Golf-FAQ.com

why does my 1998 gas club car golf cart buck and jump on take off

by Dr. Janelle Emmerich Published 2 years ago Updated 1 year ago
image

Your Club Car golf cart jerks when taking off, because of a faulty MCOR or low battery charge. Wiper arms that are adjusted incorrectly can also cause a golf cart to jerk. Faulty MCOR.

Causes of jerky Gas golf carts:
Damage to the primary clutch weights can cause jerks while accelerating your golf cart. 2] Dust and other dirt settled in the clutch can also cause jerks. So, make sure that you clean your golf cart regularly to avoid such situations.

Full Answer

Why does my club car golf cart Jerk when taking off?

Your Club Car golf cart jerks when taking off, because of a faulty MCOR or low battery charge. Wiper arms that are adjusted incorrectly can also cause a golf cart to jerk. Faulty MCOR. Low battery charge. Wiper arms and contact out of adjustment. Clutch problem.

Why does my golf cart keep running but not shut off?

1994 Club Car golf cart keeps running This kind of problem with shutting down can occur in both gas and electric golf carts. There are different reasons why it can happen; some of them are discussed below: May be the starter is still operating because the spring, which pulls back the pinion to the rest pose, is not doing its job correctly.

Why is my golf cart spitting gas?

Your car spitting gas could be caused by a few things such as a jumping timing belt or a stuck valve. Firstly, it could be a timing issue. As mentioned before, if your timing belt jumps, your cart might spit gas.

What are the problems with a club car golf cart?

The problems with a club car golf cart appear when either the OBC or the solenoid is not functioning correctly. OBC regulates the car’s batteries’ charge, and the solenoid supplies the electrical current from the battery to the entire vehicle. Resetting the OBC should solve the problem but if not, check whether the solenoid is okay.

image

What causes a golf cart to jump?

Jerking electric golf carts are probably more common than a jerking gas model. That's because most “jerking” concerns are caused by battery issues or a poor flow of electricity from the battery to the cart. Typically, you'll start to notice this problem when your cart needs to charge up.

How do you stop a golf cart from bouncing?

You can easily take care of this problem by deflating your front tires until the sidewalls of your cart are about 1/2 the front walls. This should help get the beads seated. Now, you can inflate your tires back. The bounce should have disappeared.

How do you fix jerky in a golf cart?

One way to fix the jerky acceleration on a Club Car golf cart is to check if the battery charge is dropping and the battery is nearly dead under load. A load test will help you determine this. If recharging the batteries doesn't help, getting a new battery or new batteries fitted should work.

Where is the speed sensor located on a Club Car golf cart?

The speed sensor in a Club Car Precedent golf cart is located on the back of the motor. To remove the sensor, unplug the cables behind the motor. You can use a 5/16-inch socket to remove the pigtail connector and pop off the plastic housing that encases the speed sensor.

How can I make my golf cart more stable?

Drop Spindle kits are used to replace and increase the golf cart spindle size and length. This can give your golf cart a wider stance, and increase the stability. The wider stance is perfect for those looking to fit those big off-set wheels on your cart, which in turn, can allow you to add wider and taller tires.

What should the tire pressure be for a golf cart?

15 to 25 pounds per square inchThese tires typically use anywhere from 15 to 25 pounds per square inch (PSI), with the average being 20 to 22 PSI. For golf carts driven off-road or on rougher terrain, it's not uncommon to under-inflate tires to gain additional traction. However, under-inflated tires wear down prematurely.

What causes a gas golf cart to surge?

A golf cart can be surging due to insufficient fuel levels, damaged motor brushes or a vacuum leak. The brushes in the motor are damaged or worn out. The MCOR is malfunctioning or a mismatch between the motor and controller results in torque bumps.

Why does my gas golf cart hesitation?

The main reason why an EZGO Gas golf cart hesitates while accelerating, is because of a dirty carburetor. A dirty carburetor causes this hesitation. Regular cleaning can prevent this problem. Check the rubber boot and clean if you spot any dirt.

Why is my gas golf cart sputtering?

Golf carts can spit and sputter for several reasons, but mainly due to worn out spark plugs or dirty filters inside the fuel system. There might be something wrong with the fuel system of your cart. You could be having a spit and sputter problem because the filter, pump and injectors in your golf cart are very dirty.

How do I know if my speed controller is bad on my golf cart?

When your golf cart's speed controller isn't operating correctly, your cart will show it by running erratically or failing to drive at one constant speed. If your cart starts showing these symptoms, the first thing you should look at is your speed controller.

How do you adjust the governor on a Club Car golf cart?

0:040:46How to remove governor on a Club Car golf cart - YouTubeYouTubeStart of suggested clipEnd of suggested clipYou open up this box lap. Here. It looks up look inside. There's 12 cable down right here this leverMoreYou open up this box lap. Here. It looks up look inside. There's 12 cable down right here this lever you want to lift up and Bend and that pulls on the cable a little more.

How do you test a throttle sensor on a golf cart?

Take a digital multimeter and set it to the volts reading. Place the positive probe of the meter on the white wire terminal of the ITS. Release the accelerator pedal slowly. The reading should be in the 0.45V to 0.53V range when the micro-switch gets activated.

What is a gas club car?

Gas club cars are mostly used for maneuvering rolling hills, rougher terrain, and for transportation of heavy payloads. Here I have mentioned a few troubleshooting steps which can help to shut off your car, and also, they are necessary when you are using the vehicle regularly.

How to turn off a car with a key?

Switch off the car with your key. Set forward or reverse to neutral. Now find out the run or tow switch and put it to tow. If the negative battery terminal is connected to the battery pack, disconnect it. Now put the switch from tow to run and the forward or reverse switch to reverse. Then turn the key switch on.

What happens if the OBC is off?

If the OBC detects any disfunction, it turns off the drive systems or charging system of the vehicle. And if the system starts working correctly, the OBC resets the system, and the car comes back, it’s normal functioning.

How to disconnect a key switch?

First thing first, before starting anything, disconnect the cables from both of the large terminals. After disconnecting the cables , make sure you have wrapper the ends with tape and keep the ends of the cable away from each other. Turn the key switch off. Put the reverse or forward switch to neutral.

Can you fix a 2003 club car golf cart?

There are a few things you need to do to fix the shutdown issue of the 2003 club car golf cart. If your car is new and still facing such problems, then do not worry. It’s just a matter of minutes, as there will be no bigger issues. They can be fixed easily.

Why does my golf cart keep turning off?

When a Golf Car is shutting off without warning, it’s because of low battery voltage, dead batteries, or because the solenoid coil is overheating. Low battery voltage: Sometimes a dip in the minimum voltages of both batteries causes the Golf Cart to turn off randomly. It is best to use a voltmeter and check if the voltages ...

Why does my golf cart cut out?

A golf cart may cut out at full throttle due to a faulty solenoid that needs replacing, or having too low of a battery voltage. Solenoid needs replacing: It may be that the solenoid of the Golf Cart may have developed some glitches due to which it is not responding at full throttle.

Why does my Yamaha G2 keep shutting off?

Yamaha G2 golf cart keeps shutting off: The Yamaha G2 Golf Cart may keep shutting off due to one of the following reasons: Loose solenoid wiring: The first check should be done whether the wiring on the golf cart is in right condition.

How to fix an EZGO golf cart?

The ways to fix a EZGO are stated below: Check the Solenoid contacts: The wires connecting the solenoid may not have electricity flowing due to which the Golf cart is getting abruptly shut off. It is recommended to change the wires connecting the solenoid and check if the problem gets sorted.

What happens if the voltage goes down on a golf cart?

Again, when the voltages go down, it will hit minimum and all the power that is gained shall be lost.

Why is my controller not connecting to the solenoid?

It is advisable to check the connections out there to check if the wires are getting disconnected.

Can you replace solenoid on golf cart?

Replacing the solenoid helps in most cases but it is advisable to get it checked at an authorized service center. Battery voltage is too low: In many instances, the batteries may not be carrying adequate amounts of voltage to keep the Golf Cart in running order. The voltages of the batteries should be checked via a voltmeter to see ...

image
A B C D E F G H I J K L M N O P Q R S T U V W X Y Z 1 2 3 4 5 6 7 8 9