There is an easy method to check the electric motor on any EZ-Go golf cart. Go to the back of the golf cart and find the panel that covers the electric motor. Four or six screws will hold the panel in place.
Full Answer
How do you test the motor on a golf cart?
How to Test a Golf Cart Motor. 1 Step 1 - Test the Source of Power. Before you check the motor itself, first test the source of the power: the wall socket where you charge it. Take a ... 2 Step 2 - Check the Batteries. 3 Step 3 - Uncover the Motor. 4 Step 4 - Detach the Wires. 5 Step 5 - Check the Terminals.
Where is the motor located on a golf cart?
Finally, its time to check the motor itself. This will be located under a panel, usually at the back of the cart. This panel will be held on with four screws, so just make quick work of them with your screwdriver, and set everything aside in a safe place on a towel.
How do you replace an electric motor on a golf cart?
Go to the back of the golf cart and find the panel that covers the electric motor. Four or six screws will hold the panel in place. Use the screwdriver to remove all the screws, turning them counterclockwise and putting them in a secure location after removal. Remove the panel so the electric motor is visible.
How do I know if my electric golf cart is bad?
Electric golf carts are usually trouble-free and do their job efficiently and with no fuss, but sometimes you suspect your golf cart is experiencing a problem. If the speed seems to be off, or your cart gives off a burning wire smell, your golf cart motor might have a problem.
How do I test a electric golf cart motor?
Connect the positive jumper cable to the positive battery terminal on the 12-volt battery. Touch the other end of the positive battery cable to the A2 terminal on the electric motor. Once the positive battery cable touches the A2 terminal, the motor should start turning and the rear wheels should start turning as well.
How do I know if my electric golf cart motor is bad?
You have enough going on in your life without your golf car refusing to start when you turn the key in the ignition. If your golf car won't start, is slower than it used to be, or is experiencing other technical problems, you could have a bad motor on your hands.
How do you test a club car 48v motor?
3:1615:0248 Volt Club Car Diagnostics - YouTubeYouTubeStart of suggested clipEnd of suggested clipThe 48 volt club car has a computer here that controls the input from the charger to the batteries.MoreThe 48 volt club car has a computer here that controls the input from the charger to the batteries. And also the the drain that the motor is allowed to put on the batteries.
How do you test a golf cart motor controller?
How to Test a Club Car Golf Cart Speed Controller? The simplest test to ascertain your golf cart controller's performance is to to watch whether it runs when the batteries are fully charged with a slight push of the pedal. If you hear a distinct clicking noise, then your golf cart is running correctly.
How do you reset a golf cart electric motor?
First, you'll want to reset your motor. It should have a small reset button (Usually it will be red) located near the main battery supply. Hit the reset button and then put the cover back on the motor. The next step would be to recharge your cart and try turning it on again. If it starts up then you're in luck!
How long do electric golf cart motors last?
Golf Cart Motor Just like solenoids (mentioned above), your golf cart motor works HARD. When properly taken care of, the typical gas or electric golf cart motor can last many, many years (20 to 30+).
How do you test a 48v solenoid on a golf cart?
Set your multimeter to ohms and insert a probe on each large terminal with the key off and the cart direction switch in the neutral position. Press on the accelerator with the cart's movement control in the forward position, and the key is turned on. A click should be heard first from the solenoid.
How do you troubleshoot an electric golf cart?
There are a few simple problems that you can fix yourself that will not necessitate professional maintenance.Test the wall socket where you charge your cart. ... Expose your golf cart batteries. ... Test the batteries for voltage. ... Replace dead batteries. ... Expose the motor for inspection. ... Reset the motor. ... Test the cart.
Where is the reset button on a Club Car golf cart?
Identify your main battery supply (usually the largest battery) on your motor. Check around this supply for a small red button that may or may not be labeled “Reset”. Press and hold this button for a few moments and then release it to reset the motor.
How do I know if my golf cart controller is bad?
X Common Symptoms of Controller FailureTop Speeds Not Appropriate for Your Cart. Golf carts are designed to reach pretty specific speeds and to not go over them or beneath them. ... Sudden and Unexpected Slowing. ... Shuttering or Shaky Driving. ... Stalling Out and Refusing to Start. ... Surges in Speed When Driving.5 Symptoms Of Bad Controller On Golf Cart (Fixes)https://www.golfcartreport.com › symptoms-of-bad-contr...https://www.golfcartreport.com › symptoms-of-bad-contr...
Where is the speed controller located on a Club Car golf cart?
The speed sensor in a Club Car Precedent golf cart is located on the back of the motor. To remove the sensor, unplug the cables behind the motor. You can use a 5/16-inch socket to remove the pigtail connector and pop off the plastic housing that encases the speed sensor.How to Test a Golf Cart Speed Sensor (Bad Sensor Symptoms)https://www.golfstorageguide.com › how-to-test-golf-cart-...https://www.golfstorageguide.com › how-to-test-golf-cart-...
How do you test a solenoid on a electric golf cart?
Set your voltmeter to the ohms reading, and connect its probe to each one of the big terminals. Of course, the reading should be zero. Next, move the cart's switch to forward, turn it on, and accelerate slowly. Your solenoid should click.5 Symptoms of a Bad Solenoid on a Golf Carthttps://www.golfcartsforsale.com › blog › 5-symptoms-of...https://www.golfcartsforsale.com › blog › 5-symptoms-of...
What to do if your motor has an S terminal?
If your motor has an S terminal instead of an F, then test the S-1 to the A-1 terminal to make sure there is no continuity. Then, test the S-2 terminal, to the A-1 terminal for no continuity. These continuity tests will help you determine where the problems with your motor lie.
How to check if a battery is working?
Insert the screwdriver into the slot on a clamp and turn counterclockwise to remove it. Repeat this step with the other clamp. Then, test the voltage of the battery by touching each side of the wires to your 12-volt tester. This needs to be done to check all the batteries, as even one not working can cause your motor to malfunction. Don’t forget to remove the clamps before testing the other batteries as well. If at any time the tester shows less than 12 volts, the batteries need to be replaced.
How To Tell If Your Electric Golf Cart Motor Is Bad
Even the most well-maintained golf car will have technical problems eventually. Still, it’s rather unfortunate if the problem is with your motor or engine. You have enough going on in your life without your golf car refusing to start when you turn the key in the ignition.
Test Your Batteries
When your golf car doesn’t start, it’s tempting to jump straight to the perceived problem area: the motor. But the issue could be a simpler one concerning another part of the car. Before checking its other parts, test the voltage of your batteries to make sure they’re working.
Check the Solenoid
If your batteries are charged and in working condition, but your car still won’t start, check its solenoid. A solenoid is an electromagnetic coil of wire that transmits energy from your car’s battery to its motor to help it start. Every time you start your golf car, you should hear the click of the solenoid.
Examine the Potentiometer
If your car still won’t start or you notice any issues with acceleration, it’s time to check the potentiometer. The potentiometer sends an electric signal from the accelerator pedal to the speed controller, allowing the car to accelerate properly.
Check the Motor Itself
If you’ve checked all the above parts and none of them are responsible for your trouble, inspect the motor of the golf car itself. Sometimes, the issue can be resolved by simply resetting the motor. To reset your golf car’s motor, open the hood to expose your motor and look for the red reset button.
How to remove electric motor from golf cart?
Go to the back of the golf cart and find the panel that covers the electric motor. Four or six screws will hold the panel in place. Use the screwdriver to remove all the screws, turning them counterclockwise and putting them in a secure location after removal. Remove the panel so the electric motor is visible.
How to reset an electric motor?
Look in the area where several electrical wires enter the motor and locate a small red button. This is the reset button. Push the button to reset the motor. Put the panel in place and secure it with ...
Is the battery on an EZ Go golf cart charged?
Warnings. Be certain that the battery is not being charged before you begin working on any EZ-Go electric golf cart. Be certain that the battery is not being charged before you begin working on any EZ-Go electric golf cart.
How does an electric club car work?
Electric-powered club cars come equipped with a series-wound electric motor that turns the wheels forward or in reverse. The current from the battery pack flows through the wiring inside of the motor to produce the electricity needed to operate the car.
How many wires are in an electric motor?
The electric motor will have four wires connected to the top front. Each of the four battery wire posts are marked A1, A2, S1, S2. Mark each wire with the proper post number with a piece of chalk before removing the wires from the motor.
What is a club car?
by Kevin Mclain. A club car is an electric-powered utility vehicle that is mainly used as a golf cart. Club cars can also used to move people more efficiently around places where regular vehicles will not fit.
