The most common reason why your golf cart is stalling is due to a bad solenoid or a faulty speed controller. Batteries have lost charge Faulty ignition Problem with the direction switch Faulty speed controller Bad solenoid The solenoid wears out every time the gas pedal is pressed down. The solenoid gets pressed down to a thin plate.
Why won’t my golf cart run?
First off, if your controller is bad, your vehicle won’t run. However, there are other reasons that could lead to your vehicle not running. Here are a few quick troubleshooting tips. Make sure it isn’t your batteries! If your batteries are old and dead, then your golf cart will not operate. Charge them fully first and attempt to drive the unit.
Why does my club car golf cart Jerk when taking off?
Your Club Car golf cart jerks when taking off, because of a faulty MCOR or low battery charge. Wiper arms that are adjusted incorrectly can also cause a golf cart to jerk. Faulty MCOR. Low battery charge. Wiper arms and contact out of adjustment. Clutch problem.
Why is my golf cart stalling?
The most common reason why your golf cart is stalling is due to a bad solenoid or a faulty speed controller. The solenoid wears out every time the gas pedal is pressed down. The solenoid gets pressed down to a thin plate.
Why does my golf cart backfire when I start it?
Golf Cart Backfires Because Of A Carbon Buildup On Piston/Valves Another possibility (though less likely) reason for your golf cart backfiring can be a buildup of carbon on the piston, also known as coke. This material glows red hot after the engine runs for a while and ignites the fuel without the spark plug being turned on.
Why is my golf cart jolting?
A Club Car golf cart jerking from the front end of the golf cart occurs due to poor quality of tires. If the tires are worn out or loose, the golf car can start jerking. The uneven height of your front tires can also cause jerking.
Why does my electric golf cart hesitate when I accelerate?
If your cart does not start smoothly, hesitates before starting, or does not gain speed properly, these are all signs of a bad or damaged accelerator.
Why does my golf cart jerk when I accelerate?
Your 2015 Club Car golf cart jerks when accelerating because of a battery issue or a defective MCOR. A faulty speed sensor could also be the reason for the jerk. The steps that are given here can help you eliminate the jerk in your golf cart. Do a load test on the batteries using a battery load tester.
What causes a golf cart to surge?
A golf cart can be surging due to insufficient fuel levels, damaged motor brushes or a vacuum leak. The brushes in the motor are damaged or worn out. The MCOR is malfunctioning or a mismatch between the motor and controller results in torque bumps.
Where is the speed sensor located on a Club Car golf cart?
The speed sensor in a Club Car Precedent golf cart is located on the back of the motor. To remove the sensor, unplug the cables behind the motor. You can use a 5/16-inch socket to remove the pigtail connector and pop off the plastic housing that encases the speed sensor.
What causes a golf cart to lose speed?
Low Battery Usually, the most common reason golf carts slow down is when they don't get enough power output from the battery. If the battery pack charge is very low and your cart is out of power, your cart will run slow.
Why do my RPMs jump when accelerating?
If your car's RPMs fluctuate while accelerating, then you may be dealing with an engine vacuum leak in the engine. A vacuum leak is when there is an interruption in the air flow in the intake manifold or exhaust system of your vehicle.
How do you fix a car jerking when accelerating?
To fix this, you should clean the injectors on a regular basis. Using a fuel injector cleaning solution might eliminate the issue of the car jerking. If the clog is too severe, the injectors may need to be taken out and cleaned or replaced by a mechanic.
How do you diagnose a golf cart problem?
There are a few simple problems that you can fix yourself that will not necessitate professional maintenance.Test the wall socket where you charge your cart. ... Expose your golf cart batteries. ... Test the batteries for voltage. ... Replace dead batteries. ... Expose the motor for inspection. ... Reset the motor. ... Test the cart.
Where is the reset button on a Club Car golf cart?
Expose the motor (you'll probably need a screwdriver to remove the cover), and look for a red button. It is usually near the main power source, where most of the wires are connected. Once you've pressed the button to reset the motor, reassemble the cart, charge up the batteries, and give it a test run.
How do I know if my golf cart solenoid is bad?
If your golf cart fails to turn on when you turn the key on, this is the most obvious sign of solenoid failure. The solenoid clicks a little with the ignition system in regular operation; in most cases, a failing solenoid will not snap.
How to Increase your golf cart speed?
Are you looking to increase your golf cart speed? Learn more about how to make your golf cart go faster.
What is an ampacity controller?
The Ampacity controller is a part of your cart that helps to manage the amperage that produces and uses as your cart drives. When this particular part malfunctions, you're going to run into some issues with your cart operation.
Why is my Ampacity controller not working?
Usually, this issue arises when the controller has not been installed correctly. Consult with a professional to ensure that you don't run into any problems. Sometimes repair experts may use aftermarket items that don't fit properly on your ampacity controller and cause it to run poorly or fail and leave you with a cart that runs slow.
Why is a speed sensor important?
The speed sensor is an essential and critical part of golf cart operation that helps to ensure that cart runs smoothly and efficiently. It operates by measuring how fast you are driving and how much electricity is needed to maintain that speed. When the speed sensor ends up running into trouble, chances are your cart may end up running slowly.
What happens if your golf cart speed sensor breaks?
So, it will send less power to your engine and cause it to produce less speed as well as cause accelerator problems in the golf cart .
Why is my golf cart slow?
Usually, the most common reason golf carts slow down is when they don't get enough power output from the battery. If the battery pack charge is very low and your cart is out of power, your cart will run slow.
What does it mean when a golf cart doesn't produce enough power?
Inspect the battery connections throughout the golf cart. If it doesn't produce this much power, then it indicates the battery is not outputting properly.
Why is a golf cart controller important?
From being able to change your golf cart's speed to manage all the electrical components perfectly, the controller is an important element of your cart. You could say the controller is the heart of your cart. A properly selected and maintained controller will allow the vehicle to operate smoothly and safely. Learn more about your Club Car speed ...
Why won't my golf cart run?
If your controller is damaged, your cart won't run. However, a few other reasons could lead your vehicle to stop running. Since the speed controller is the heart of your electric golf cart, you need to make sure that the problem is not something else first. Following is a list of things to check before you troubleshoot the speed controller.
What to do if your golf cart doesn't start?
If the cart doesn't start, check the solenoid. If the solenoid is working fine and allowing power to flow, then you can begin inspecting the controller. Learn more about symptoms of a bad golf cart solenoid. If all the components are working well, the next step is to check the speed controller.
How to start a golf cart when it's dead?
Start with batteries and make sure they are working properly. If your batteries are dead, your golf cart will not start. Charge your batteries completely, and then try to drive the cart.
What is the function of a speed controller on a golf cart?
Following are some of the primary functions of the speed controller: Limiting Motor Current – Protects the motor and controller from damage in case of stalling and overloading. Limiting Battery Current – Managing current drawn from the battery ...
What is a club car controller?
The Club Car controller is also known as a speed controller, and the best thing about the controller is that it works as a brain and speed control system for the golf cart.
What is a programmable controller?
Programmable Controller. The programmable controller can easily be configured for the needs of your cart. This controller's most significant and important advantage is that programmable controllers produce 60% less heat than other controllers.
How to troubleshoot a golf cart?
GOLF CART CONTROLLER TROUBLESHOOTING 1 Make sure it isn’t your batteries! If your batteries are old and dead, then your golf cart will not operate. Charge them fully first and attempt to drive the unit. 2 If your batteries are fully charged and your vehicle won’t run, when you press on the accelerator pedal, then you should hear a clicking sound which will indicate the solenoid is engaging and allowing power to flow to your controller. If there is no distinct clicking sound, then check your solenoid. Also, it could have to do with something in the accelerator device as well. But, we can eliminate the controller as being defective. 3 If your batteries are fully charged and you get a clicking sound ensuring the solenoid is allowing power to flow to the controller, then you can begin inspecting the controller 4 Check all the wiring and signs of disconnection or damage. Also, most controllers will have an operation light that will begin to flash a morse code that will unveil the secrets of the problem. If that is the case and all of the above have been eliminated, then you are getting closer to determining it is the controller.
What is the advantage of a programmable controller?
The key advantage of this controller is that; programmable controllers produces 60% less heat than other controllers. Programmable controllers are epoxy potted or in other words Club Car controller troubleshooting, which let controller failure due to the vibration and water corrosion get easily eliminate.
Why won't my club car run?
Due to their expense, you want to be sure your controller is the major reason and problem with your Club Car. First off, if your controller is bad, your vehicle won’t run. However, there are other reasons that could lead to your vehicle not running. Here are a few quick troubleshooting tips.
Why limit current to motor?
Limiting the current to the motor so that both motor and the controller could be protected in case of motor stalling and overloading.
What does it mean when there is no controller?
When there is no controller, it means batteries drainage is at its peak, as motors can operate independently at their high speed, which would gradually increase stress on the mechanical and electrical components and let motors and batteries degrade quicker.
How to tell if a controller is bad?
Check all the wiring and signs of disconnection or damage. Also, most controllers will have an operation light that will begin to flash a morse code that will unveil the secrets of the problem. If that is the case and all of the above have been eliminated, then you are getting closer to determining it is the controller.
How does a club car controller work?
In this way, today’s modern speed controller’s meters out the battery voltage and current to the Club Car motors on the basis of numerous input parameters such as; throttle, brakes and twist grips. Hence, the operator of the Club Car would be able to control the speed at which Club Car is moving by the way of acceleration and deceleration cycles. Following are some of the main functions of the controller, irrespective of the type of the motor:
Carburetor
More often than not, golf cart backfiring is caused by the throttle plate inside the carburetor being slightly open. This allows fuel to flow into the cylinder before the ignition system is activated to produce a spark for combustion.
Accelerator Cable
In almost all cases, whether it is a 2 cycle or 4 cycle engine, golf cart backfiring is caused by the accelerator cable being out of adjustment at the throttle plate of the carburetor. This problem has a relatively simple cure.
Adjustment
For proper symbiosis between the fuel and ignition systems, the accelerator micro switch must click BEFORE the throttle lever of the carburetor moves. The accelerator cable may move through the plate, but the plate itself cannot move prior to the micro switch click.
Why does my Club Car golf cart jerk when taking off?
Your Club Car golf cart jerks when taking off, because of a faulty MCOR or low battery charge. Wiper arms that are adjusted incorrectly can also cause a golf cart to jerk.
Why does my Club Car DS shake when accelerating?
Your Club Car DS may shake when accelerating because of an overly tight drive belt or a clutch issue. Sometimes, this problem happens when the carburetor fails to mix the fuel properly.
How to fix club car precedent?
You can fix a Club Car Precedent that jerks when taking off by checking and fixing the MCOR and batteries. These are the two key parts that often cause the jerking action.
Why does my club car jerk in reverse?
Your Club Car golf cart jerks in forward and reverse due to a sticky drive clutch or a high gear solenoid problem. A missing cable between the resistor and the forward/reverse selector can also cause the jerking in both directions.
How to fix jerk on 1985 club car?
If you have a 1985 Club Car, the jerk can be curbed by doing a high gear solenoid replacement. The solenoid will be in ON position when the cart moves both in forward and reverse directions. This solenoid is present on the passenger side of the golf cart.
How to fix a club car DS that jerks when taking off?
You can fix a Club Car DS that jerks when taking off by correcting the oil level. The following steps help to solve the jerking in 1988 lifted Club Car DS. Check the oil level of the golf cart and do a refill if needed. There is no need to overfill the oil. It’s enough if you fill it to just the required level.
How to fix jerky acceleration on club car?
One way to fix the jerky acceleration on a Club Car golf cart is to check if the battery charge is dropping and the battery is nearly dead under load. A load test will help you determine this. If recharging the batteries doesn’t help, getting a new battery or new batteries fitted should work.
How Do I Clean The Carburetor To Stop Backfiring On My Golf Cart?
Cleaning the golf cart carburetor will require you to obtain a rebuild kit, or at the very least, a gasket kit. The gaskets and seals will not re-compress properly if you try to reuse them. If you buy a kit online, specify the year and make of your golf cart and make sure that it includes the main jet and gaskets required to finish this job.
How to adjust a golf cart?
Adjustment is made by loosening the nut or screw, pressing the throttle closed, and then retightening the nut. Some golf carts may not have accelerator cables but instead will have a series of rods between the gas pedal and the carburetor.
What happens when the throttle cable is out of adjustment?
When the throttle cable is out of adjustment, the throttle plate never completely closes, allowing unburned gasoline to accumulate in the exhaust system before the spark plug fires. Here are a few tips for adjusting your golf cart engine to keep it from backfiring.
Why is my throttle plate not closing?
If none of these accelerator cable adjustments solve the problem, then the throttle plate may not be closing all the way due to an obstruction or internal mechanism being bent. Unfortunately, the only way to find out if this is true is to remove the carburetor and inspect it.
How to uncook a muffler?
It sounds crazy, but the common method of un-coking a muffler is to remove it from the cart and barbecue it over a fire for about half an hour. This will burn off all of the debris inside the muffler and turn it to ash.
How to clean a carburetor?
(it might be a good idea to take a picture of it with your cell phone.) Using a can of carburetor cleaner, spray all the ports and jets thoroughly. Use a bristle brush to remove the heavier deposits inside the fuel bowl and outside the carburetor body.
What is the ignition system on a golf cart?
Older golf carts used a set of points and a condenser to produce the spark needed to run the engine, but the more modern carts have a solid-state ignition system . The solid-state system utilizes an internal magnetic pickup device inside the engine that sends an electrical signal down the line to the igniter.