineral spirits, acetone, and grip solvent made by clubfitting supply companies.
Can you use WD40 to Regrip Golf Club?
Some people will use WD40 when they are regripping golf clubs. WD-40 is not the best solution to use as a grip solvent because it is priced a bit higher than other choices, but it will work. You can use the WD-40 to remove grip tape from golf clubs, and then you can use it as the solvent when you put a new grip on.
Can I use acetone to Regrip golf clubs?
Acetone is more flammable, more toxic and more destructive than lighter fluid which is commonly used for DIY golf club regripping. However, you can use acetone to clean the gunk and residue left on your shaft when you take off your old grip.
What is golf grip solution made of?
Some golfers use paint thinner, mineral spirits, acetone, lighter fluid or even camping fuel as a grip solvent.
Can I use white spirit for golf grips?
Yep it's easy, no need for a vice either, yes it's nice if you have one but I have always manged easily without one. you will need a craft knife, double sided tape ( available from the pro or online) a bottle of white spirit and a few rags.
Can you use soapy water for golf grips?
Warm Soap and Water If you're looking to keep this cleaning mission as cost-efficient as possible, stick with good old-fashioned warm soap and water. To do this, we suggest cleaning golf grips (and clubs) outdoors or in the garage (as your wife probably doesn't want your dirty golf clubs in the kitchen sink).
Can You Use soapy water to Regrip a golf club?
The only thing it could do is make it slick so the grips would slide right on with little trouble. If that's how it works then how does it work when it dries? The tape couldn't be working as there isn't anything to activate it. Just to let you know, I am NOT using the water activated grip tape, just the regular stuff.
What liquid do you use to Regrip golf clubs?
Pour the excess Mineral Spirits Grip Solvent (through the vent hole) over the entire length of the two-sided tape. Apply generously. Use a tray to catch excess Mineral Spirits Grip Solvent for use on other clubs.
Can you use acetone instead of grip solvent?
An outstanding substitute golf grip solvent is nail polish remover. The main ingredient in nail polish remover is acetone, so that means you can use paint thinner just as easily as you can use nail polish remover.
Can you use methylated spirits to Regrip golf clubs?
Works fine. I use turps, metho drys to quick, just get the low odour one. But I don't bother with grip tape, i just use masking tape, grip tape tends to get stuck on the insides of the grips. And I use a large Vets syringe and needle to get them off (I have seen some fancier pump bottle setups as well).
How to activate tape on golf clubs?
After completely removing the old grip, apply water-soluble tape to the shaft where the new grip will be. Pour water inside the grip and over the taped area of the club to "activate" the tape.
Why do you need to have extra water to install grip tape?
Be ready to quickly install the grip and have extra water handy because the grip tape dries and becomes tacky very fast. If someone is available to help you, it works well if one person continuously pours water over the tape while the other slides on the grip. Once the grips are installed dry them and the club off.
How to remove grip from air compressor?
You can remove a grip using an air compressor by inserting an inflation needle under the lip of the old grip and adding enough air pressure to expand the grip enough to pull off. You can buy air compressors at home improvement stores and they range in cost from about $89 up to thousands of dollars.
Can you replace golf grips?
Replacing your own golf grips is easy, rewarding and can save you a lot of money. The skill can also come in handy if you need to replace worn grips but don't have time to take your clubs in for professional re-gripping. Traditional golf grip solvent is the most versatile and safest to work with.
Do you need grip tape for rubber cement?
You do not need grip tape when using rubber cement, which increases the savings. After removing the old grip, cover the butt-end of the club with masking tape to prevent cement from getting on the inside of the shaft. Use a paint brush to apply it to the shaft and slide the grip on.
Is WD-40 a good solvent?
Everybody has a can of this all-purpose lubricant/cleaner in their garage. WD-40 is not the most economical solvent to use, but it is good in an emergency. Apply double-sided tape to the area of the shaft where the grip will be.
Can you use golf grip solvent?
The skill can also come in handy if you need to replace worn grips but don't have time to take your clubs in for professional re-gripping. Traditional golf grip solvent is the most versatile and safest to work with. But if you run out of solvent and do not have the time to wait for another shipment, there are plenty of alternative household ...
How long does it take to regrip golf clubs?
The whole process of regripping golf clubs is probably going to take you somewhere between 1 to 2 hours. I wouldn’t call it an easy project, but once you do it once you’ll probably be comfortable doing it forever.
How often should I replace my golf grips?
Typically the rule of thumb is that you can replace your grips about every 18 months if you play 1-2 times a week, and live in a cold-weather climate.
What happens if you don't get the grip on your grip?
You absolutely want to get that grip on quickly and aggressively. If you don’t get the grip all the way down and it gets stuck, then you will likely be throwing that grip away. For you beginners out there, I would expect to possibly botch one or two attempts, which is why I recommend buying a couple of extra ones.
Can you regrip golf clubs at home?
Since I am not the most “handy” person in the world, and don’t have much experience regripping golf clubs , I decided to enlist the help of my friend Nick Banks who actually knows what he is doing since he is a PGA professional.
Can you spray a grip with solvent?
You almost can never have enough grip solvent! If you have a spray bottle or a tube, the first step is to place your finger over the small hole at the butt of the grip (this will prevent it from leaking out). Then you apply a generous amount of solvent to the inside of the grip.
Can you spray paint on a grip?
This is another step where you want to be generous with the solvent. You can even spray some extra solvent on the tape afterwards, it’s only going to make it easier to apply the grip.
How often should you regrip golf clubs?
For the average golfer, clubs should be regripped every year. If you play excessively then you will maybe need to consider getting the grips done more often. If you damage a grip you will need to get it redone too. You should also be cleaning your grips with soap and water every couple of weeks.
What do you need to remove old grips?
Other than that there are a few items that you will absolutely need and some that will just make your life a little easier. Double-sided tape is a must, a sharp Stanley knife for removing the old grips, white spirit, a bucket larger than the grips for draining excess spirit, a cloth and a vice with a shaft protector.
What happens if you don't line your grips?
If you don’t line your grips up correctly, it can be annoying but it can also badly affect your game. Grips have many lines and patterns now to help you grip the club correctly and these should be inspected once the grip is in place to check for proper instalment. Carefully inspect the grip and ensure all patterns are as they should be and any branding is aligned perfectly with the clubface.
How to put grip on airgun?
Then you want to take your air-gun and place the nozzle in the small hole at the butt-end of the grip. Using either a smooth push and a constant air-stream or short sharp movements with bursts of air, push the grip into place.
Do you need to part with your golf clubs?
By doing it yourself, you can save a lot of money and you don’t need to part with your clubs. It is a great skill to learn and it gives you more control over your grips. This is something that many top golfers do themselves and it gives you a whole new understanding of your clubs. Keep your clubs at home and make sure they are in top condition.
How to remove a knife grip?
1) Remove the old grips. First cut or peel off the old grips, which may or may not be straightforward depending on how long they’ve been on. With steel shafts you can be relatively ‘aggressive’ with the knife, always making sure to work the blade away from you not towards you.
How to pour white spirit?
Place your receptacle under the grip ( if your vice arrangement allows you to do so), then, pinching the open end to control the flow, pour the White Spirit over the double-sided tape with any excess falling into your receptacle to re-use. Place a bowl or similar under the grip when pouring on the White Spirit.
Can you use double sided tape on reels?
You can also get double-sided tape in sheet form rather than on a reel. Leave a little extra at the top and don’t unpeel the other side of the double-sided tape until you are ready to fit the new grip. Wrap the extra bit around the top so it is covered with tape as this will make it easer to slip the new grip on.
How To Choose The Right Golf Grips
Before you can start regripping golf clubs, you will need to choose a proper golf grip. There are hundreds of grip choices on the market. Here are a few ways to narrow down which one could be the right choice for your golf game.
How To Regrip Golf Clubs – A Step-By-Step Guide
We have put together a step-by-step guide to help you regrip your golf clubs. If you follow these steps and take our tips and precautions into consideration, there is no reason for you to pay for another regripping.
Common Mistakes When Regripping Golf Clubs
There are a few mistakes that golfers make when it comes to regripping golf clubs. These mistakes are easily avoided by following our process above. Here are the mistakes you will want to be aware of when regripping golf clubs.
Frequently Asked Questions
Here are a few of the most commonly asked questions about golf grips and how to put on golf grips. If you are changing golf grips, you are doing the best thing for your game, but make sure you fully understand this process.
Conclusion
We hope that you are now feeling more confident knowing how to regrip golf clubs. Learning to regrip golf clubs is a skill that will end up saving you and your friends quite a bit of money. The supplies are inexpensive and can save you up to $100 every few months.
How to get solvent out of golf grip?
Use a golf tee to plug the hole at the end of the grip. Pour solvent into the open end of the grip. Cover the open end with your hand and shake to distribute the solvent. Remove the tee and pour the excess solvent onto the grip tape on the shaft. Put a tray under the clamped shaft to catch excess solvent.
How long does it take to regrip golf clubs?
To regrip golf clubs is a simple, straightforward process. Once you’re familiar with the process, it’s possible to regrip golf clubs in a matter of minutes. You may want to entrust the task to your golf pro.
Why are rubber grips so popular?
Rubber grips are the most common, in part because they are often the most economical. Rubber grips come standard on many sets of clubs sold to everyday players. High-quality rubber grips offer the grip stability that many golfers appreciate.
What is the difference between a soft grip and a firm grip?
A firm grip allows for stability even when combined with the lighter grip pressure typically preferred by better players. A soft grip may cause excessive torque at higher swing speeds.
What are the different types of grips for golf?
There are four general categories of golf grips: wrapped, rubber, corded and hybrid.
What is grip selection?
Grip selection often involves finding the right balance between feel and club security. Any lateral movement of the grip in the hands during the swing spells trouble. Still, strangling the club with excessive grip pressure is counterproductive. Keep in mind that the needs of a hard-swinging adolescent may be very different from those of a retiree with a more languid swing.
What grips do hybrid golfers use?
To some degree, the fingers and the palm of your hand have different needs. Hybrid golf grips address this with a firm cord upper for control and a soft rubber lower for comfort.