Full Answer
What are the terminals on a golf cart motor?
Working on a golf cart motor. Terminals are A1, A2, F1 and F2. I have continuity between A1 and A2 and between F1 and We use cookies to give you the best possible experience on our website.
Where is the tow/run switch on a golf cart?
Does the Golf Cart have a Tow/Run switch or Run/Maintenance switch? This would be under the seat. If the cart DOES have this switch, it is a Regen (Regenerative Braking) cart. If there is NOT a switch, then its a Series cart. 2. Series Vehicle Features 3. Does the motor have a speed sensor wire protruding from the end head?
What does A1 A2 and F2 mean on a motor?
Sepex or Separately excited motors are almost always marked A1, A2 and F1, F2 The F stands for field and that also is the stationary windings in the motor. You must log in or register to reply here.
What kind of motor does a golf cart have?
Most of the modern-day carts are equipped with a Sepex motor. The advantage of the SePex motor is that they prevent the cart from freewheeling down an incline and over-spinning the armature.
What are the 4 terminals on a golf cart motor?
If you're unsure if it is working, it is simple to test. There are four terminals on a solenoid: usually two large and two small. The small terminals are connected to the battery, and the large terminals are connected to the motor. Disconnect all wires from the two large terminals.
Where is the reset button on a golf cart motor?
First, you'll want to reset your motor. It should have a small reset button (Usually it will be red) located near the main battery supply. Hit the reset button and then put the cover back on the motor. The next step would be to recharge your cart and try turning it on again.
How do you hook up an electric golf cart motor?
3:315:58EZGO RXV Golf Cart Motor Removal & Installation How-To - YouTubeYouTubeStart of suggested clipEnd of suggested clipKeep the gap between the motor and the transaxle evenly spaced when tightening the bolt. First we'reMoreKeep the gap between the motor and the transaxle evenly spaced when tightening the bolt. First we're going to run our main drive wires back to the front of the golf cart and the controller.
Do all golf cart motors have a reset button?
Electric golf cart motors have a reset button on their chassis which is designed to put your motor back into its original factory state. While it doesn't repair damage that may have occurred to the motor over the years, obviously, it does help to overturn any changes to the operation which may have occurred.
How do I reset my golf cart?
Easily Reset the Club Car Golf Cart OBCKey switch to off.Set forward/reverse to neutral.Put tow/run switch to tow.Disconnect the negative battery terminal from the battery pack.Put the tow/run switch to run.Put forward/reverse switch to reverse.Put key switch to on.More items...
How do you reset the motor on a EZ Go golf cart?
Look in the area where several electrical wires enter the motor and locate a small red button. This is the reset button. Push the button to reset the motor. Put the panel in place and secure it with the screws.
How can I make my electric EZ Go golf cart go faster?
6 Ways You Can Make a Golf Cart FasterAdd More Torque to Your Golf Cart.Upgrade Your Golf Cart's Motor.Improve the High-Speed Controller of the Cart.Add Better Golf Cart Tires.Use a Higher Powered Golf Cart Battery.Watch the Weight in Your Golf Cart.
How do you troubleshoot an electric EZ Go golf cart?
Things to Keep in Mind Before TroubleshootingEZGO golf cart batteries aren't perfect right away.Sticky accelerators are perfectly normal and can be fixed easily.Keep your cart stable.Make sure your charging wall socket isn't faulty.Keep your tire pressure stable.Troubleshooting the speed controller.
How do you test a golf cart motor?
4:0210:28Testing 36 volt golf cart motor with 12 volt battery - YouTubeYouTubeStart of suggested clipEnd of suggested clipYou're going to take the negative. And put it on the a1. Again i'm going to take the jumper cableMoreYou're going to take the negative. And put it on the a1. Again i'm going to take the jumper cable from a2 to s1 you're going to take the positive cable from the jumper.
How do I know if my electric golf cart motor is bad?
You have enough going on in your life without your golf car refusing to start when you turn the key in the ignition. If your golf car won't start, is slower than it used to be, or is experiencing other technical problems, you could have a bad motor on your hands.
Why won't my electric golf cart go forward or reverse?
Check the Forward/Reverse switch of your golf cart for loose connections. If the connections are intact, interchange the top and bottom wires at the rear. If the cart now goes in reverse but not forward, the problem is with the switch. You have to just change the switch in this case.
What would cause an electric golf cart not to move?
Solenoid Wear When there is a disruption in the flow of the electrical current, your cart will not operate. A common reason for current disruption is solenoid wear. Each time the solenoid activates as you press down on the gas pedal, the solenoid compounds down onto a thin metal contact plate.
What does S2 stand for in motors?
Oct 24, 2019. #10. Series motors are almost always marked A1,A2 and S1, S2 S stands for stater and that is the stationary windings of the motor. Sepex or Separately excited motors are almost always marked A1, A2 and F1, F2 The F stands for field and that also is the stationary windings in the motor.
How many turns does a regen cart have?
Usually, the wire is rectanular in shape (cross-section). These coils have a much lower number of turns (usually 5 to 15 turns) per field coil. Note: A Regen cart will normally automatically slow down when you hit approximately 15 MPH going down a hill. This is for safety reasons (as not to over-spin the armature).