Golf-FAQ.com

yamaha golf cart backfires when stopping

by Rosa Hoeger Published 2 years ago Updated 2 years ago
image

Why does my golf cart backfire?

Golf Cart Backfires Because Fuel Mixture Is Too Rich. Always check the air and fuel ratio to make sure your engine is not receiving too rich of a fuel mixture. The following adjustments are an example of most carburetors, but you should look up the proper number of screw turns your model requires.

What is the ignition system on a golf cart?

Older golf carts used a set of points and a condenser to produce the spark needed to run the engine, but the more modern carts have a solid-state ignition system . The solid-state system utilizes an internal magnetic pickup device inside the engine that sends an electrical signal down the line to the igniter.

How to put air mixture back in?

When putting the air mixture screw back in, turn it to a soft seat and then back it off to the number of turns you took note of earlier. Bolt the carburetor back on to the engine head and reattach the cables and other lines. Replace the fuel filter and reconnect the line to the carburetor inlet.

How to clean a carburetor?

(it might be a good idea to take a picture of it with your cell phone.) Using a can of carburetor cleaner, spray all the ports and jets thoroughly. Use a bristle brush to remove the heavier deposits inside the fuel bowl and outside the carburetor body.

How to uncook a muffler?

It sounds crazy, but the common method of un-coking a muffler is to remove it from the cart and barbecue it over a fire for about half an hour. This will burn off all of the debris inside the muffler and turn it to ash.

Why is my piston red?

If you find that there is a buildup of coke on the top of your piston be sure and use a blunt tool to scrape it off because the piston material is very soft and can scratch or gouge easily. A scratch or gouge would glow red at the edges and cause just as much of an ignition point as the original issue would have and would defeat the purpose of de-coking.

Why is my throttle plate not closing?

If none of these accelerator cable adjustments solve the problem, then the throttle plate may not be closing all the way due to an obstruction or internal mechanism being bent. Unfortunately, the only way to find out if this is true is to remove the carburetor and inspect it.

Carburetor

More often than not, golf cart backfiring is caused by the throttle plate inside the carburetor being slightly open. This allows fuel to flow into the cylinder before the ignition system is activated to produce a spark for combustion.

Accelerator Cable

In almost all cases, whether it is a 2 cycle or 4 cycle engine, golf cart backfiring is caused by the accelerator cable being out of adjustment at the throttle plate of the carburetor. This problem has a relatively simple cure.

Adjustment

For proper symbiosis between the fuel and ignition systems, the accelerator micro switch must click BEFORE the throttle lever of the carburetor moves. The accelerator cable may move through the plate, but the plate itself cannot move prior to the micro switch click.

What is Backfiring?

Backfiring is when the combustion inside of the engine experiences an issue that makes it combust incorrectly. The result? An explosion occurs in the exhaust pipe, not inside of the engine as it should. This can cause damage to your clutch, piston rods, and even valves if you’re experiencing backfiring on a regular basis.

What Causes Backfiring on a Gas Golf Cart?

There are a number of reasons why your gas golf cart is backfiring. Some of the common causes of backfiring are:

Gas Golf Cart Parts Explained

Before we get into how to fix your backfiring issue, let’s go over some of the important parts of your gas golf cart that you’ll need to be familiar with.

How Can I Fix My Backfiring Issue on my Golf Cart?

Typically if your backfiring issue isn’t something major, it’s usually a good idea to simply replace parts that are worn out or broken. This includes spark plugs, throttle plates, accelerator cables, and more. If this doesn’t work, you can always adjust parts such as your piston rods and throttle plate for perfectly matched air and fuel mixes!

Still backfiring? Try these other solutions!

If you’re still having issues with your cart backfiring after following all of these steps, it’s possible that there is something wrong deeper within the engine. The next step would be to try a few other solutions listed below:

Why does my golf cart keep powering off?

If the cart starts powering off after a new installation, then you will know that the issue is caused due to errors with the installation.

Why does my golf cart cut out?

Another reason why golf carts can cut out is due to problems with the battery voltage or water levels.

What does the first beep sound on a cart mean?

The manual will have the list of beeps and their respective fault codes. The first beep sound will indicate the performance factor.

Does my cart stop suddenly while driving?

Does your cart stop suddenly while driving and give out beep sounds? Well, you may not be the only one experiencing this. A lot of people have reported that they have experienced their carts stopping suddenly and giving out beeps. In some cases, the carts have started running again after the beep sounds stop.

Can a fuel pump diaphragm be torn?

Also, the diaphragm in the fuel pump could be torn or not working properly. It would be a good idea to verify this part also.

What causes a cart engine to die?

If your cart engine dies suddenly, it may be the carburetor causing the issue. Read the following steps to fix it:

Can you clean out a V glide?

You can also verify whether the wires and connections within the V-Glide assembly are not loose. Any dust or dirt that has managed to get into the assembly could also make the throttle to cut out. Cleaning out the assembly might also be a good idea.

image
A B C D E F G H I J K L M N O P Q R S T U V W X Y Z 1 2 3 4 5 6 7 8 9