Loosen the drive belt tension bolt, with the open end wrench, on the front pulley. Slide the old drive belt off the front drive clutch pulley, and then the rear clutch pulley. Slip the new belt around the golf cart's clutch pulley, and then stretch it out over the front pulley.
How do you replace the belt on a golf cart?
Raise the golf cart engine cover, to access the drive belt inside the engine compartment. The drive belt is plainly visible. Loosen the drive belt tension bolt, with the open end wrench, on the front pulley.
How to replace a clutch on a golf cart?
Switch OFF the golf cart’s engine. Take a screwdriver and gently insert it between the belt’s bottom and the clutch’s groove. Slowly rotate the clutch and the belt will come off easily. If the belt is already loose, taking it out is very easy.
What does a drive belt do on a golf cart?
To primary function of a golf cart drive belt is to connect the primary clutch and the secondary clutch. The primary clutch drives the cart and the belt helps it to rotate the secondary clutch (they are referred to as the drive clutch and the driven clutch respectively). The drive belt, unlike some of the other automotive belts, are very thick.
What does a drive belt do on a club car precedent?
The drive belt on a Club Car Precedent golf cart is an important component and using the right-sized drive belt is essential for a smooth ride. To primary function of a golf cart drive belt is to connect the primary clutch and the secondary clutch.
How do you change a belt on a Easy Go golf cart?
1:195:57Changing the Drive Belt and Starter Generator Belt 2008 EZGO TXTYouTubeStart of suggested clipEnd of suggested clipDrive belt to remove it all you got to do is kind of work it over the edge and then roll. Back.MoreDrive belt to remove it all you got to do is kind of work it over the edge and then roll. Back. Until it pops off that rear driven clutch and then take it right out.
How do you tighten a drive belt on a golf cart?
There is no provision for adjusting the drive belt on a Club Car golf cart. If you find the belt loose or too tight, you have to go for a replacement belt.
How do I know if my golf cart belt is bad?
0:152:00How to Check the Belts in your Gas Golf Cart | Golf Cars UnlimitedYouTubeStart of suggested clipEnd of suggested clipDown below and you don't want to press the moderate pressure on that belt you're gonna want to seeMoreDown below and you don't want to press the moderate pressure on that belt you're gonna want to see about 3/16 to 1/4 inch of deflection. There no more than that that'll be your proper.
Why wont my EZGO golf cart go forward?
The main reason why a EZGO gas golf cart will not go forward is because of a locked up brake, or a faulty solenoid and accelerator. A defective Run/Tow or Forward/Reverse switch can also cause a EZGO to not move forward.
How does EZGO clutch work?
0:463:28How a golf cart CVT slip drive clutch works - YouTubeYouTubeStart of suggested clipEnd of suggested clipMaking the revolution path smaller like dropping the chain on the back of your bike down to aMoreMaking the revolution path smaller like dropping the chain on the back of your bike down to a smaller gear causing the belt to rotate even faster.
How do you rebuild a clutch on a EZGO golf cart?
0:395:37GBoost E Z GO ClutchKit CKSDEZ19 - YouTubeYouTubeStart of suggested clipEnd of suggested clipFor this cart loosen the leaf spring bolt and slide it back so you'll have room to remove bothMoreFor this cart loosen the leaf spring bolt and slide it back so you'll have room to remove both clutches and belt. Now we can remove both bolts for the driven.
How tight should an EZGO drive belt be?
How Tight Should a Golf Cart Drive Belt Be? The drive belt should not be too tight. If it's too tight it can risk wearing off faster and it's also harder to shift gears.
How do I know if my EZGO clutch is bad?
A sudden inability to maintain even slow speeds when heading uphill or changing elevation. Slowing down to a crawl, then speeding up, then slowing again, seemingly without reason. Jolting during startup. A 'cranking' sound when starting up the golf cart.
Why does my golf cart click but not move?
A Club Car golf cart can start clicking but not move, due to dust accumulating inside the battery ports. Opening the battery ports and checking whether there is any dust accumulation can tell you if this is the case. Cleaning it thoroughly with a cloth can resolve the problem.
Why won't my golf cart go forward or backwards?
If the power from the battery pack is not reaching the motor, then the Club Car golf cart won't move forward or reverse. In such cases, there are a few components in between the two that need to be checked. The solenoid is one major component. Check if the resistor between the two big terminals on the solenoid is hot.
Where is the reset button on EZGO golf cart?
Locate the motor Remove the panel so the electric motor is visible. Electric motors usually include reset buttons that can perform similar to circuit breakers. Look in the area where several electrical wires enter the motor and locate a small red button. This is the reset button.
Where is the reset button on golf cart motor?
First, you'll want to reset your motor. It should have a small reset button (Usually it will be red) located near the main battery supply. Hit the reset button and then put the cover back on the motor. The next step would be to recharge your cart and try turning it on again. If it starts up then you're in luck!
How tight should a golf cart drive belt be?
The drive belt should not be too tight. If it's too tight it can risk wearing off faster and it's also harder to shift gears. To check if your drive belt is set just right make sure your golf cart is turned off then check the drive belt by pressing it down between the two clutches with your finger.
How do you tighten the belt on a club car starter?
6:459:16Club Car DS Tune Up Kit | Starter/Drive Belt - YouTubeYouTubeStart of suggested clipEnd of suggested clipBelts are that easy now that we got the belts changed let's say we're going to do on this turn upMoreBelts are that easy now that we got the belts changed let's say we're going to do on this turn up it's go ahead we're going to check the valves. See if they need adjusting.
How do you tighten the belt on a Yamaha gas golf cart?
0:002:03How to tighten a loose Starter Belt on Yamaha Golf Cart YDRA. G29YouTubeStart of suggested clipEnd of suggested clipAnd wiggle this belt here yeah she's loose. All right my 12 mil uh socket here grab that loosen thatMoreAnd wiggle this belt here yeah she's loose. All right my 12 mil uh socket here grab that loosen that up 17 mil wrench here wrap this down. There you go.
How do you fix a clutch on a golf cart?
Cleaning the clutch thoroughly might be the simplest solution to this problem. You could also try lubricating the system with a good quality lubricant. This might free up the clutch and thus prevent the squeaking noise. Another common reason could be due to the weights present inside the system hanging up.
Why is my Ezgo golf cart belt so loose?
The reason your EZGO drive belt is too loose could be because it’s worn out, or you’re simply using the wrong size drive belt. In this case, need to find a replacement immediately. A loose drive belt can result in your EZGO Golf Cart to lose top speed and underperform.
Why is my EZGO drive belt so tight?
The reason your EZGO drive belt is too tight can be because you’re not using the right size drive belt. Check and make sure if you’re using the right one. A quick search online will give you the right information. It can also be too tight because the drive/driven clutch is misplaced or broken.
How to tell if golf cart drive belt is too tight?
To check if your drive belt is set just right make sure your golf cart is turned off then check the drive belt by pressing it down between the two clutches with your finger. If it deflects less than 1.5” it’s too tight.
Why is my clutch too tight?
It can also be too tight because the drive/driven clutch is misplaced or broken. A drive belt that’s too tight can damage the drive and driven clutches and can also result in the drive belt being worn out too fast. To check, whether the drive/driven clutch is misplaced or broken call a certified technician to have a look.
Why is my drive belt so loose?
If the drive belt is the right model but it seems to be too loose then it could be because there is something stuck in the clutch or there is some damage in the clutch. In this case you’ll need to call a certified technician to inspect your golf cart.
How to stop a EZYGO drive belt from slipping?
How to stop a EZYGO drive belt slipping: Make sure that you have the right drive belt. Sometimes the wrong drive belt will not be as wide as the clutch you are putting it on. This gives it an unwanted room to move back and forth when you are using the golf cart.
Where is the primary drive clutch located?
After doing so, you can follow these steps: Locate the primary drive clutch. It’s located at the bottom of the two clutches and is the smaller one. Take note of how the existing belt has been adjusted to the clutches and then remove it.
golfcartman
When you removed the batteries, a certain procedure MUST be followed. Key switch off, switch to tow position and shift lever in reverse. You must wait until the beeper unit sound dies out then remove the wire from the most NEGATIVE cable. Place in Neutral before installing new batteries.
golfcartman
Your batteries have died. The reason it will barely move in reverse is that current is being supplied to the motor is a direction that it spends very little time using. There is a slight change in the armature over time, and reverse tends to work better over time. Check the voltage when under load.
I do not know how to start my ezgo electric golf cart 2001 no one showed me how to start it just said here it is drive it and left so it is in great running condition what are the steps to turn it on
Click on the link above and when you get to the page, select your specific golf cart and you can read the manual. It should explain everything you need to know.
Basic EZGO Golf Cart Problems And How To Fix -
Apr 30, 2010 - Electric E-Z-Go Golf Carts are becoming more popular every day ..... I have a ezgo carryall gas golfcart. it has began to pour smoke from rear.
1978 ezgo gas golf cart tighten clutch belt
You may have this posted in the wrong product category. Please select another category appropriate to the problem and re-post the problem so the correct expert will see and respond to the question..
Do i need to mix the gas in my 1988 ezgo
Most people do not trust the old oil pump used on the 3PG models, me included. Mix 50:1 and you can be sure that the piston and crank will not seize up.
