Where can I buy resistor speed control parts for my golf cart?
Resistor speed control parts are available for your next golf cart repair project when you shop online at Blockbuster Golf Cars, Inc. Our business sells a variety of high-end club car golf cart parts for your needs, including golf cart speed controller and resistor selections.
How do you test the coil on a golf cart?
Testing the coil on a golf cart is required due to a bad ignition coil or a problem that may run deep in the engine. Coils are intrinsic to every golf cart and the ignition system powers the spark plugs. Locate the ignition coil in the golf cart by getting the seat of the golf cart raised to, as would be mentioned in the owner’s manual.
What kind of resistor coil does club car use?
Club Car AFTERMARKET 36-Volt Resistor Coil Standoff. Fits ALL Electric Models 1989 to 2003. PART # 6755 Club Car Factory Genuine OEM 36-Volt Resistor Coil Standoff for ALL Electric Models 1989 to 2003. PART # 2125156-OEM
Is there an OEM 36 volt resistor coil standoff?
Club Car Factory Genuine OEM 36-Volt Resistor Coil Standoff for ALL Electric Models 1989 to 2003. PART # 2125156-OEM Club Car DS Electric Resistor Mounting Bracket. PART # 781
What is a resistor coil on a golf cart?
Resistor Coils battery voltage as heat allowing just a portion of available battery voltage to actually get to the motor.
What does the resistor do on a golf cart solenoid?
Its purpose is to maintain the capacitors within the controller at the battery pack voltage so that when the contactor closes, no arcing occurs. Resistor value is determined by battery pack voltage.
Where is the solenoid located on an electric golf cart?
0:095:38Replace Solenoid in Golf Cart - YouTubeYouTubeStart of suggested clipEnd of suggested clipCart um your solenoid could be located in a bunch of different places but almost always underneathMoreCart um your solenoid could be located in a bunch of different places but almost always underneath the seat.
How do you test a 48v solenoid on a golf cart?
Set your multimeter to ohms and insert a probe on each large terminal with the key off and the cart direction switch in the neutral position. Press on the accelerator with the cart's movement control in the forward position, and the key is turned on. A click should be heard first from the solenoid.
How do you test a golf cart resistor?
Place the (+) probe to the controller side of the solenoid's large post. With the resistor in place the reading should be 0.1 to 3 volts less than battery voltage. If the reading is more than 3 volts less the battery voltage, the resistor is faulty.
Do solenoids need resistors?
The resistors, capacitor, and diode are unnecessary. The solenoid coil is rated for 24V, so it will operate at approximately that voltage with no additional resistors needed to drop voltage and/or limit current. The diode would typically be used to protect an active switching device from inductive kickback.
Where is the reset button on a Yamaha golf cart?
It should have a small reset button (Usually it will be red) located near the main battery supply. Hit the reset button and then put the cover back on the motor. The next step would be to recharge your cart and try turning it on again. If it starts up then you're in luck!
How do you test a Yamaha solenoid on a golf cart?
Turn on the engine of the cart and press the pedal downwards. If you hear a clicking sound, then it means that the low side voltage is working. But, if there is no such sound, it means that either there is no low side voltage or there is a problem with the solenoid. Use a voltmeter and engage the solenoid.
How do you bypass the electric solenoid on a golf cart?
Bypassing Golf Cart Solenoid Method If you do decide to bypass the solenoid, this is what you need to do: Take the two larger wires that connect to the solenoid and connect them directly (keeping all safety precautions in place). This should do the trick and if it does not work then the solenoid is not the problem.
What are the symptoms of a bad solenoid in a golf cart?
On an electric golf cart, the most common symptom is the solenoid is not delivering electricity to the controller when the vehicle's ignition is turned on. In normal operating conditions, the solenoid clicks on and off with the ignition switch. A failing solenoid will generally not click.
How do I know if my golf cart controller is bad?
X Common Symptoms of Controller FailureTop Speeds Not Appropriate for Your Cart. Golf carts are designed to reach pretty specific speeds and to not go over them or beneath them. ... Sudden and Unexpected Slowing. ... Shuttering or Shaky Driving. ... Stalling Out and Refusing to Start. ... Surges in Speed When Driving.
Why does my golf cart click but not move?
A Club Car golf cart can start clicking but not move, due to dust accumulating inside the battery ports. Opening the battery ports and checking whether there is any dust accumulation can tell you if this is the case. Cleaning it thoroughly with a cloth can resolve the problem.
Why is my golf cart muffler so congested?
The congestion, apart from making the muffler malfunction, creates several long-term issues. To correct this problem, remove the muffler and heat the inside.
Why is my golf cart not starting?
A bad solenoid could be one of the possible reasons behind a golf cart not starting. If the cart happens to be gas-powered, the engine will not start. If it is powered by electricity, the cart will not move.
Why does my club car get hot?
The solenoid resistor on a Club Car golf cart can get hot because of a faulty speed sensor, faulty solenoid or by using batteries that are too old. Using Old batteries. Faulty speed sensor. Congested Muffler. Faulty speed sensor.
Why does my golf cart make a stuttering sound?
They are mostly found in golf carts that operate on AC motors. If the speed sensor malfunctions, the cart can slow down substantially. When the speed sensor makes a stuttering sound, you know that there is a problem with it. The speed sensor can also malfunction when the magnet inside the golf cart is damaged.
Why do golf cart solenoids get damaged?
These parts can get damaged easily because of various factors like high temperature in the engine. It is imperative to check the pack voltage that is present at the two posts surrounding the solenoid.
How fast does a golf cart go?
A normal club car in good condition is expected to move at a speed ranging from 12 to 15 mph. When your car runs at a speed slower than 8 or 7 mph, you should know that it has a problem that needs to be addressed. Using weak batteries over a prolonged period can result in long-term issues to the engine of your golf cart.
How to check battery health on a cart?
The first thing you could do while checking the health of the battery is to turn around the connector a couple of times. After that, try to start the engine again.
How to keep water out of coil plug?
Put grease on the coil plug as it will keep water out of the reach of the connection. Get the coil slide so that the boot clicks into the spark plug. Get the electrical connection reattached. Move to the next unit till the other coils are replaced.
Why do you need to test a golf cart coil?
Testing the coil on a golf cart is required due to a bad ignition coil or a problem that may run deep in the engine. Coils are intrinsic to every golf cart and the ignition system powers the spark plugs.
Why does my golf cart ignition go bad?
The main cause of golf cart ignition coils going bad is the wearing out due to a bad spark plug ignition cable. When a bad plug is inserted, it will have a much higher resistance value. During such high resistance a high amount of voltage gets generated from the secondary wiring of the ignition coil. The excess amount of voltage ends up creating ...
Why does my ignition coil mat fail?
The ignition coil mat fail due to voltage supply being cut down or overload of the ignition control unit. It can also be due to any sort of mechanical damage to the ignition wires due to a faulty valve cover gasket or oil leakages.
What is the purpose of an ignition coil?
One of the major objectives of an ignition coil is to let a high voltage be induced from a low voltage. There is a laminated iron core which has the task of getting the magnetic field amplified. The primary wiring is connected to the secondary wiring via a connection to the terminal.
Why is my golf cart not starting?
Golf Cart not starting in one go: If you experience that the Golf Cart is not starting in one or two goes, then it is an indication that there may be a failure in ignition coil.
What is the most important thing about a golf cart?
Engine performance issue remains one of the most important concerns. The ignition coils are one of the most important components of an engine of a golf cart. Such issue can compromise the spark which can downgrade the performance of the golf cart.
Where are the solenoids on a golf cart?
In all golf carts, new and old, the solenoids can be found under the seat or in the engine well and are easily identifiable by the wires that lead to them. Banks of heavy duty solenoids, as in the previous illustration, are mounted on the side or back panel near the electric motor.
How to tell if solenoid is bad on golf cart?
The common symptom of a bad solenoid is no clicks when the cart’s ignition is on and you press the accelerator.
Why doesn't my golf cart solenoid click?
This can be a faulty wire connection, but can also mean the solenoid is beginning to fail. The golf cart solenoid doesn’t click when the accelerator is pressed. This again can be faulty wiring or a failed solenoid.
How to test golf cart solenoid?
A diode allows current to run in one direction, but not in the other. Testing the diode is a simple procedure. Remove the diode from the circuit and check the leads with a continuity tester.
How to check if a battery is low?
First, follow these steps: Step 1 – Check the battery voltage from the positive connection to the battery negative. A solenoid uses 12-18volts and low voltage will not activate the solenoid. Step 2 – If the voltage is low, check the cable ends for corrosion. Clean and charge the battery.
How to tell if a golf cart won't start?
The first and most obvious symptom is the golf cart won’t start. If it is a gas-powered cart, the engine doesn’t turn over, and if it is an electric cart, the cart doesn’t move. Now, on to the next symptoms…. The engine on the gas-powered cart starts, but the starter doesn’t disengage after starting.
What to do if your solenoid is not zero?
If the reading is not zero, then the solenoid is stuck and needs to be replaced. If the ohmmeter does read zero, set the cart to forward travel and turn the key switch on. Press the accelerator pedal (or have a friend do it) and you should hear a click. If you don’t hear a click, measure the resistance anyway.