Faulty parts such as the solenoid, OBC and wiring can also cause a golf cart to not move. There are several reasons why your club car won’t move: Batteries; in a pack of 3 or 4 batteries even if one fails, the required power won’t reach the motor
What to do if your solenoid is not getting enough voltage?
Does a 48 volt club car move?
About this website
Why wont my golf cart go forward or reverse?
The problem could be with either the Run/Tow switch or Forward/Reverse switch or both. Check the switches to ensure that they aren't stuck midway. If they are, getting them released should help. However, if they show signs of wear and tear, you must get them replaced.
What causes a golf cart not to move?
Solenoid Wear When there is a disruption in the flow of the electrical current, your cart will not operate. A common reason for current disruption is solenoid wear. Each time the solenoid activates as you press down on the gas pedal, the solenoid compounds down onto a thin metal contact plate.
Why does my golf cart click but not move?
A Club Car golf cart can start clicking but not move, due to dust accumulating inside the battery ports. Opening the battery ports and checking whether there is any dust accumulation can tell you if this is the case. Cleaning it thoroughly with a cloth can resolve the problem.
Where is the reset button on a Club Car golf cart?
It should have a small reset button (Usually it will be red) located near the main battery supply. Hit the reset button and then put the cover back on the motor. The next step would be to recharge your cart and try turning it on again.
How do I know if my golf cart solenoid is bad?
If your golf cart fails to turn on when you turn the key on, this is the most obvious sign of solenoid failure. The solenoid clicks a little with the ignition system in regular operation; in most cases, a failing solenoid will not snap.
Where is the solenoid located on a Club Car golf cart?
0:095:38Replace Solenoid in Golf Cart - YouTubeYouTubeStart of suggested clipEnd of suggested clipCart um your solenoid could be located in a bunch of different places but almost always underneathMoreCart um your solenoid could be located in a bunch of different places but almost always underneath the seat.
How do you test a golf cart controller?
How to Test a Club Car Golf Cart Speed Controller? The simplest test to ascertain your golf cart controller's performance is to to watch whether it runs when the batteries are fully charged with a slight push of the pedal. If you hear a distinct clicking noise, then your golf cart is running correctly.
How do you reset a golf cart motor?
First, you'll want to reset your motor. It should have a small reset button (Usually it will be red) located near the main battery supply. Hit the reset button and then put the cover back on the motor. The next step would be to recharge your cart and try turning it on again. If it starts up then you're in luck!
How do you troubleshoot an electric club car?
2:3915:0248 Volt Club Car Diagnostics - YouTubeYouTubeStart of suggested clipEnd of suggested clipMake sure your key switch is on step on the accelerator. You should get a light here.MoreMake sure your key switch is on step on the accelerator. You should get a light here.
Do all golf cart motors have a reset button?
Electric golf cart motors have a reset button on their chassis which is designed to put your motor back into its original factory state. While it doesn't repair damage that may have occurred to the motor over the years, obviously, it does help to overturn any changes to the operation which may have occurred.
Where are the fuses in a Club Car golf cart?
In a 1997 Club Car, the fuse is located in the electrical components black box that is present near the battery. On the other hand, in a 2005 Club Car Precedent, the fuse is connected to a blue wire under the golf cart seat.
How do I reset my electric Club Car?
Easily Reset the Club Car Golf Cart OBCKey switch to off.Set forward/reverse to neutral.Put tow/run switch to tow.Disconnect the negative battery terminal from the battery pack.Put the tow/run switch to run.Put forward/reverse switch to reverse.Put key switch to on.More items...
SOLVED: Push Pedal nothing happens - Golf Cart - iFixit
Yesterday I pulled up to my ball and hit it and then got back into the cart and it wouldn't go anywhere when I press the pedal I have a 2000 ezgo electric golf cart.
Club Car Precedent Won't Move Forward or Reverse
Club Car Precedent won't move forward or reverse. This issue has been getting progressively worse. Started out when depressing the pedal nothing would happen but then letting off the pedal and trying again the cart would work fine. Now there is nothing when depressing the pedal. Help!
Why a Club Car DS/Precedent Solenoid Clicks but Won’t Move
Why a Club Car DS Clicks but Won’t Move. If your club car makes a clicking sound but doesn’t move, the issue could be due to a faulty battery or damage to the internal controller.
My electric golf cart will not go uphill and losses power quickly.
@satterfield you want to go ahead and load test the batteries to see their real condition. Your batteries may have the proper voltage and may not hold a charge under load. Even one bad battery can affect the performance of your cart. You should also check the voltage drop while driving uphill.... - Golf Cart
What to do if your solenoid is not getting enough voltage?
Check your connections at the solenoid and the motor. If you are not getting enough voltage at the solenoid, check for bad fuses or circuit breakers. If voltage is good at the solenoid, but not the motor; suspect the solenoid is going bad. Hope this helps.
Does a 48 volt club car move?
48 volt club car, surges slightly when pedal is pressed, but will not move. can hear silenoid clicking on and off after a few seconds of pedal release, but no movement in forward or reverse.
Why is my club car not moving?
A Club Car golf cart can start clicking but not move, due to dust accumulating inside the battery ports. Opening the battery ports and checking whether there is any dust accumulation can tell you if this is the case. Cleaning it thoroughly with a cloth can resolve the problem.
Why won't my club car DS move?
If your club car makes a clicking sound but doesn’t move, the issue could be due to a faulty battery or damage to the internal controller. Check whether the batteries are working fine. Use a voltmeter to check the static voltage of the batteries.
Why does my motor make a clicking sound?
The clicking sound that you hear is made by the solenoid. There are many reasons why this could be happening. If the battery is down you might hear the solenoid click. If the wires between the solenoid and the motor are not connected properly, the solenoid might make this sound. If the motor or the controller is damaged then again, ...
What are the components of a motor that are burnt out?
The most common components to be burnt out are the brushes. You can easily get the brushes from one of the cart dealers and replace them. Check the solenoid to see if it is working correctly.
What does it mean when your club car battery is too low?
If the voltage is too high or too low, it means that the battery needs to be recharged fully. Try recharging the battery to its full capacity. If the voltage still keeps fluctuating, you may have to replace the battery. Check for a similar brand and model suitable for your club car.
What is a 9 degree driver?
What is a 9 Degree Driver? A 9 degree driver is a low loft driver and is most convenient for golfers having fast swing speeds. These drivers create a positive angle of attack and generate little spin. Features Specifications Loft Range Low Used For Golfing Ideal For Golfers who have a swing speed of 105 ]
Can a car controller be defunct?
In most cases, the controller could have become defunct after many years of use. You can take out the controller and test it to see if it is working correctly. The resistance coil can also prevent the car from moving forward. It is often found that the resistance values are out of the normal range.
Why won't my golf cart start?
Like any other electric vehicle, the batteries are mainly at the root of why your cart won't start. After all, they are the primary source of power for your electric golf cart. If your cart is not working, this is the first place to check. Generally, lead acid-based batteries are used for electric golf carts, and you must recharge them regularly so that they function correctly.
What is a direction switch on a golf cart?
The direction switch or forward/reverse switch controls whether the golf cart moves forward or backward. This switch is one of the most used parts in a golf cart, which means it will be subject to wear and tear. You'll find what the issue is if the switch is acting up. There is a big chance that it will need to be replaced. Again, it's best to choose a mechanic for repair.
Golf Cart
Support for gas-powered and electric golf carts, sometimes referred to as golf cars or club cars after the Club Car Golf Cart brand.
2 Answers
Noah Lisciandro that looks like a Blue and a green wire. Could be the one that needs to go to the key switch.
What to do if your golf cart is under water?
If the cart was under water you might want to change the rear end oil and re-pack the front wheel bearings also . Here's a link to post that will give you all the information on changing the fluids in the Club Car.#N#Club Car DS Servicing
Does a hotrod cart have a fuel pump?
Like hotrod reccomended make sure that you are getting fuel first and no you probably will not see the fuel move through the filter it only moves a small amount. Checking the valves would probably be a good thing why don't you pull the carburetor off and clean it good crank it over a few times and pull the plugs to see if they are wet or dry then get back with us maybe together we can figure it out and yes the cart does have a fuel pump.
Why do electric golf carts fail?
These carts can start to show signs of wear and may fail just like any other vehicle over time.
What are the problems with electric golf carts?
These carts can start to show signs of wear and may fail just like any other vehicle over time. Learn about some of the more common issues associated with electric golf carts. 1. Solenoid Wear. The solenoid is the primary electrical switch in your golf cart and is designed to ensure the current from the battery flows into the motor. ...
What is the controller on a golf cart?
An electric golf carts' controller is known as the heart of the operation and closely resembles and operates much like the motherboard in a computer. So a problem with the controller will have rippling effects throughout the cart. A common function of the speed controller is to control the speed of the golf cart.
Why does my gas cart not work?
When you press down on the gas pedal and hear a tapping-like sound, this is the sound of the solenoid activating. When there is a disruption in the flow of the electrical current , your cart will not operate. A common reason for current disruption is solenoid wear.
What happens if your cart doesn't move?
If the cart doesn't move in either direction, both switches have failed. Diagnosing a problem with the direction switches isn't a complicated matter, but repairing the switch is more complex, especially if the switches are built into the speed controller.
Why won't my sped controller accelerate?
Problems with the sped controller occur for a variety of reasons, but most often the cause is degradation due to age or lack of use.
Why is my golf cart not clicking?
On an electric golf cart, the most common symptom is the solenoid is not delivering electricity to the controller when the vehicle’s ignition is turned on. In normal operating conditions, the solenoid clicks on and off with the ignition switch. A failing solenoid will generally not click. Two things could be going on here.
What does it mean when a golf cart solenoid goes bad?
Technically, in fact, a solenoid is a shape – a shape in which the length of something coiled is longer than the diameter of the coils. In engine starters, this refers to the smaller motor ...
How to check if a golf cart solenoid is silent?
On an electric golf cart, if the solenoid is silent – no clicking – use the setting voltmeter to DC volts using the 200 range. First, turn on the ignition while looking for a reading on the smaller terminals. If nothing is appearing, then press on the accelerator. If the needle doesn’t move, then the problem is not with the solenoid.
Why do golf carts have solenoid?
The solenoid is simply there to allow electricity to flow freely to the controller and motor which will result in a running golf cart. RELATED: 4 Signs you need to Replace your Golf Cart Batteries.
Why won't my solenoid click?
The solenoid might not be getting enough electricity to do its work – which could be caused by loose connections, a weak battery or the coil wearing out.
What does a solenoid do when you turn the ignition?
Step by step, it looks like this: When you turn the ignition key, a small amount of electricity goes to the solenoid. The solenoid uses that small amount of juice to close two heavy-duty contacts that allows a large jolt of electricity to pass through the starter. The solenoid also sends a pinion gear forward, which is the device ...
How to troubleshoot a golf cart?
GOLF CART CONTROLLER TROUBLESHOOTING 1 Make sure it isn’t your batteries! If your batteries are old and dead, then your golf cart will not operate. Charge them fully first and attempt to drive the unit. 2 If your batteries are fully charged and your vehicle won’t run, when you press on the accelerator pedal, then you should hear a clicking sound which will indicate the solenoid is engaging and allowing power to flow to your controller. If there is no distinct clicking sound, then check your solenoid. Also, it could have to do with something in the accelerator device as well. But, we can eliminate the controller as being defective. 3 If your batteries are fully charged and you get a clicking sound ensuring the solenoid is allowing power to flow to the controller, then you can begin inspecting the controller 4 Check all the wiring and signs of disconnection or damage. Also, most controllers will have an operation light that will begin to flash a morse code that will unveil the secrets of the problem. If that is the case and all of the above have been eliminated, then you are getting closer to determining it is the controller.
Why won't my club car run?
Due to their expense, you want to be sure your controller is the major reason and problem with your Club Car. First off, if your controller is bad, your vehicle won’t run. However, there are other reasons that could lead to your vehicle not running. Here are a few quick troubleshooting tips.
What does it mean when there is no controller?
When there is no controller, it means batteries drainage is at its peak, as motors can operate independently at their high speed, which would gradually increase stress on the mechanical and electrical components and let motors and batteries degrade quicker.
What is the function of a motor controller?
Following are some of the main functions of the controller, irrespective of the type of the motor: Limiting the current to the motor so that both motor and the controller could be protected in case of motor stalling and overloading.
Does a golf cart controller degrade?
As a controller in the Club Car or golf cart is made up of electrical and electronics components, it degrades gradually over time with the frequency of usage. But usage is not the only factor, controllers and the Club Car parts may also degrade in case of non-usage. For example, if a golf cart is left for no use for a longer period, ...
Can you trust aftermarket controllers?
price difference. Generally, Club Cars are made with highly precise and quality ensured engineering practices, so you can easily trust the aftermarket controllers if you don’t want to spend much.
Do golf carts have solenoids?
In the old days of golf carts, a series of solenoids were used which was not an efficient means for battery management. As today’s technology does not use full-on DC Motors, instead there exist Brushless DC Motors and AC Motors by way of which operators have the option to drive the Club Car at varying speeds.
What to do if your solenoid is not getting enough voltage?
Check your connections at the solenoid and the motor. If you are not getting enough voltage at the solenoid, check for bad fuses or circuit breakers. If voltage is good at the solenoid, but not the motor; suspect the solenoid is going bad. Hope this helps.
Does a 48 volt club car move?
48 volt club car, surges slightly when pedal is pressed, but will not move. can hear silenoid clicking on and off after a few seconds of pedal release, but no movement in forward or reverse.