Golf carts can spit and sputter for several reasons, but mainly due to worn out spark plugs or dirty filters inside the fuel system. There might be something wrong with the fuel system of your cart. You could be having a spit and sputter problem because the filter, pump and injectors in your golf cart are very dirty.
Full Answer
Why is my golf cart spitting gas?
Your car spitting gas could be caused by a few things such as a jumping timing belt or a stuck valve. Firstly, it could be a timing issue. As mentioned before, if your timing belt jumps, your cart might spit gas.
Why does my golf cart smoke when I start it up?
How to Fix Golf Cart Blowing Out (White Smoke) White smoke usually means your engine is running hotter than normal. If there’s a bit of smoke when you’re just starting the cart, it might just be the cart warming up. Excessive amounts of white smoke might mean there’s a problem with your cooling system.
Why does my golf cart shake when I stop?
The cause of golf cart shaking may be due to low batteries and dead batteries. For this, you can check the batteries and replace them if possible. If your golf cart’s clutch is in bad condition, it may be cause jerk and shake during the starting and stopping stage.
Why does my golf cart sputter when accelerating?
Golf Cart Sputters when Accelerating. Your golf cart could be sputtering when you accelerate because of your carburetor. There are several things that could be wrong with your carburetor that could cause sputtering. If you’re not getting enough gas to the carburetor, your cart will sputter. This is called a lean condition.
What does sparkly motor oil mean?
The “glitter” in engine oil is just miniscule metal shavings from the engine suspended in the oil. It's not uncommon for new cars to have this glittery look as the engine breaks itself in and fine particles from the machining process are cleared out.
What does gritty engine oil mean?
Oil's color changes as it does its job keeping your engine lubricated. It's normal for oil to appear black in color and a little gritty in texture. The grit in the oil is the buildup of engine sludge. These particles are supposed to build up in the oil instead of getting stuck in your engine.
What does metallic oil mean?
The sudden accumulation of metal shavings within an engine typically indicates accelerated wear of bearings or other reciprocating surfaces. As metal erodes away from these components, it is deposited in an engine's oil, where it collects before being discarded during routine maintenance.
What causes oil foaming?
Foaming is caused by oil degradation or contamination, which is often the result of frying with oil on too high a temperature, overusing the oil or frying with poor quality oil that contains impurities. Oil foaming can be caused by any of these factors and is often a combination of more than one issue.
Can I drive with milky oil?
The bad news is milky oil can be the sign of a leaking head gasket or an even more severe issue, so you should visit a mechanic. To fix milky oil in your engine, the engine needs to be flushed out with flushing oil.
Why is my engine oil milky brown?
Milky brown engine oil is an indication of coolant in the oil. This can be caused by a blown head gasket (or other gasket), a failed transmission cooler, or cracked casings. This condition is very serious and needs to be checked by a professional technician immediately.
Is it normal to have metal particles in oil?
Sources of Metal Flakes in Oil This is a part of normal engine wear. The oil filter is responsible for catching metal flakes, but it can't catch them all. This is why checking and replacing the oil and the oil filter is an important part of regular car maintenance.
Is metal shavings in oil bad?
The good news is it's fairly uncommon for metal shavings to end up in motor oil. The bad new is when it happens, it can shorten the life of your engine, or cause expensive repairs. The engine has many different moving parts.
What do shiny metallic particles in the transmission oil indicate?
If you look into your transmission crankcase and see metal flakes, grimes, fragments, or metal shavings, you should take it seriously. Metal shavings are an indication of friction, wear, or tears on the inner components.
Is foaming oil bad?
In terms of food safety, foam does not indicate a problem with the oil per se. However, it is a sign that the oil has been well-used over time. With age and repeated use, the oil may develop rancid flavors and its structure will break down, leaving it less effective.
How do you stop hydraulic oil from foaming?
Fixing Foaming Hydraulic Fluid One way to deal with the presence of foam is to add an anti-foaming agent to the hydraulic fluid. Anti-foaming agents will usually contain ester or silicone oil. They spread over the surface of the fluid and the foams.
How do I stop foaming?
0:001:36How To Get Rid of Beer Foam Fast - YouTubeYouTubeStart of suggested clipEnd of suggested clipEven your oily nose work in a pinch get a dab of grease on your finger. And swirl it through theMoreEven your oily nose work in a pinch get a dab of grease on your finger. And swirl it through the foam to watch those bubbles disappear.
What gear meshes with the two side gears?
The spider gear also meshes with the two side gears.
What happens when the house of the differential is full of oil?
If the house of the differential is full of oil, the oil will start to come out.
How does the power transfer to the ring gear work?
The power from the engine transfers to the ring gear through a pinion gear. Again, the ring gear is connected to a spider gear. The differential would be a complete waste without the spider gear.
Where is the differential on a golf cart?
Locate the differential from the rear axle part of your golf cart.
How to find out what oil to use on a car?
In case you have lost the manual, you can search on Google with the exact model number to find out the specific oil that you should use on your vehicle.
Why do differentials need lubrication?
But the differential also demands lubrication for better functionality. While transferring engine power to the wheels, the differential needs to make a sudden movement. The friction generated during that movement can deteriorate the condition to a great extent.
Can you change the fuel on an EZ Go golf cart?
Checking or changing the fuel of your EZ-GO golf cart is not a kind of job to fear. You just need to have some decent knowledge about the parts of the cart to ensure convenient processing. Here are the processes you will need to maintain while checking the differential oil of your EZ-GO golf cart-
Why is my Yamaha G1 golf cart shaking?
Yamaha G1 golf cart shaking. The Yamaha G1 golf cart is shaking due to a bad fuel pump, dirty carb, low compression, and bad clutch. To fix the Yamaha golf cart G1, you should check the fuel pump and engine oil of the golf cart G1. Check the quality of your engine and replace it if you have used this for a long time.
Why does my EZGO golf cart shake?
In most cases, the EZGO marathon golf cart shakes while starting due to tire issues, brake issues, and bad suspension. It may be due to excessive water enters into the components and loosely connected wires.
Why does my Ezgo RXV shake?
The golf cart Ezgo RXV shaking issues that occur in your golf cart may be due to worn steering parts, loose lug nuts, and loose wheel bearings. This may be due to brake drums and tires. To fix the issue, check the steerings of your golf cart. If it’s worn, then replace it with the worn steering parts.
Why does my golf cart jerk?
The golf cart may cause a jerk because of the solenoid issues. You need to check the voltage reading (normal range or not) of the solenoid. If the range is more or less than the normal range, then replace this.
How to check golf cart tires?
Check the tire’s height, and both tires need to place in the same position. Remove the tires and clean them if there are any particles stuck in them. Check the engine of your golf cart, steerings, and solenoids. Install a new tire if it needs, and then go for a test driving.
Why does my golf cart shake when starting?
If your golf cart’s clutch is in bad condition, it may be cause jerk and shake during the starting and stopping stage.
How to fix a golf cart?
To fix the issue, you have to check your golf cart’s adaptor and resistor, check all its components, and repair and replace the components that need replacement.
Strut is leaking oil or shows physical damage
Most of the time if a strut is going bad it is because a seal holding the fluid (usually oil) in the shock starts to get old and starts to let the oil escape. This can often be discovered by a simple inspection of the shock. If it appears to be oily, wet or caked with dust and dirt, it is likely that the shock is leaking and needs to be replaced.
Golf cart is experiencing excessive body roll
Excessive body rolling is another indication of a strut going bad. This test can be performed by driving the golf car then turning the steering wheel so that the golf cart is tracing out an “S” pattern.
Bonus tip
If none of these tests or inspections reveal that your shock is bad, you may want to inspect the shock bushings. These are the rubber or plastic bushings at the ends of the shocks and also found where the leaf springs are bolted to the spring plates or brackets.
How to prevent battery spillage in golf cart?
The key to avoiding golf cart battery spillage is simple: avoid over-watering your golf cart batteries. Watering batteries is the act of replacing water that naturally evaporates from within the battery casing, either due to excessive heat or daily use. Water accompanies the acid that facilitates energy storage within your battery, ...
How to maintain golf cart battery?
Here are a few other tips to follow regarding golf cart battery maintenance: Use distilled water: Only ever water your batteries using distilled water. Tap water contains trace salts and minerals that adversely affect your battery’s performance, or cause it long-term damage.
Why does my golf cart leak on the floor?
Why Does My Golf Cart Sometimes Leak on the Floor? If you own a golf cart, chances are, the batteries have leaked acid onto the floor of your garage or patio at some point in the past . This can be an alarming sight, particularly if it’s your first time encountering battery acid.
When to disconnect battery when not in use?
Disconnect when not in use: If you’re not using your battery, unplug it! Disconnecting batteries when they aren’t being used is a great way to preserve their lifespan and ensure that you’re making the most out of your investment in energy storage technology.
When to water battery when charging?
If you water your battery when it’s discharged, when you charge it or use it, the liquid levels will rise and the battery water and acid will spill out onto the ground. To avoid this, only water your battery when it’s fully charged.
Does water evaporate out of a battery?
Water accompanies the acid that facilitates energy storage within your battery, and makes the storage and transfer of energy possible. While water naturally evaporates out of a battery and needs to be replaced, acid does not evaporate. You should rarely, if ever, need to add more acid to a battery. Depending on where you live ...
How to check if a golf cart solenoid is working?
On an electric golf cart, if the solenoid is silent – no clicking – use the setting voltmeter to DC volts using the 200 range. First, turn on the ignition while looking for a reading on the smaller terminals. If nothing is appearing, then press on the accelerator. If the needle doesn’t move, then the problem is not with the solenoid. If it jumps and displays full voltage, then the solenoid is the problem and should be replaced with a new one.
What does it mean when a golf cart solenoid goes bad?
Technically, in fact, a solenoid is a shape – a shape in which the length of something coiled is longer than the diameter of the coils. In engine starters, this refers to the smaller motor ...
Why does my golf cart make clicking sounds?
On a gas golf cart, the most common symptom is the starter failing to engage – so the engine doesn’t turn over – while all you hear a series of very futile clicking sounds.
How to check ohms of a cable?
Once you’ve disconnected the cables safely – using your multimeter – use the voltmeter on the ohms setting and touch each large terminal with the probes with the key turned off. You should get a zero reading.
Why does my solenoid wear out?
Like any switch that relies on wiring, the solenoid could also just wear out due to overheating. This might cause it to fail to retrieve the pinion gear.
What does a solenoid do when you turn the ignition?
Step by step, it looks like this: When you turn the ignition key, a small amount of electricity goes to the solenoid. The solenoid uses that small amount of juice to close two heavy-duty contacts that allows a large jolt of electricity to pass through the starter. The solenoid also sends a pinion gear forward, which is the device ...
Why do starter contacts wear out?
Secondly, the contacts could begin to wear out from overheating or exposure to high levels of current. This needs to be fixed right away if possible, because this causes continuous use of the starter. If not caught in time, the solenoid and the starter will both need replacement.
