
What does a carburetor do on a golf car?
Carburetors are one of the most critical components on any gas golf car. The carburetor is responsible for mixing air and fuel in the proper proportions and placing that fuel into the engine for combustion. Carburetors are the predecessor to fuel injection.
How do I fix a bad carburetor?
Sometimes, the problem can be fixed by removing the carburetor and clean everything thoroughly. Other times, you may need to use a carburetor rebuild kit to repair it, while sometimes there is nothing that can be done except to replace the entire carburetor. Within this section, we offer carburetors and carburetor rebuild kits for Only EZGO.
How do you adjust the carburetor on a 2 cycle engine?
2 Cycle engine: The adjustment screw is on the side of the carburetor and is parallel to the ground. You can identify it by the lock nut at the base of the screw. Loosen this and turn the screw all the way into a soft seat, then back it out one and a half (1-1/2) turns.
Why is my golf cart backfiring without a choke?
If your golf cart is spitting, sputtering, backfiring, of won't run without the choke pulled, you may need to check your carburetor. Particulates in your gas can clog the small holes in the jets within the carburetor housing, the float can go, or the needle and seat can wear out over time.

How do you clean the carburetor on a EZ Go golf cart?
10:2618:51Carburetor cleaning on EZGO gas golf cart - YouTubeYouTubeStart of suggested clipEnd of suggested clipChannel right here is your main jet. And that is the one that is going to there's going to be aMoreChannel right here is your main jet. And that is the one that is going to there's going to be a passageway inside that that leads to. So that's the most important one to have clean.
How do you adjust the carburetor on a EZ Go golf cart?
2 Cycle engine: The adjustment screw is on the side of the carburetor and is parallel to the ground. You can identify it by the lock nut at the base of the screw. Loosen this and turn the screw all the way into a soft seat, then back it out one and a half (1-1/2) turns.
How do you adjust a carburetor on a gas golf cart?
Find the pilot adjustment screw on the edge of your carburetor. Pay attention to this screw – it should be a sharp point and not flat. Carefully remove this screw and then carefully screw it back. Turn this screw out one and one-half turns to adjust it properly.
How do you prime a golf cart carburetor?
How to Prime a Golf Cart Fuel PumpTurn the engine of the golf cart on and remove the gas cap.Keep a rag around the filler hole.Blow hard into the gas tank. You may have to do this a few times until the engine starts purring and the fuel filter has fuel in it.
How can I make my ezgo gas golf cart faster?
One way to increase the speed of EZ Go golf carts is to incorporate an octane booster when you fill the tank. The cart will have more pick-up, and it could gain as much as 5 mph. A different approach is to take out the throttle linkage governor on the carburetor.
Why does my EZ Go golf cart backfire?
The golf cart backfires through the carburetor because of an open throttle plate. The accelerator cable at the scale is out of adjustment and, in turn, stops the vessel from closing when the microswitch makes contact with the ignition.
What causes a gas golf cart to sputter?
Golf carts can spit and sputter for several reasons, but mainly due to worn out spark plugs or dirty filters inside the fuel system. There might be something wrong with the fuel system of your cart. You could be having a spit and sputter problem because the filter, pump and injectors in your golf cart are very dirty.
Why does my golf cart only run with the choke on?
Dwight Coleman there are usually only a few possibilities if it only runs with the choke. One cause could be an air leak on the carb, head gasket, crankshaft seal. The other could be a clogged low speed and idle circuit.
Why is my gas golf cart slow?
Low Battery Usually, the most common reason golf carts slow down is when they don't get enough power output from the battery. If the battery pack charge is very low and your cart is out of power, your cart will run slow.
Why is my carburetor not getting gas?
float may be stuck in the closed position or if carburetor equipped with a electric shut off/solenoid it could be faulty/stuck/bad connection. Now if you are getting fuel to carb. and the bowl is filling, either the jets are clogged or you have not adjusted the screws out to the proper settings to allow fuel to flow.
Should fuel filter be full on golf cart?
Please keep in mind that the overall operations of the golf cart do not get affected if the fuel tank stays half full. The fuel filter on both new and older EZGO carts may not stay full due to the vacuum tube which connects the crankcase and the fuel pump, facing a glitch.
Where is the fuel pump on a ezgo golf cart?
2:3311:36Homesteading - EZGO Fuel Pump Replace - YouTubeYouTubeStart of suggested clipEnd of suggested clipIt's where the engine is what I've got here is a little Robin engine. There was the original fuelMoreIt's where the engine is what I've got here is a little Robin engine. There was the original fuel filter right fuel pump right there.
For the 295cc or a 350cc twin-cylinder OHC engine. 1991 – Present
Tools required: Ratchet with 6″ extension, 10mm socket, 10mm socket wrench, flat blade screwdriver, and a feeler gauge. Note: if the screw (C) has a square head instead of a flat blade slot, this takes a tool designed just for this purpose.
For the Kawasaki FJ400 401cc 4-cycle Single Cylinder 1996 – Present
Tools required: Ratchet with 6″ extension, 10mm socket, 3mm hex wrench, feeler gauge.
