
Full Answer
Why is my golf cart heating up so fast?
If the motor of your golf cart is relatively old, then there are chances of carbon dust getting accumulated on both its brushes and interior. This can lessen the motor’s efficiency, thereby causing a strain on the battery cables and heating them. Get your golf cart’s motor cleaned from time to time and keep it dust-free as far as possible.
Why do my golf cart batteries feel warm?
It’s quite normal for golf cart batteries to feel a little warm while in use or during charging. This comes as no surprise as a large amount of energy is being transferred when using your golf cart.
How do I know if my golf cart switch is bad?
When the switch is in the reverse mode you get only a buzzer sound. The cart moves forward even when the switch is in the neutral position. Not getting the best speed while in the forward position. Sometimes you may even notice a burning smell that can be due to overheating.
Why won’t my golf cart move?
The golf cart will not move even if one of them is damaged. If the solenoid heats up too much, the vehicle will not move. A bad solenoid could be one of the possible reasons behind a golf cart not starting. If the cart happens to be gas-powered, the engine will not start. If it is powered by electricity, the cart will not move.

Why are golf cart batteries hot?
Golf cart batteries may also get heated up due to low water level in the battery. You should regularly check the water level to maintain accurate balance in the battery. Often, a mark on the tank designates the amount of water required in it.
Do electric golf cart motors get hot?
One of the big reasons your golf cart could quit on you is that your motor burnt out. Motor burnout happens when your engine gets too hot and overheats, frying the wiring and other components inside.
What does a reed switch do on a golf cart?
Reed Switches are used to prevent cart operation with the charger plugged in. They have become increasingly expensive and they are very fragile. this component is used to eliminate the reed switch from the electrical system.
How hot should a golf cart motor get?
How hot should a Yamaha golf cart motor get? Generally, a temperature of 170ºF is considered reasonably safe for your Yamaha golf cart motor. If the temperature exceeds 250ºF this indicates a serious problem.
How do I know if my electric golf cart motor is bad?
You have enough going on in your life without your golf car refusing to start when you turn the key in the ignition. If your golf car won't start, is slower than it used to be, or is experiencing other technical problems, you could have a bad motor on your hands.
Why is the positive terminal on my 48 v Club cart getting hot?
Loose or dirty connections This results in overheating and eventually melting of the terminals. If it is a loose connection that is the problem, set the connection right by tightening it up immediately. Alternatively, if you notice dust or dirt on the terminals, wipe it off with a damp cloth and clean the terminals.
How do you test a golf cart switch?
Testing a Club Car Ignition SwitchFind the back and red wires on the back of your battery pack.Connect the black wire to the negative terminal and the red to the positive.Keep the cart turned off while you work on it.Check the wires with a probe meter while the cart is off – only one wire should have a charge.More items...
How do I bypass the reed switch on my EZ GO?
0:221:131995 36V EZGO Golf Cart Reed switch bypass - YouTubeYouTubeStart of suggested clipEnd of suggested clipSo some form said that the reed valve can be bypassed and that seems to be a pretty common issue.MoreSo some form said that the reed valve can be bypassed and that seems to be a pretty common issue. And here's the charger here and the front I've already taken off the panel and loosened it.
How do you bypass a micro switch on a golf cart?
You can bypass the reed switch in an EZGO golf cart by connecting the red wire of the reed switch to the white wire from the charger receptacles and to the red wire from the FRN micro switch.
How long do electric golf cart motors last?
Golf Cart Motor Just like solenoids (mentioned above), your golf cart motor works HARD. When properly taken care of, the typical gas or electric golf cart motor can last many, many years (20 to 30+).
How many miles can you put on a golf cart?
The primary deal breaker we are told: range. How far will I be able to travel? Depending on the manufacturer, most gas golf carts have between a 5 and 6 gallon gas tank and get about 40 miles to the gallon. Electric golf carts with fully charged batteries in perfect condition get about 35 miles to the full charge.
Do all golf cart motors have a reset button?
Electric golf cart motors have a reset button on their chassis which is designed to put your motor back into its original factory state. While it doesn't repair damage that may have occurred to the motor over the years, obviously, it does help to overturn any changes to the operation which may have occurred.
Why does my golf cart get hot?
If you find a particular cable getting hotter than the other cables, check for the connection made with that cable. A bad or loose cable connection can cause it to get hot.
Why does my golf cart battery melt?
The main reason why golf cart battery cables will melt is because of too much current passing through the jumper cable; resulting in overheating and melting. A poor contact connection or a missing ground strap between the chassis and the engine may also result in the melting of your golf cart battery cables. Alternatively, corrosion of either of ...
What happens if a golf cart battery leaks?
If you have a leaking battery, then corrosion is inevitable and it will affect the battery terminals. This will eventually seep into the posts and melt them. Check out for a battery terminal protector from your golf cart parts store. This is usually available in the form of a spray.
What causes a cable to overheat?
Excessive internal resistance. The internal resistance of the cables used to connect to the terminals may be very high, leading to overheating followed by melting. Check the resistance of the cables with the help of an ohmmeter. The resistance between both ends should ideally be zero or as negligible as possible.
What causes a battery to melt down?
A stalled motor can cause the terminals of a battery to have a meltdown. It happens when a motor receives enough power to get started but it fails to turn. This is common when the cart is over a steep incline or a curb. It may be time to charge your battery and replace the melted terminals with new ones.
Why do the bolts on my cable terminals melt?
The bolts on the terminals often melt because of excess heat and even tend to break. When this happens, the terminals are also affected. One main reason for the heat generation is a corroded connection. This corrosion increases the cable resistance and thereby the heat, which leads to melting.
What happens when two cables touch each other?
Short circuit or fused connection. Two cable ends that accidentally happen to touch each other can result in a short circuit or a fused connection. Remove the shorted cables and use new cables to reestablish the proper connection between the terminals.
