Golf-FAQ.com

yamaha golf cart hesitates when starting

by Oceane Mante I Published 2 years ago Updated 2 years ago
image

G9 Yamaha golf cart hesitates. Yamaha G9 golf carts can stall due to a bad solenoid. The bad solenoid is often caused by a loose or damaged connection. Ensure there is no corrosion on the ends of the wires. Check the battery’s cables, the plug connectors, starter generator, and connections in the solenoid.

G9 Yamaha golf cart hesitates
Check the battery's cables, the plug connectors, starter generator, and connections in the solenoid. In the case of rust, it is important to clean the places properly. If it cannot be cleaned, you must replace the wires. A worn-out solenoid can often cause issues.

Full Answer

Why does my golf cart hesitate while accelerating?

When the cart becomes hot, the voltage also drops. So, make sure you provide enough voltage to the batteries so the cart can run. The main reason why an EZGO Gas golf cart hesitates while accelerating, is because of a dirty carburetor. A dirty carburetor causes this hesitation.

What should I do if my golf cart does not start?

On gasoline carts, check the battery that turns the engine over to make sure it is charged. On Electric carts, the battery pack should be checked for a full charge. If there is no click when the pedal is pushed, then there is no solenoid activity.

Why should I learn to troubleshoot my Yamaha cart?

Learning to troubleshoot your cart will help you recognize any potential problems before they become serious issues or safety hazards. Yamaha carts run on electricity generated by an acid-based rechargeable battery and most problems can be traced to this source.

How do I know if my electric golf cart is bad?

First, you turn the key, press the pedal, and listen for a click. If nothing happens, it’s most likely an electrical issue. On gasoline carts, check the battery that turns the engine over to make sure it is charged. On Electric carts, the battery pack should be checked for a full charge.

image

Why is my Yamaha electric golf cart so slow?

Low Battery Usually, the most common reason golf carts slow down is when they don't get enough power output from the battery. If the battery pack charge is very low and your cart is out of power, your cart will run slow.

Where is the reset button on a Yamaha golf cart?

It should have a small reset button (Usually it will be red) located near the main battery supply. Hit the reset button and then put the cover back on the motor. The next step would be to recharge your cart and try turning it on again. If it starts up then you're in luck!

What does a solenoid do on a golf cart?

The solenoid is the small unit that rides on top of the starter in the engine. The solenoid brings power from the battery to the rest of your golf cart. With the use of an electric charge, a solenoid may generate a magnetic field.

What causes an electric golf cart to hesitate?

In most cases, the hesitation problem occurs due to bad batteries. If you have bought new batteries for your EZGO RXV, make sure to fully charge them before the first use. Batteries should then be charged after every use. To keep the batteries in check, get a Digital MultiMeter to measure the individual voltage.

Is there a reset button on Yamaha electric golf cart?

The Simple Motor Reset Process Electric golf cart motors have a reset button on their chassis which is designed to put your motor back into its original factory state.

What are the symptoms of a bad solenoid in a golf cart?

On an electric golf cart, the most common symptom is the solenoid is not delivering electricity to the controller when the vehicle's ignition is turned on. In normal operating conditions, the solenoid clicks on and off with the ignition switch. A failing solenoid will generally not click.

How do you test a Yamaha solenoid on a golf cart?

Turn on the engine of the cart and press the pedal downwards. If you hear a clicking sound, then it means that the low side voltage is working. But, if there is no such sound, it means that either there is no low side voltage or there is a problem with the solenoid. Use a voltmeter and engage the solenoid.

Where is the solenoid located on a Yamaha golf cart?

0:095:38Replace Solenoid in Golf Cart - YouTubeYouTubeStart of suggested clipEnd of suggested clipCart um your solenoid could be located in a bunch of different places but almost always underneathMoreCart um your solenoid could be located in a bunch of different places but almost always underneath the seat.

How to test a fuel pump?

You can test the fuel pump by simply removing the fuel line from the carburetor side and turn the engine over. If there is fuel being pumped out good then it's your carb. If it dribbles it's the pump.

Do golf cart belts chatter?

But the belts don't chatter. If you put the golf cart in neutral and depress the gas, the clutch moves slowly, then picks up speed.

How many volts should a car battery be?

With the engine running at about half power/speed, put a volt meter across the battery terminals. The meter should read somewhere around 14.5 volts. If it is below 13 volts it is definitely not charging. Consider that the battery, unless new, could also be failing.

Do you need a repair manual for a golf cart?

You really need to consult a repair manual/wiring diagram. As a complete uninitiated golf cart layman I would expect the main solenoid switch to be switching the battery voltage which would then supply the speed and direction control board. I could be worng though!

Can a golf cart solenoid be actuated?

My answer is I don't know regarding golf carts but generally a designer would arrange for a solenoid to be actuated by as constant a voltage as possible, especially if it is to be engaged for long periods. That is the only method to ensure consistent operation without danger of overheating. This is assuming the available voltage energises the soleniod.

Why is my golf cart not clicking?

This insulated wire channels the electric current from the battery that powers the cart. If you press on the cart's accelerator and do not hear a clicking sound, the solenoid wires may need tightening.

What does a Yamaha cart run on?

Yamaha carts run on electricity generated by an acid-based rechargeable battery and most problems can be traced to this source. If your cart is sluggish or won't start, the battery may need to be charged. If it is charged, but still not working properly, make sure the battery terminal connections are clean and secure.

Do Yamaha golf carts need maintenance?

Yamaha golf carts, like any other machine, will occasionally require troubleshooting and maintenance to ensure that they are functioning properly. Learning to troubleshoot your cart will help you recognize any potential problems before they become serious issues or safety hazards.

Why is my golf cart not accelerating?

When your electric golf cart does not accelerate, the first thing you need to keep in mind is that it is not a regular vehicle like your car . That's why the methods and solutions you use to get your car to start are not the same as the solutions you can apply to your cart.

What happens if your golf cart doesn't accelerate?

Bad Solenoid. If your golf cart does not accelerate, there is a possibility of the damaged solenoid. The solenoid is basically an electrical switch that enables the battery's flow from the battery into the motor. Check out the signs of the bad solenoid.

Why is my golf cart speed controller not working?

There are many reasons behind a speed controller malfunction. The most common problem that happens in the controller has aged due to infrequent use. These are just some of the issues that could be affecting your vehicle's acceleration. If you have trouble finding the issue of your golf cart accelerator, don't be afraid to take it to the mechanic.

What does it mean when your cart doesn't start?

If your cart does not start smoothly, hesitates before starting, or does not gain speed properly, these are all signs of a bad or damaged accelerator.

How does a golf cart solenoid work?

The golf cart speed controller and solenoid are both controlled by the accelerator. The pedal is connected to the potentiometer. That means when you are pressing the pedal for acceleration, you are actually going through the potentiometer by pushing a rod. The potentiometer works as a communicator and tells the speed controller how much voltage it ...

image
A B C D E F G H I J K L M N O P Q R S T U V W X Y Z 1 2 3 4 5 6 7 8 9