How do I stop my golf cart from overheating?
One way to ensure that your cart doesn't heat up quickly is to install a fan close to the controller heat sink to keep the air circulating around it. You can also install another one near the fender panel just to make sure the cart doesn't overheat. Another option is to upgrade and customise your controller.
What causes a golf cart to suddenly stop?
If the connections from the solenoid have become loose or if there is some other loose contact, the cart might behave in this manner. It can also be caused by a faulty motor or a faulty key switch. If the micro-switch is faulty, it can also cause the cart to suddenly stop midway.
What causes a golf cart to overheat?
One of the most common reasons for the overheating is the dirty fins. The obstruction in the fins leads to excessive heat. The best solution, in this case, would be to first try to clean them, if that does not work, get them replaced. Another common reason for overheating can be the dragging breaks.
What happens if a golf cart overheats?
Motor burnout happens when your engine gets too hot and overheats, frying the wiring and other components inside. One common cause of golf cart motor burnout is continually pressing the pedal to the metal like you're trying to drive a race car.
Why does my electric golf cart stop and go?
A common reason for current disruption is solenoid wear. Each time the solenoid activates as you press down on the gas pedal, the solenoid compounds down onto a thin metal contact plate. Over time, the force of this pressure creates tiny electric arcs on the plates' surface.
How do I know if my EZ GO controller is bad?
Press the accelerator and watch to see if the voltage increases. It should increase from a reading of 0 to the full voltage of the battery. If the motor is not turning, the problem may be in the directional switch or motor. If there is no voltage, the controller is bad and must be replaced.
How do you cool a golf cart engine?
The guys that race (very high speed) electric and also 2 stoke Radio Control boats use water to cool the motors / engines. Try some small diameter copper tube around the outside of the motor, one end is under water facing forward, the other exits behind. Some have the inlet behind the prop and exit above the water.
Where is the reset button on an ezgo golf cart?
Locate the motor Remove the panel so the electric motor is visible. Electric motors usually include reset buttons that can perform similar to circuit breakers. Look in the area where several electrical wires enter the motor and locate a small red button. This is the reset button.
Where is the reset button on a golf cart motor?
The reset button acts as a mini circuit breaker for the motor, so it will correct any minor errors. Expose the motor (you'll probably need a screwdriver to remove the cover), and look for a red button. It is usually near the main power source, where most of the wires are connected.
Is there a reset button on an electric golf cart?
Electric golf cart motors have a reset button on their chassis which is designed to put your motor back into its original factory state. While it doesn't repair damage that may have occurred to the motor over the years, obviously, it does help to overturn any changes to the operation which may have occurred.
How do you know if your golf cart motor is bad?
You have enough going on in your life without your golf car refusing to start when you turn the key in the ignition. If your golf car won't start, is slower than it used to be, or is experiencing other technical problems, you could have a bad motor on your hands.
How long do golf cart motors last?
Golf Cart Motor Just like solenoids (mentioned above), your golf cart motor works HARD. When properly taken care of, the typical gas or electric golf cart motor can last many, many years (20 to 30+).
How do I know if my golf cart solenoid is bad?
If your golf cart fails to turn on when you turn the key on, this is the most obvious sign of solenoid failure. The solenoid clicks a little with the ignition system in regular operation; in most cases, a failing solenoid will not snap.
Why does my ezgo golf cart not move?
The main reason why a EZGO gas golf cart will not go forward is because of a locked up brake, or a faulty solenoid and accelerator. A defective Run/Tow or Forward/Reverse switch can also cause a EZGO to not move forward.