
How do you take the governor off of an electric EZ Go golf cart?
0:000:46How to remove governor on a Club Car golf cart - YouTubeYouTubeStart of suggested clipEnd of suggested clipYou open up this box lap. Here. It looks up look inside. There's 12 cable down right here this leverMoreYou open up this box lap. Here. It looks up look inside. There's 12 cable down right here this lever you want to lift up and Bend and that pulls on the cable a little more.
How do I speed up my electric EZ Go golf cart?
6 Ways You Can Make a Golf Cart FasterAdd More Torque to Your Golf Cart.Upgrade Your Golf Cart's Motor.Improve the High-Speed Controller of the Cart.Add Better Golf Cart Tires.Use a Higher Powered Golf Cart Battery.Watch the Weight in Your Golf Cart.
Can you remove a golf cart governor?
Here's another fun fact, though: you can remove or deactivate the governor from your cart engine to speed up your cart. You need to be very careful when you perform this step, though, because you may end up making a mistake that damages your engine.
Do ezgo electric golf carts have governors?
Considering electric golf carts don't have governors like gas powered carts, the old-school method of simply removing the governor is not an option.
How can I make my golf cart governor faster?
Steps to Adjust EZ-GO Golf Cart GovernorStep 1 - First, lift the seat of your engine to reveal seat cousins. ... Step 2 - Remove the seat cushions over your motor. ... Step 3 - Remove the black plastic cover to expose the motor. ... Step 4 - Loosen the smaller one and tighten the larger one to increase your cart's speed.More items...•
How can I make my electric golf cart go faster without upgrading?
How to Make an Electric Golf Cart Faster Without UpgradesWash Your Cart Properly. ... Inspect the Batteries. ... Refill the Battery Water. ... Check the Gas Pedal and Linkage. ... Measure the Tire Pressure. ... Charge Up Your Battery Unit. ... Lighten Up Your Cart's Weight.
What does removing the governor do?
Removing the governor will increase the maximum rpm of the engine, but the internal parts of the Predator 212 are designed for 3600 rpm. Generally, this isn't an issue with just the governor removal, the internal parts can usually withstand 5000 rpm without breaking apart (unless you go full throttle for too long).
How do you bypass a speed sensor on a golf cart?
The speed sensor on the EZGO golf cart can be bypassed by unplugging it from the speed controller. By disconnecting the J5 pin on the speed controller, this will cause the golf cart to creep along as the controller will go into limp mode.
Where is the governor on a ezgo golf cart?
The engine is in the front of golf carts, underneath this panel. Take off the plastic cover and set it aside with the seats. Follow the thickest cable coming from the gas pedal until your find a small spring wrapped around a metal rod. This is the governor.
How fast can a 48v golf cart go?
The standard 48v golf cart will travel between 12 to 14 mph. However, if you apply modifications to the vehicle you can expect top speeds of 20 to 24mph.
Where is the governor located on a golf cart?
0:061:28Where Is a Golf Cart Governor Located? - YouTubeYouTubeStart of suggested clipEnd of suggested clipWell a golf cart's governor located is actually down in the motor. Compartment. Some of them theseMoreWell a golf cart's governor located is actually down in the motor. Compartment. Some of them these electric ones nowadays. Actually the governor isn't a true governor. It is a control speed.
Why is my ezgo golf cart so slow?
A EZGO RXV and TXT golf cart can run slow because of a faulty speed sensor, low battery charge and insufficient levels of water in the battery. A problem with the speed sensor. A faulty speed magnet. One or more batteries could are weak and don't have sufficient charge or the water level could be low.
Where is the speed controller on an ezgo golf cart?
These speed controllers are located under the EZGO cart seat. Check the speed controller's attachment near the carburetor.
How can I make my EZGO TXT 48V faster?
How to Make EZGO Txt 48v Faster. You can make an EZGO TXT 48V go faster by changing the RPM or the speed settings of the cart. Replacing old batteries, unlocking the speed settings or changing the controller will make your EZGO golf cart much faster.
How do I unlock Freedom mode on EZGO?
Toggle the forward/reverse switch from the "neutral" position to "reverse" five times in quick succession. After a few seconds, the computer controller will beep four times, indicating it has shifted into the freedom mode.
How Does a Golf Cart Governor Work
Governors play an important role in electric golf carts by limiting the speed they can travel. This is an important safety feature, as it prevents the cart from going too fast and helps ensure passengers’ safety.
How to Take the Governor off a Golf Cart
Removing the governor from a golf cart is a simple process that can be done with common tools. Here’s what you’ll need:
Frequently Asked Questions about Golf Cart Speed Governors
If you’re looking for ways to speed up your golf cart, there are a few things you can do. Start by removing the governor on top of the engine if you haven’t already. If it doesn’t have a governor, then you’ll need to open up the cart and look at the gear shaft to see if it’s turning.
How to Adjust, Remove, Bypass a Golf Cart Governor (STEPS ..
You can bypass the governor connection in an EZGO or Yamaha G1 golf cart as given below. Remove the cable connecting the carburetor and the governor. Disconnect the connection between the gas pedal and the governor. Connect the gas pedal directly to the carburetor opening.
How to Remove the Governor on an Electric Golf Cart ..
Probably someone told you that you could remove the governor from your electric golf cart to make it go faster. The bad news is there is no governor on an electric golf cart, but the good news is there are several options to quench your need for speed.
How to Adjust an E Z Go Golf Cart Governor: 13 Steps
Remove the screws from the black plastic cover at the rear of the seat. There should be five screws in most models. The engine is in the front of golf carts, underneath this panel. Take off the plastic cover and set it aside with the seats.
How to Easily Remove a EZGO Golf Cart Motor (STEPS) - Golf ..
The expert advice on the easy way of removing the Robin 295 engine from a golf cart (a 1997 EZGO TXT or any other model) is as follows: Disconnect all the electrical, fuel and air supply lines. Then remove the belts, exhaust and the choke cable.
Adjusting Your Golf Cart's Governor
Type of Golf Cart: Gas Problem: "I would like to get a little more power and speed out of my golf cart's engine.Can I adjust the governor?" About Golf Cart Governors: The ground speed governor, as it's called among the golf cart manufacturers, is a mechanical device usually either inside or in someway related to the differential, which controls your top end flat ground speed to prevent ....
Only 2 methods tell you How to Adjust an E Z Go Golf Cart ..
Tighten the governor spring located in the engine of most golf carts to adjust your cart's top speed. 90% of EZ Go Carts have simple springs which limit the speed of the engine. To raise the top speed of your golf cart, all you need to do is locate this spring and tighten it slightly.
Video How To Remove Club Car DS ... - Golf Cart Hot Rod
Easy free way to remove the speed limiting governor from your Club Car DS golf cart. This how to video gives you the step by step procedure for making your Club Car DS golf cart go much faster at no cost to you.
How to remove governor from golf cart?
How to Remove the Governor From a Golf Cart. You hit the links. The course is open in front of you as far as the eye can see. The only thing holding you back is the put-put-puttering of your golf cart. Golf carts are governed to go anywhere from 12 to 14 miles per hour. But if you've got a few minutes, some simple mechanical know-how and a wrench, ...
Where is the governor on a car?
The governor generally sits on top of the engine . This is the easiest way to find the carburetor. Once you've followed the cable up to the governor, disconnect it there as well. You can save this cable for later use or throw it away.
How to adjust a gas pedal on a cart?
Using your wrench, remove the bolt on the gas pedal shaft. Slide the shaft up so there is more play in the gas pedal. Tighten the bolt and then start the cart. You may need to adjust the gas pedal shaft a couple of times before you have it to your liking.
How fast can a golf cart go?
Golf carts are governed to go anywhere from 12 to 14 miles per hour. But if you've got a few minutes, some simple mechanical know-how and a wrench, you can double the speed of your cart and zip through your round.
How fast can a factory cart go?
The factory gear most likely has a 12.5:1 ratio, which allows the cart to achieve somewhere around 14 mph. If you swap out the factory gear for one with an 8:1 gear ratio, you'll up your top end to about 20 mph.
How to make a cart faster?
Step 1. The first option to making your cart faster is to replace the electronic speed control. This will enable more voltage to pass to the motor, producing the desired result. Unfortunately, this upgrade is not inexpensive as the unit can run anywhere from $100 to $1,000. Step 2.
Can you drive a golf cart faster?
It should be noted that the golf cart you are trying to make faster may not be designed to do so. Weigh the options carefully and exercise caution whenever driving a golf cart at any speed. Remember that golf carts are not equipped with seat belts, air bags and other safety equipment that you find in automobiles.
How to adjust EZ Go cart governor?
To adjust an EZ Go Cart Governor engine, start by removing the seat so that you can access the engine. Once the seat is off, remove the screws from the black plastic cover at the rear of the seat and then set the cover aside.
How to make a golf cart go faster?
Loosen the small nut and tighten the larger nut. The more you tighten the larger nut, the faster your cart will go. Start slowly, only tightening the nut a quarter turn to start. You can over-stress the engine if you try to run it too quickly, and it will skip and potentially burn out if you are too eager.
How to get a cart to move faster?
1. Remove the seat and plastic covering over the engine. Sometimes you'll need to remove screws while some models have seats that pop right out. Expose the engine so that you can get to work adjusting the motor. If you don't have a central governor spring, you can still get your cart to move a little faster.
How fast can a golf cart go?
Adjusting the governor can make your golf cart go 5–10 mph (8 .0–16.1 km/h) faster. If you do this to an E-Z-GO golf cart, you might be able to go from 15 mph (24 km/h) to 22 mph (35 km/h). It will only take about 5 minutes to do it. Steps.
How many screws are in a golf cart engine?
There should be five screws in most models. The engine is in the front of golf carts, underneath this panel. Take off the plastic cover and set it aside with the seats. ...
How to change the speed of a car?
Locate your clutch pedal and line. The clutch is the pedal (sometimes a handle near your knee) that you use to put the car into reverse or change speeds. You can adjust the clutch to send more gas to your engine, moving you faster. ...
How to raise the top speed of a golf cart?
To raise the top speed of your golf cart, all you need to do is locate this spring and tighten it slightly. If you cannot find this spring, you likely have a newer model that is more difficult to adjust, though this is rare. Lift up the seat. Remove the seat cousins, which hide the engine.
