Golf-FAQ.com

how do i reset the obc on a 2005 club car precedent golf car

by Lori Kerluke Published 2 years ago Updated 2 years ago

Press the throttle pedal and lock it using a heavy object or request someone to hold it down for you. Wait for the reverse buzzer to sound and go off in about half a minute. Allow the golf cart to stay that way for at least five minutes so that the OBC is reset.

Easily Reset the Club Car Golf Cart OBC
  1. Key switch to off.
  2. Set forward/reverse to neutral.
  3. Put tow/run switch to tow.
  4. Disconnect the negative battery terminal from the battery pack.
  5. Put the tow/run switch to run.
  6. Put forward/reverse switch to reverse.
  7. Put key switch to on.

Full Answer

How to reset the club car golf cart OBC?

Easily Reset the Club Car Golf Cart OBC 1 Reconnecting the OBC into the system: 2 Key switch to off 3 Set forward/reverse switch to neutral 4 Put tow/run switch to tow 5 Reconnect the negative battery terminal from the battery pack

How do I know if the OBC on the club car is working?

If the OBC on the Club Car is functional and the batteries are above 35 volts, you should hear a "click" from the relay inside the charger when the round plug is inserted into the cart and the charger should come on and begin charging.

How to test a club car precedent controller?

To test a club car precedent controller, connect a voltmeter between the negative terminal of your cart’s battery and the M terminal on the controller. Then push the pedal down and look for a clicking noise from the solenoid. Your batteries should read as full. Connect a voltmeter to the negative terminal on the battery

What is an OBC on a golf cart?

The OBC is a small device that is wired into the golf cart that’s purpose is to regulate the batteries charge. As you use and drive your golf cart, the OBC records the amount of energy consumed and then directs the charger to replace exactly the amount of energy needed to fully replenish the batteries. Do all golf carts have OBC’s?

Is there a reset button on a Club Car golf cart?

Electric golf cart motors have a reset button on their chassis which is designed to put your motor back into its original factory state. While it doesn't repair damage that may have occurred to the motor over the years, obviously, it does help to overturn any changes to the operation which may have occurred.

Where is the reset button on electric golf cart motor?

First, you'll want to reset your motor. It should have a small reset button (Usually it will be red) located near the main battery supply. Hit the reset button and then put the cover back on the motor. The next step would be to recharge your cart and try turning it on again. If it starts up then you're in luck!

Does a 2005 Club Car Precedent have a OBC?

Since 1995, 48 volt Club Cars come with an OBC.

How do you bypass OBC on Club Car DS?

To bypass the OBC you will need to connect a 12 gauge black wire from the negative terminal of this battery to where the black wire attaches to the back of the receptacle. That's it folks; you're done!

How do you reset the OBC on a Club Car golf cart?

Easily Reset the Club Car Golf Cart OBCKey switch to off.Set forward/reverse to neutral.Put tow/run switch to tow.Disconnect the negative battery terminal from the battery pack.Put the tow/run switch to run.Put forward/reverse switch to reverse.Put key switch to on.More items...

How do I change my Club Car to OBC?

1:083:20How to Replace on Club Car Precedent Golf Cart | OBC - YouTubeYouTubeStart of suggested clipEnd of suggested clipHere's the back side of your OBC. To take this portion out you take your ten millimeter socket andMoreHere's the back side of your OBC. To take this portion out you take your ten millimeter socket and ratchet take these out slide it up in your bed tilt it forward. Then you would take this coupling.

How do I test my OBC golf cart?

How to Test Club Car Precedent Controller?Connect a voltmeter to the negative terminal on the battery.Connect the voltmeter to the M terminal on the controller.Push down on the golf cart pedal.A clicking sound should be heard.The batteries show a full charge.

Where is the OBC on a Club Car golf cart?

Look for the main negative wire coming off of the last battery in sequence(it will be the only negative wire not going to another battery). If you have an OBC(on board computer) the wire will come off of that negative wire and through the middle of a small box about 4" inches square. The small box is the OBC.

How do I reset my golf cart?

Believe it or not, it may be as simple as pressing a reset button. Use a screwdriver to expose the motor. Look for a small red button located near the main power supply. Press the button and put your cart back together before hooking it up to charge.

What is an OBC bypass kit?

Simply connect this Club Car OBC Bypass Kit. It shuts off your OBC's "brain" so it can no longer (a) prevent charging or (b) over-charge / fry your batteries. Lets You Use Your Own Charger. Once your Red Hawk Bypass Kit deactivates your OBC, you can properly charge your cart with any microprocessor-controlled charger.

How do you remove the speed limiter on a electric golf cart?

0:000:46How to remove governor on a Club Car golf cart - YouTubeYouTubeStart of suggested clipEnd of suggested clipYou open up this box lap. Here. It looks up look inside. There's 12 cable down right here this leverMoreYou open up this box lap. Here. It looks up look inside. There's 12 cable down right here this lever you want to lift up and Bend and that pulls on the cable a little more.

How do you put a club car in service mode?

0:151:07PRO TIP - Putting a Club Car DS Golf cart (Gas) into Maintenance ModeYouTubeStart of suggested clipEnd of suggested clipOkay here's a quick tip anytime you're working on a club car especially on the on the club card DXMoreOkay here's a quick tip anytime you're working on a club car especially on the on the club card DX there's a little yellow switch. Right here see when this is in neutral you push the gas.

What is an OBC in golf carts?

Club Car uses the On Board Computer or OBC to monitor and control functions of their golf carts. If it functions properly it controls the charging and the drive system. If the OBC detects a problem with the charging system or the drive systems it shut down.

How long does it take for the OBC to reset?

Lock the throttle pedal down with a second set of hands or object. The reverse buzzer will sound and go off in approximately 30 seconds. Leave the cart like that for 5 min to cause the OBC to reset.

What happens if you disconnect the controller from a golf cart?

If you disconnect the controller from the golf cart will cause a soft reset of the of the OBC when the battery power is removed. Once the battery powered is removed, the OBC internals will clear any faults. Once the controller is reinstalled, everything should work fine.

Is tidewater cart responsible for golf cart problems?

Tidewater Carts is not responsible for any malfuntions or problems that you incur directly or indirectly from folowing these procedures. Keep in mind that testing and troubleshooting should be done by trained and paid golf cart tech's.

How to Reset Club Car Precedent OBC?

For club car precedent, it is the same as above and with only some difference. You, first of all, make the key switch to off position. Then you do neutral to Forward/Reverse. After this, make Tow to Tow/Run switch and disconnect the negative terminal wire from the battery minus terminal of the battery set.

How to reset club car OBC?

The best way to reset your club car OBC is first to switch off the key switch. Then you put your cart to neutral and then put tow run switch to the low position. After this, you should disconnect the negative of the battery terminal from the battery set.

What Does a Club Car Golf Cart Controller Do?

It is the controller that controls the acceleration and deceleration of a golf cart.

How to Test 48 Volt Club Car Controller?

Testing your 48 volt club car controller is easy. First of all you need to charge your batteries to the full.

How to check if golf cart battery is working?

Connect a voltmeter to the negative terminal on the battery. Connect the voltmeter to the M terminal on the controller. Push down on the golf cart pedal. A clicking sound should be heard. The batteries show a full charge. You must determine whether your golf cart batteries are working properly or not.

Why is my cart not starting?

If your cart doesn’t start even when your batteries are full, and no clicking sound comes from the solenoid, it means your solenoid is defective or accelerator. If you hear a distinct clicking sound, this means that there is nothing wrong with solenoid as it allows power to flow to the controller.

How long does it take for an OBC to reset?

When you do this you will hear the reverse buzzer. Now leave the cart like that for about 5 minutes such that the OBC resets. Then after 5 minutes you release the throttle pedal. Now for reconnecting OBC back into your club car system you must switch off key.

How to check if a golf cart is working properly?

To check this, disconnect the wires at the bottom of the breaker and connect them to a blade fuse of the same rating. If the golf cart functions properly, you need a replacement breaker. There is a problem with the wire harness between the controller and the circuit breaker. Alternatively, the controller may be defective.

How much does a club car diagnostic tool cost?

They are the user, technician, dealer and manufacturer versions. On average, the tool costs around USD 650. The user version has the maximum number of functions while the functions in the manufacturer version are limited.

What is the resistance of a MCOR 3 pin plug?

Check the resistance of the three MCOR wires that are connected MCOR 3 pin plug to controller 16-pin plug. Each of the resistors should have 453 Ohms resistance.

What happens if the motor armature wire is broken?

If the wire is disconnected or loose, reconnect it or tighten it as appropriate. In case of a broken wire, do a replacement. The motor brushes or armature may have failed.

How to check if motor is operating correctly?

Run the Motor Unwanted Continuity Test to determine whether the motor is operating correctly. Check the voltage of the smaller solenoid terminals if you don’t hear a clicking sound from the solenoid when you turn the key to the ON position.

What is anti tamper on golf carts?

The anti-tamper functionality is integrated into the Visage GPS of a Club Car golf cart. It affects the maximum speed when a GPS signal is not detected on the golf course.

How to lock throttle pedal?

Press the throttle pedal and lock it using a heavy object or request someone to hold it down for you.

What is an OBC golf cart?

Since 1995, 48 volt Club Car's come with an OBC. The OBC is is a small device that is wired into the golf cart that’s purpose is to regulate the batteries charge. As you use and drive your golf cart, the OBC records the amount of energy consumed and then directs the charger to replace exactly the amount of energy needed to fully replenish ...

What does OBC stand for in a car?

What does OBC stand for? You’ll see that generally folks will use the abbreviation OBC. This is simply an abbreviation for “On Board Computer” and is widely used when referring to the OnBoard Computer in your 48V Club Car (a much quicker way to get it down on paper rather than typing out the whole phrase).

How many volts does a club car battery have?

If the OBC on the Club Car is functional and the batteries are above 35 volts, you should hear a "click" from the relay inside the charger when the round plug is inserted into the cart and the charger should come on and begin charging.

How often does the OBC battery charge?

Yes. The OBC has a long term storage mode of sorts and will activate the charger every 15 days or so to keep the batteries charged.

How to contact GolfCart Garage?

If you have questions about your OBC and whether or not it’s functional, feel free to email us at Support@GolfCart Garage or give our experts a call at 800-401-2934 and we would be happy to help you!

Can OBC carts move?

Yes. The OBC won’t let the cart move when the charger is plugged in.

What to do if your charger is not 42 volts?

If there is not 42 volts you should check the sense wire connection on the charger receptacle and check the inline fuse is available.

Is an OBC bad?

NOTE: (Note: If you have any (any) corrossion on or around the OBC or any wires leading to the OBC have corrossion or are burnt or darkly discolored due to heat - your OBC is most likely bad. However, your OBC may still be bad if everything appears to looks good visually, so you will need to test.)

Can you plug a golf cart charger into an extension cord?

Make sure the electricel outout you are plugging the golf cart charger works properly. Do not connect your golf cart charger to an extension cord, it may not work at all or work properly.

Is tidewater cart responsible for golf cart problems?

Tidewater Carts is not responsible for any malfuntions or problems that you incur directly or indirectly from folowing these procedures. Keep in mind that testing and troubleshooting should be done by trained and paid golf cart tech's.

A B C D E F G H I J K L M N O P Q R S T U V W X Y Z 1 2 3 4 5 6 7 8 9