- Open up your cart hood to expose your carburetor and to make it easier to work upon
- Find the pilot adjustment screw on the edge of your carburetor
- Pay attention to this screw – it should be a sharp point and not flat
- Carefully remove this screw and then carefully screw it back
- Turn this screw out one and one-half turns to adjust it properly
- Find the throttle stop screw and then push it backwards on its threads
- Wait until the throttle shaft completely closes before you stop pushing
- Now carefully turn this screw back one-quarter turn
- Pull out the pilot adjustment screw. ...
- Rethread the screw back until it's slightly seated.
- Turn the screw outwards by 1-1/2 turns.
- Push the throttle stop screw backward until the throttle shaft is closed completely.
- Turn the screw in by a 1/4 turn.
How to adjust a carburetor on a golf cart?
How to Remove Carburetor on a 1993 EZGO Marathon
- Move the starter to the front of the golf cart.
- Pull the stud bolt of the carburetor gently.
- Turn the carburetor and remove it.
How do you slow down a gas Yamaha golf cart?
Yamaha Golf Cart Running Slow with New Batteries
- Ensure that the distilled water levels are always above 50% inside the battery. New batteries do usually have enough distilled water levels but might drain out in a short while.
- Ensuring proper series wiring is important while installing a new battery in your Yamaha golf cart. ...
- Check the user guide manual for instructions on setting up a new battery. ...
How to properly charge your golf cart Yamaha?
Yamaha g1 Golf Cart not charging
- Often, the G1 golf cart doesn’t charge because of a bad receptacle. Make sure that the receptacles fit tightly and are clean. ...
- Check the plastic coverings on the prongs. A broken cover can also build problems. ...
- The next thing to watch out for is corrosion. Corrosion mainly occurs at the battery terminals. ...
Why does my Yamaha golf cart backfire?
Yamaha Golf Cart Backfires
- The needed adjustment to remedy golf cart backfiring will vary between manufacturers and year models. ...
- 83 yamaha g1 backfiring: Gas Yamaha: gas 2005 yamaha backfiring: Gas Club Car: Yamaha G9 engine adjustment ( backfiring issue & running rough ) Gas Yamaha: 1987 Yamaha gas cart ...
- 3. ...
How do you adjust a Yamaha carburetor?
1:017:29Adjusting Yamaha Carburetor - YouTubeYouTubeStart of suggested clipEnd of suggested clipBut you loosen it up and eventually it's not going to contact it. Okay. So I can loosen this up on aMoreBut you loosen it up and eventually it's not going to contact it. Okay. So I can loosen this up on a cable. And also adjust it there. So to get the idle down as low as possible.
How do you adjust a golf cart carburetor?
Find the pilot adjustment screw on the edge of your carburetor. Pay attention to this screw – it should be a sharp point and not flat. Carefully remove this screw and then carefully screw it back. Turn this screw out one and one-half turns to adjust it properly.
Why does my Yamaha golf cart backfire?
Engine backfiring occurs when there is an air leak within your golf cart or sometimes when there is too much fuel inside. This can cause the piston to slam against the cylinder head and cause a tapping sound. An essential component of any golf cart is the drive belt.
How do I stop my golf cart from backfiring?
How do I stop my golf cart from backfiring? One simple way to stop the golf cart from backfiring is to use good quality fuel. Once this is done, ensure that the throttle plate is closed by adjusting the accelerator cable at the plate.
Why does my golf cart only run with the choke on?
Dwight Coleman there are usually only a few possibilities if it only runs with the choke. One cause could be an air leak on the carb, head gasket, crankshaft seal. The other could be a clogged low speed and idle circuit.
How can I speed up my gas golf cart?
Thankfully, there are ways to put a little extra giddy-up in your gas golf cart....5 Effective Ways to Make a Gas Golf Cart FasterRemove the Governor. The governor limits the top speed your golf cart can move. ... Upgrade the Engine. ... Upgrade the Speed Controller. ... Regular Maintenance. ... Lose Weight.
Why is my golf cart sputtering?
Golf carts can spit and sputter for several reasons, but mainly due to worn out spark plugs or dirty filters inside the fuel system. There might be something wrong with the fuel system of your cart. You could be having a spit and sputter problem because the filter, pump and injectors in your golf cart are very dirty.
How do you adjust the governor on a Yamaha golf cart?
0:005:15Yamaha G29 Drive Golf Cart Governor Adjustment - MORE SPEED!!YouTubeStart of suggested clipEnd of suggested clipItself by tightening this nut down you're putting more pressure on the spring. So that the governorMoreItself by tightening this nut down you're putting more pressure on the spring. So that the governor has to work harder to pull back on the throttle.
How fast will a Yamaha golf cart go?
Most electric golf carts are faster than gasoline golf carts. Although, new gasoline and electric golf cart versions of Yamaha all have the same top speed. The top speed of both versions of Yamaha golf carts is 19 mph (31 kph).
How do you adjust the throttle on a golf cart?
Pull the spring that is present around the plastic piece located behind the shifter. Spin it until it falls back. Loosen the throttle cable present in the cable box to adjust the extent to which you can take it out of the housing. Press the accelerator so that the golf cart starts up and begins to idle.
Does a golf cart have a carburetor?
Gasoline-powered golf carts have many parts that you won't find on an electric cart. For example, the average golf cart has a carburetor that helps to minimize pollution and keep your cart more efficient.
How do you adjust the carburetor on a Club Car DS?
How do you adjust the carburetor on a Club Car DS?Pull out the pilot adjustment screw.Rethread the screw back until it's slightly seated.Turn the screw outwards by 1-1/2 turns.Push the throttle stop screw backward until the throttle shaft is closed completely.Turn the screw in by a 1/4 turn.
How to Adjust a Golf Cart Carburetor
The way to adjust the carburetor on a golf cart will depend on the model of golf cart. In most cases, you’ll need to adjust the jet pilot screw, perform a valve clearance adjustment and then clean the carburetor.
Bad Golf Cart Carburetor Symptoms
The engine shows a reduced performance such as a reduction in fuel efficiency or power and sluggish acceleration.
Troubleshooting Golf Cart Carburetor Problems
Adjust the idle jet pilot screw on the carburetor. This can be done by doing a 1/4 turn of the screw.
How to Adjust Yamaha Golf Cart Carburetor
Pull out the pilot adjustment screw. It must be present at a sharp point and not a flat spot.
Yamaha Golf Cart Carb Vs EFI
The carb model is more powerful as well as starts and goes faster when compared to the EFI. The EFI experiences delay to start moving when the pedal is pressed.
How to Adjust EZGO Golf Cart Carburetor
Check the valve adjustment for proper compression using a compression tester. You will have to pull out the plugs and put the tester inside.
EZGO Golf Cart Carburetor Diagram
The EZGO TXT gas golf cart carburetor diagram shows just one adjustment on the engine. This is present above the carburetor towards its rear. In a 2-cycle cart, this is the idle circuit and is initially set for 1-1/2 outward turns.
What is a golf cart carburetor?
A golf cart carburetor is just like any other carburetor on a gas-powered vehicle. While it may be a bit smaller and have a slightly simpler design, the overall look and feel is the same. More importantly, the purpose of a carburetor on a golf cart remains the same – decreasing fuel waste and minimizing your carbon output to ensure ...
How to get your carburetor in good order?
Once the engine’s operation starts to sound drastically different, stop turning the screw. Bring the screw back until the change in the engine disappears or evens out. Ride your cart to test how well you have adjusted your carburetor. Repeat these steps, as needed, to get your carburetor in great operational order.
Why is my golf cart not running?
That’s because your carburetor helps to keep the cart running smoothly and with even and powerful acceleration. Other problems that may affect your golf cart include regular overheating or backfiring.
Why does my carburetor stutter?
These issues occur because your carburetor does not properly mix your fuel and it is much too lean for your cart. As a result, it may stutter and struggle to run properly without help. You may also see this problem trigger a steady cloud of black smoke as you drive that is quite nauseous.
Do carburetors last longer?
However, they are also more powerful and typically last longer, which makes them popular with a certain subset of buyers. However, these buyers may find that the carburetor on their cart is threatening to go out or is causing issues with cart operation. As a result, it is important for cart owners to understand how to adjust ...
Is my carburetor struggling?
Typically , your cart will showcase a myriad of issues that will make it quite clear that your carburetor is struggling . However, there are many differences between the cart models and manufacturers that may make this process a little harder to properly execute.
Does EZGO have a carburetor?
EZGO manufactures many different carts, each gas model of which has a carburetor that may run into complications over time. These issues are not uncommon with other cart manufacturers – however, some are more common in EZGO carts.
What is a golf cart?
Golf carts are also known as golf cars. The term "cart", in its purest sense, refers to a vehicle that does not travel under its own power. Golf cars, however, are most commonly referred to as golf... link to Club Car DS Wiring Diagrams 1981 To 2002.
How many times can a Yamaha engine be rebuilt?
Yamaha engines are durable and because of the simple design, they can be successfully rebuilt 3 or 4 times . Initially, the Yamaha G1 2-cycle gas was the standard-bearer and in 1985 the G2 4-cycle single-cylinder gas engine was introduced as the new standard.
Does the G21 have a filter?
The G2, G9, G11, and the G21 model Fuel tank has a screw-in filter that is difficult to reach. It is advisable to remove the 2-4 bolts holding the tank in and pull the tank out to drain and replace the filter. Please note that on ALL models using the screw-in filter the tank will need to be drained.
How to adjust idling on a golf cart?
Press the accelerator so that the golf cart starts up and begins to idle. Check the cable tension to make sure that it’s still loose. The idle screw can be used to adjust the idling if it’s very fast. Turn the key to the OFF position and put the cable back into the box.
How to increase the speed of a golf cart?
Make sure that the governor and carburetor are seated with minimum slack and no tension. Fix the cable in place by tightening the nuts at the end of the cable. As the length of the throttle cable increases, it stops the throttle lever from being pulled back. This will in turn increase the speed of your golf cart.
How to get a golf cart to idle?
Pull the spring that is present around the plastic piece located behind the shifter. Spin it until it falls back. Loosen the throttle cable present in the cable box to adjust the extent to which you can take it out of the housing. Press the accelerator so that the golf cart starts up and begins to idle.
How to stop a cart from running at less speed?
Compress the spring between the cable stop and the throttle lever to close the throttle until the pedal is away from the microswitch so that the cart can run at less speed with very less throttle. You must do the compression until your problem goes off. Turn the key to the OFF position and press the accelerator pedal.
What to do if throttle plate opens before it should?
If the throttle plate opens before it actually should, loosen the rear cable. If the throttle plate opens at the correct time but only partly, tighten the rear cable. If the throttle plate opens before it actually should but only partly, loosen the front cable and then tighten the rear cable.
How to run a cable to a governor?
Slide the cable through the little slit present on the side of the cart. Position the cable so that the wire part is in the spool. This ensures that the threaded part of the cable rests on the adjuster bracket. Move the housing backward and adjust the nut to where it was initially. Finally, run the cable to the governor as it was at the start.
Is the Ping G25 adjustable?
Is the Ping G25 driver adjustable? The Ping G25 driver is adjustable. It’s possible to do four adjustments using the hosel adapter of the driver apart from the stated loft setting and...
