Full Answer
How to fix a golf cart solenoid that won’t start?
Connect the two high side large wires to the large terminals of the solenoid. Try to start the golf cart after establishing this connection. If the cart does not start, then it is a clear sign that your solenoid does not have a problem. However, if it does, this does not indicate that the solenoid is the cause of the problem.
Why does my EZGO golf cart stop suddenly?
The main reason why a EZGO golf cart stops suddenly is because of a bad solenoid or low voltage levels causing a thermal cut.
What causes a bad solenoid to go bad?
Another reason for a bad solenoid is that the contacts are beginning to get damaged because of high current passing through them or overheating. This issue must be addressed at once because if neglected the starter can also be affected.
What is a golf cart solenoid and why is it important?
Basically it’s your golf cart’s go switch, and it’s absolutely essential to your golf cart’s ability to do its job. Golf cart solenoids are also typically one of the first components to fail in your golf cart, because they work very hard, turning on and off every time you stop and go in your golf cart.
What causes a solenoid to go bad in a golf cart?
In some cases, this happens because the coil of the battery is worn out or is too old. It can also be a sign of a faulty battery or even loose connections within the solenoid. Additionally, you could be dealing with overheated contacts. This is an issue you need to take seriously.
How do I know if my electric golf cart solenoid is bad?
Press on the accelerator while the key is turned on and the cart is in forward.The solenoid needs to be replaced IF the voltmeter shows a full battery voltage without a click.If your voltmeter stays at 0, the problem stems from somewhere else in your cart.
How do you bypass the electric solenoid on a golf cart?
Bypassing Golf Cart Solenoid Method If you do decide to bypass the solenoid, this is what you need to do: Take the two larger wires that connect to the solenoid and connect them directly (keeping all safety precautions in place). This should do the trick and if it does not work then the solenoid is not the problem.
How do you test a solenoid on a EZ Go golf cart?
This can Also be tested by putting a test lead on each small terminal and pressing the gas pedal. The meter should read 36 V when the gas is pressed. If this voltage does exist when the gas pedal is pressed then the solenoid should click and engage.
What are symptoms of bad solenoid?
As a result, the common signs of a bad starter solenoid include:Engine Doesn't Crank or Start. ... No Clicking Noise When Trying to Start the Engine. ... Starter Spins Without Fully Engaging the Flywheel (Rare) ... Engine Cranks Slowly (Rare) ... Test the battery. ... Check That Power is Getting to the Starter Solenoid.More items...•
Will a bad solenoid click?
A single “click” sound comes from the engine compartment or from under the car. This could mean that the solenoid is trying to engage but that the internal components are stuck and unable to work properly. Repeated “clicking” sounds usually indicate a dead battery.
Where is the reset button on EZ Go golf cart?
Look in the area where several electrical wires enter the motor and locate a small red button. This is the reset button.
Where is the reset button on electric golf cart?
First, you'll want to reset your motor. It should have a small reset button (Usually it will be red) located near the main battery supply. Hit the reset button and then put the cover back on the motor. The next step would be to recharge your cart and try turning it on again. If it starts up then you're in luck!
How do you jump a solenoid?
0:271:17How to Jump the Solenoid on your ATV or GoKart - YouTubeYouTubeStart of suggested clipEnd of suggested clipWe're just going to put them out and then how we jump it is you could take any screwdriver PhillipsMoreWe're just going to put them out and then how we jump it is you could take any screwdriver Phillips or straight head and then we're going to connect the bolts.
Can you bypass a solenoid?
5:037:29Solenoid Bypass - YouTubeYouTubeStart of suggested clipEnd of suggested clipAll you have to do to bypass the solenoid. And make the starter turn is basically connect this hardMoreAll you have to do to bypass the solenoid. And make the starter turn is basically connect this hard copper wire to this point on the battery. Then you're not doing anything with the solenoid.
How do I know if my EZGO controller is bad?
Press the accelerator and watch to see if the voltage increases. It should increase from a reading of 0 to the full voltage of the battery. If the motor is not turning, the problem may be in the directional switch or motor. If there is no voltage, the controller is bad and must be replaced.
Why does my golf cart click but not move?
A Club Car golf cart can start clicking but not move, due to dust accumulating inside the battery ports. Opening the battery ports and checking whether there is any dust accumulation can tell you if this is the case. Cleaning it thoroughly with a cloth can resolve the problem.
What is a solenoid in a golf cart?
A golf cart solenoid is one of the major components of any golf cart. This part is essential regardless whether you own an electric or gas golf cart because both types primarily rely on a solenoid for their movement. What this means is whichever brand or model you choose for your cart, a solenoid is truly an indispensable part of the vehicle.
How to tell if your solenoid is faulty?
In an electric cart, one of the key signs of a faulty solenoid is when you turn your cart’s ignition on, and find no electricity is being transferred to the controller from the solenoid. When this occurs the usual solenoid click on and off associated with the ignition switch will not take place.
What is a solenoid wiring diagram?
A solenoid wiring diagram can be very helpful in guiding you about the various connections made to and from the solenoid. This can come in handy when you set out to troubleshoot a problem in your cart on your own. The solenoid wiring diagram is generally very simple, straightforward and self-explanatory.
How to get a golf cart going without a glitch?
To get your golf cart going without a glitch, you most definitely need the solenoid of your cart to be functioning properly. Thus, it goes without saying that you must check this component occasionally to monitor its performance so that you don’t get stranded mid-way.
What does the inductive throttle sensor do on a golf cart?
When you push down the pedal of the golf cart downwards, the inductive throttle sensor sends out the first low power signal to activate the solenoid on its low side and the speed controller. The low side is the steel rod of the solenoid.
How often do solenoids work?
Since solenoids need to work very frequently; turning on and off each time you use the cart, they are prone to wear and tear easily. This is not surprising as they can switch on and off as much as 1,500 times a day). One of the first indications that a solenoid is faulty is when your cart fails to start.
Why is my golf cart not clicking?
This may be because the safety reed switch is not working properly in the charger socket. There could be a loose connection of the MOLEX plug.
Why does my golf cart have no solenoid?
Golf cart solenoids are also typically one of the first components to fail in your golf cart, because they work very hard, turning on and off every time you stop and go in your golf cart. If you have an issue with no start or no go then your solenoid should be pretty high on your list of things to check.
What is a solenoid on a golf cart?
A solenoid, for our purposes, is a type of relay. A relay is a type of switch that uses a low power circuit to operate a high power circuit. A solenoid uses a magnetic coil (the actual solenoid) on a low power circuit to push a rod that closes a high power circuit. On your golf cart, this high powered circuit is either your ignition on ...
What is a golf cart go switch?
On your golf cart, this high powered circuit is either your ignition on a gas golf cart or your electrical motor power circuit for an electric golf cart. Basically it’s your golf cart’s go switch, and it’s absolutely essential to your golf cart’s ability to do its job. Golf cart solenoids are also typically one of the first components ...
What happens if a solenoid reads infinity?
If it reads infinity or open lead, then the solenoid has an internal fault and requires replacement. Your solenoid should also have a range that it operates in, and if the resistance reads outside of that range, you should replace the solenoid even if it works to avoid damaging other components.
What is the most important part of a golf cart?
One of the most important components of your golf cart is the solenoid. It is one of the main components of your golf cart that allows it to move. Whether you have a Yamaha, E-Z-GO, or Club Car golf cart, and no matter if it is an electric or gas golf cart, you need a properly operating solenoid to get anywhere. Contents [ show]
What to do if your solenoid doesn't work?
Before you run out and get a solenoid, you’ll have to test the entire ignition system this way to find out what’s not working, and it is a bit of a pain.
What is a micro switch on a gas pedal?
This switch is what sends the low power to the solenoid. The solenoid uses this to create a circuit between the battery and the starter, thus starting your motor and getting you grooving.
What does it mean when a golf cart solenoid goes bad?
Technically, in fact, a solenoid is a shape – a shape in which the length of something coiled is longer than the diameter of the coils. In engine starters, this refers to the smaller motor ...
Why do golf carts have solenoid?
The solenoid is simply there to allow electricity to flow freely to the controller and motor which will result in a running golf cart. RELATED: 4 Signs you need to Replace your Golf Cart Batteries.
Why is my golf cart not clicking?
On an electric golf cart, the most common symptom is the solenoid is not delivering electricity to the controller when the vehicle’s ignition is turned on. In normal operating conditions, the solenoid clicks on and off with the ignition switch. A failing solenoid will generally not click. Two things could be going on here.
How to check if a golf cart solenoid is silent?
On an electric golf cart, if the solenoid is silent – no clicking – use the setting voltmeter to DC volts using the 200 range. First, turn on the ignition while looking for a reading on the smaller terminals. If nothing is appearing, then press on the accelerator. If the needle doesn’t move, then the problem is not with the solenoid.
What does a solenoid do when you turn the ignition?
Step by step, it looks like this: When you turn the ignition key, a small amount of electricity goes to the solenoid. The solenoid uses that small amount of juice to close two heavy-duty contacts that allows a large jolt of electricity to pass through the starter. The solenoid also sends a pinion gear forward, which is the device ...
Why won't my solenoid click?
The solenoid might not be getting enough electricity to do its work – which could be caused by loose connections, a weak battery or the coil wearing out.
Why do you use electrical tape on a solenoid?
When you do this, use electrical tape to seal the cable ends, so they won’t form a circuit by accidentally touching each other or connecting through a metal conductor inadvertently. Doing this will ensure the vehicle will not run while testing the solenoid.
Do E-Z-Go Golf Carts have titles?
E-Z-Go Golf Carts, unlike vehicles, do not have a title, but they do have serial numbers. If you are buying a golf cart, it is essential to check the serial number to ensure you do not buy a stolen one. Each E-Z-Go Golf cart has a unique serial number that you can use to identify your golf cart.
Where is the E-Z-Go Cart Serial Number
As mentioned above, all E-Z-Go Golf carts have unique serial numbers. These numbers are essential when buying replacement parts for your golf cart. Textron Specialized Vehicles has been building golf carts for a long time, and the serial numbers are placed on different parts of the golf carts.
How do I push my E-Z-Go Golf Cart?
It can be frustrating when your battery is flat and your golf cart will not roll. To push it to the nearest charging or gas station, you need to release the motor brake. Follow these easy steps to do that.
Why does my E-Z-Go golf cart not move
There are several reasons why your cart refuses to move, but you should check the battery before anything else. If the battery is charged, here are some other reasons why your golf cart will not move.
Are all E-Z-Go Golf carts electric?
No, there are both electric and gas-powered E-Z-Go Golf carts available. Bear in mind that there are several models you can drive on the street, but those are all-electric. These electric models run on batteries that you have to charge at least every 24 hours, depending on how much you use them.
How to tell the Assembly year of my E-Z-Go golf cart
The placement of serial numbers is discussed above, and you will find the manufacturer’s number right next to it. The manufacturer’s number consists of one letter and 3 or 4 numbers. The last two numbers indicate the last two digits of the year of assembly.
How to service E-Z-Go Golf Cart
Like all vehicles, E-Z-Go golf carts require regular maintenance to enhance longevity and performance. You should ensure that your golf cart is serviced after every six months of use. That will ensure that you spot problems and repair them early, which will help reduce repair costs. Here are essential guidelines for E-Z-Go golf cart maintenance.
Solenoid – why do golf players use it?
Before explaining what are symptoms of a bad solenoid on a golf cart, let’s clarify its definition and purpose for golf players.
What are the symptoms of a bad solenoid on a golf cart?
There are a few signs that a golf cart has problems because of a bad solenoid. You may have even one of these signs detected to become worried. Don’t ignore the following symptoms of a bad solenoid! Ignoring these issues will only make them worse and worse. For instance, a bad solenoid may result in buying a new starter.
How to check solenoid if you own a gas golf cart?
If you suspect the symptoms of the bad solenoid on a gas golf cart, the major problem is usually related to the failure of large contacts. The starter may continue working, even with the ignition turned off. Make sure to check the spring – it shouldn’t be worn down, to pull the pinion back to the neutral position.
How to check solenoid if you own an electric golf cart?
There are certain symptoms of the bad solenoid on an electric golf cart. The lack of any clicking noise when starting the cart’s ignition. The clicks must be heard each time when you switch on and off the ignition. If you don’t hear any clicks, then the solenoid may no longer send electric power to the golf cart.
A step-by-step guide to check a golf cart for a bad solenoid
GolfProfy.com is a website where I post articles for golf players. Every review is supported not just by experience but also includes the tips and opinions of my friends who specialize in golf equipment or techniques. For instance, my friend who is a golf cart technician for a few years wrote this instruction for checking a bad solenoid:
The simplest way to bypass solenoid on a golf cart
If you don’t have a voltmeter and you don’t intend to invest in it, there is another way how to bypass solenoid on a golf cart. Just attempt connecting two large wires of terminals of the solenoid. Then attempt to operate the cart. If it doesn’t work, the solenoid is not your problem. Test the entire ignition system.
Final thoughts
Remember that solenoid is one of the cheapest parts for replacement. Though, without checking and replacing it you risk having a malfunctioning or completely broken golf cart. Make sure to consult experts on how to bypass solenoid on a golf cart before trying it on your own.