Yamaha Carburetors & Parts
| Carburetor, Yamaha G1 2-cycle Gas 83-88 ... | Carburetor, Yamaha G14 4-cycle Gas 94-95 ... |
| Carburetor, Yamaha G16 4-cycle Gas Produ ... | Carburetor, Yamaha G2-G9 4-cycle Gas Pro ... |
| Carburetor, Yamaha G22-Drive 4-cycle Gas ... | Choke Cable Nut, Yamaha G14+ Product ID: ... |
| Choke Cable, Dash Mount 87", Yamaha G2/G ... | Gasket, Manifold to Joint, Yamaha G2-G14 ... |
| Joint, Carburetor, Yamaha G16-Drive Prod ... | Joint, Carburetor, Yamaha G2-G14 4-cycle ... |
Full Answer
How do you adjust the carburetor on a Yamaha golf cart?
How to Adjust Yamaha Golf Cart Carburetor Yamaha G9 Carburetor Adjustment. Pull out the pilot adjustment screw. It must be present at a sharp point and not a flat spot. Rethread the screw back until it’s slightly seated. Turn the screw outwards by 1-1/2 turns. Push the throttle stop screw backward until the throttle shaft is closed completely.
What kind of carburetor does a Columbia golf cart have?
1985 Columbia gas golf cart The cart makes use of a Walbro carburetor with three-line vacuum pumps with connections as follows. One vacuum pump is connected from the gas tank to the fuel pump. The second vacuum pump is connected from the fuel pump to the carburetor.
How to use a Mikuni carburetor on a golf cart?
Flip the choke lever of the Mikuni carburetor from side to side for about half a minute. The cart makes use of a Walbro carburetor with three-line vacuum pumps with connections as follows. One vacuum pump is connected from the gas tank to the fuel pump. The second vacuum pump is connected from the fuel pump to the carburetor.
What are the symptoms of a bad carburetor on a golf cart?
Bad Golf Cart Carburetor Symptoms The engine shows a reduced performance such as a reduction in fuel efficiency or power and sluggish acceleration. The engine starts overheating or backfiring that causes the carburetor to produce a lean mixture with insufficient fuel.
Do Yamaha golf carts have carburetors?
Yamaha Carburetors & Carburetor Parts A carburetor for your Yamaha golf cart will help your cart perform properly as well as replace your gunked up old unit.
Where do you spray carburetor cleaner on a golf cart?
Back the adjustment screw out all the way and set it aside. Spray the carburetor body inside and out with cleaner. Use the tube nozzle on the spray can to clean the jet ports, idle adjustment port and the choke plate. Use the bristle brush to clean dirt and deposits on the body.
How do I adjust the carburetor on my Yamaha golf cart?
How to Adjust Yamaha Golf Cart CarburetorPull out the pilot adjustment screw. ... Rethread the screw back until it's slightly seated.Turn the screw outwards by 1-1/2 turns.Push the throttle stop screw backward until the throttle shaft is closed completely.Turn the screw in by a 1/4 turn.
How do I clean the carburetor on my club cart?
2:1217:47How to Make a Golf Cart Run Better - YouTubeYouTubeStart of suggested clipEnd of suggested clipIf there's some little crevices with gunk in it and so what I do after I take time to clean it is IMoreIf there's some little crevices with gunk in it and so what I do after I take time to clean it is I use some brake cleaner.
How do you clean a carburetor without removing it?
A good way to clean the fuel tank is to start the engine and use a garden hose with a spray attachment to blow the oil out of the tank. Do this until there's no more oil in the tank. Then, while the engine is running, pour some brake cleaner into the tank and use a rag to wipe the bottom.
How do I clean a small engine carburetor without removing it?
Use Carburetor Cleaner Fortunately, you can generally do this without even taking the carburetor out of the engine. Start by purchasing some commercial lawnmower carburetor cleaner, which comes in a simple spray can and will make it easy to clean the inside and outside of the carb.
How do you make a Yamaha gas golf cart go faster?
0:005:15Yamaha G29 Drive Golf Cart Governor Adjustment - MORE SPEED!!YouTubeStart of suggested clipEnd of suggested clipItself by tightening this nut down you're putting more pressure on the spring. So that the governorMoreItself by tightening this nut down you're putting more pressure on the spring. So that the governor has to work harder to pull back on the throttle.
How does a Yamaha golf cart fuel pump work?
The fuel pump has several nozzles on it to accept the vacuum line, and both the Fuel In and Fuel Out lines. Inside the pump, there are several diaphragms which use the pulsing action created by the vacuum of the crankcase pressure to draw fuel from the storage tank and push it onward to the carburetor of the golf cart.
Why does my Yamaha golf cart backfire?
Engine backfiring occurs when there is an air leak within your golf cart or sometimes when there is too much fuel inside. This can cause the piston to slam against the cylinder head and cause a tapping sound. An essential component of any golf cart is the drive belt.
How do you unclog a carburetor?
Make sure carburetor is cool to the touch before cleaning.Dilute cleaner. ... Clear air filter. ... Remove the carburetor. ... Remove carburetor float. ... Remove other removable components. ... Soak and scrub components. ... Rinse and dry. ... Reassemble and replace.
How do you clean a golf carburetor?
0:1410:06GOLF MK1.HOW TO SERVICE & CLEAN A CARBURETOR.KEIHIN ...YouTubeStart of suggested clipEnd of suggested clipNext you need to just remove your airbox. So that you can be clear with your carburetor to work on.MoreNext you need to just remove your airbox. So that you can be clear with your carburetor to work on. And then you remove everything that is attached to the carburetor. Like your cables.
Is it hard to clean a carburetor?
But the good news is carbs are relatively easy to clean so the task should be near the top of your 'jobs to do' list if your bike is playing up. Problems generally arise because carbs rely on fuel going through very small holes, which can be easily blocked by gunk.
How to adjust carburetor on golf cart?
In most cases, you’ll need to adjust the jet pilot screw, perform a valve clearance adjustment and then clean the carburetor.
How to replace carburetor float?
Remove the carburetor and turn it upside down. Remove the nut that is used to secure the bowl on. Check the float for a puncture as this prevents the activation of the fuel cut-off needle valve. Replace the float if there is a puncture. Check for dirt accumulation in the needle valve.
Why does an EFI carb require more maintenance than an EFI?
The carb requires more maintenance than an EFI because of the cleaning and rebuilding of the carburetor involved.
Why does my carburetor flood on my golf cart?
The reason why a carburetor floods on a golf cart is usually due to a faulty fuel pump. The pump must be repaired or replaced accordingly. Seek professional assistance if required. This is usually due to the proximity of the fuel line to an exhaust manifold, a radiator hose or a heat source.
How to cool down a golf cart?
Procedure. Turn off the golf cart engine and allow it to cool for a couple of hours before you start working. This cooling down prevents damage to the cart and injury to yourself when you’re at work. Turn off the fuel-supply valve and remove the fuel line to prevent flooding of the fuel and other complications.
Where is the main jet on a 2 cycle engine?
The main jet in the carburetor diagram of a 4-cycle engine is located below the carburetor while the pilot jet is present on top of it. The needle valve and float pin are also housed under the carburetor.
How to remove cable from carburetor?
Remove the cable from the carburetor and cover its sheath opening using duct tape. To do this, make a small funnel with the tape and ensure that the wire sticks out from its middle. Loosen the nut that fixes the cable on to the mount housed on the motor just before its entry into the carburetor.
