Golf-FAQ.com

precedent club car golf cart feels like brake is being set when pedal is let up on.

by Marjorie Klocko Published 2 years ago Updated 2 years ago

The main reason why Club Car golf cart brake lights stay on is because the timer relay in the circuit is failing. The issue that most users of Club Car Precedent Electric (2010) come across is that once they apply the brake, the brake light comes and stays on even after the brake is released. It switches OFF only when the ignition is turned OFF.

Full Answer

Why do my golf cart’s brakes lock up?

If the little arm connected to the rear of the cable is pulled forward so that the cable can be hooked, the brakes may lock up. Replace the brake shoes if they show signs of wear and tear or chipping. You’ll have to remove the tires to inspect the brake shoes. Move the cart in the reverse direction by a few feet and press sharply on the pedal.

Why does my club car precedent golf cart make a popping noise?

The Club Car Precedent makes a popping noise when turning the steering wheel due to worn out guts in the rack, a bent shock tower or a binding in the knuckle on the steering column shaft. You can try the suggestions given below to overcome the popping noise in your Club Car Precedent golf cart.

How to fix club car precedent brakes locking up?

Club Car Precedent brakes are locking up You can try the following to release locked up Club Car Precedent brakes. Clean the glazing from the brake drums and shoes on both sides using fine sandpaper or emery cloth. Tighten the perch and U-bolts as the axle tends to twist when they become loose and result in grabbing brakes.

How do you adjust the brake pedal on a golf cart?

If the cart is lifted, remove the drums and adjust the shoes manually so that they are slightly loose. Check the sliders for free movement and adjust them if needed. Adjust the brake cable so that it’s not hard but the pedal remains stiff enough.

Why are my golf cart brakes locking up?

Why Do Golf Cart Brakes Lock Up? Golf cart brakes can start locking up when the brake cable gets stuck, or when the bolts on the lift kit are loose. The brake cable gets stuck because of a binding, resulting in a mechanical linkage. One or more parts of the pivot assembly have rusted.

Why does my electric golf cart hesitate when I accelerate?

In most cases, the hesitation problem occurs due to bad batteries. If you have bought new batteries for your EZGO RXV, make sure to fully charge them before the first use. Batteries should then be charged after every use. To keep the batteries in check, get a Digital MultiMeter to measure the individual voltage.

How do I adjust my club car precedent brakes?

0:161:56Club Car Precedent Brake Cable Adjustment | Golf Cart GarageYouTubeStart of suggested clipEnd of suggested clipThere is a locking nut and a movable nut to tighten or loosen the tension. Which you can test whileMoreThere is a locking nut and a movable nut to tighten or loosen the tension. Which you can test while performing the adjustment by depressing the brake pedal by.

Are golf cart brakes self adjusting?

Many modern golf carts have self-adjustment brakes and do not require manual adjustment, but they do need a little bit of tweaking here and there. However, if you feel the brakes need adjustment, you can do so manually as well.

What causes an electric golf cart to hesitate?

If your cart does not start smoothly, hesitates before starting, or does not gain speed properly, these are all signs of a bad or damaged accelerator.

Why is my club car precedent jerking when accelerating?

The main reason why a Club car golf cart jerks when you accelerate it is due to a misaligned Inductive Throttle Sensor or dirty clutch.

How do you adjust brake shoes on a Club Car golf cart?

2:474:18How to adjust golf cart brake pedal/brakes - YouTubeYouTubeStart of suggested clipEnd of suggested clipIf you're really concerned about it doesn't tend to turn on its own but you can get two wrenches inMoreIf you're really concerned about it doesn't tend to turn on its own but you can get two wrenches in here and tighten them together make it extra secure. And when you're done. Put your wrench.

How do you fix the parking brake on a club car?

3:079:35Club Car Precedent Parking Brake Fix - YouTubeYouTubeStart of suggested clipEnd of suggested clipThis little long piece here goes up underneath this cover and it's popped into place with these tabsMoreThis little long piece here goes up underneath this cover and it's popped into place with these tabs just take a screwdriver or a flathead screwdriver lift it here lift.

How do you release the parking brake on a golf cart?

Disengaging your parking brake is also quite simple:Sit down in your cart and start it up.Press the parking brake pedal down past where it initially “locked” when engaged.Release the brake and it should pop back up into its normal position.Press the brake further down if it does not disengage for any reason.

How do you adjust drum brakes on a golf cart?

0:195:17How to adjust club car golf cart brakes - YouTubeYouTubeStart of suggested clipEnd of suggested clipAnd whenever you those those kind of stays stationary whenever you push on your brakes. DownMoreAnd whenever you those those kind of stays stationary whenever you push on your brakes. Down underneath here that's where the the mechanism is that pushes out on the bottom of those brakes.

How do you check golf cart brakes?

1:543:20How to Inspect Your Golf Cart's Brakes | Golf Cars Unlimited - YouTubeYouTubeStart of suggested clipEnd of suggested clipIf you will for your brakes wien visually inspect it and clean the brake drum. And shoe area.MoreIf you will for your brakes wien visually inspect it and clean the brake drum. And shoe area.

How much does it cost to replace brakes on a golf cart?

The brake system in a golf cart is made of several components. Replacing the brake system will mean replacing all the components. A complete brake replacement costs $150-$200.

Why does my Club Car DS make a popping noise when turning the steering wheel?

The Club Car DS makes a popping noise when turning the steering wheel due to loose components in the front suspension, a cracked upper clevis, a worn out steering, missing bushings or lack of grease.

Why does my gas golf cart make a squealing noise?

The gas golf cart tends to make a squealing noise due to a loose or worn out starter/generator belt, a loose drive and/or alternator belt or a dusty clutch. Loose or worn out starter/generator belt. Loose drive and/or alternator belt. Dusty clutch.

Why does my 2001 Club Car DS make a grinding noise?

The grinding noise in a 2001 Club Car DS is because of worn out brakes, a bad wheel bearing, low transaxle oil level in the rear end or a worn out input shaft bearing.

Why does my club car DS make a clunk?

The front-end clunking noise in a Club Car DS is due to worn out bushings under the spring and spindle, loose nuts on the spindle, a damaged rubber bumper or a cracked front leaf spring plate.

How to reduce noise in golf cart?

You can reduce the noise in a Club Car considerably by opting for an engine with lower HP, insulating or lining the engine compartment, opting for mufflers or addressing mechanical problems like loose screws.

Why does my club car make a rattling noise?

The rattling noise in a Club Car DS is often because of a worn out clutch, loose bolts, a rod knock, a loose top light, a dirty guide ring or a windshield problem.

Why does my clutch make a noise?

Clutch making noise (Club Car DS) The clutch in the Club Car DS makes a noise because of a worn out clutch, damaged clutch belt, shaft or buttons or low oil level in the rear end. Worn out clutch. Damaged clutch belt, shaft or buttons. Low oil level in the rear end.

Why do golf cart brakes lock up?

Golf cart brakes can start locking up when the brake cable gets stuck, or when the bolts on the lift kit are loose. The brake cable gets stuck because of a binding, resulting in a mechanical linkage. One or more parts of the pivot assembly have rusted. There’s wear and tear of the brake drum, brake shoe, brake cable or brake spring.

Why do you need to replace brakes on a golf cart?

In most cases, you will have to replace the brake cables of your golf cart because they have not been adjusted properly. Another reason why you may have to go in for a replacement is a broken linkage or broken cable ends. If the pads under the drum are in good condition, it’s a sign of the cable beginning to seize up.

Why does my brake line keep dragging?

The locking or dragging could also be due to rusting of the collar, bolt, return spring or bushings of the pivot assembly. Cleaning up the rust may work. Attending to damaged brake cables and linings under the drums also help.

How to adjust brakes on a Yamaha G2?

How to adjust Yamaha G2 Golf Cart Brakes: Remove the brake shoes and check if the adjuster moves backward and forward. Clean the adjuster star wheel well so that it spins without a glitch. Remove the pins that connect the brake cable to the brake arm behind the brake backing plate.

How to fix a sticky brake on a golf cart?

You can also fix sticky brakes by following the steps given below. Take off the brake pedal from the golf cart. Drill out the bushings and the pedal assembly using a 3/4-inch drill bit. Drill the frame at the point where the pedal is mounted using a 1/2-inch bit.

How to adjust brakes on a G29 golf cart?

The brake adjustment of a G29 golf cart can be done in the following ways. Apply mild hand pressure on the brake pedal. This will give a yield of 1 to 1.75 inches on the pedal. If you don’t get this yield, it’s likely that the brake cable has stretched out and needs to be replaced.

Why is my cart locking?

If both the wheels are locking, it’s often because there is a binding on the main brake cable that results in the mechanical linkage. This will cause the main cable to get stuck. If your cart has hydraulic brakes, the master cylinder may have gone bad. You may try loosening the brake cable or the line at the wheels.

Club Car Precedent 48v Intermittent Problem Question

I have a 2012 Club Car Precedent 48v electric cart that will suddenly stop working. It has brand new batteries, and seems fine, but randomly will not move when pushing the pedal. It will lurch forward then stop again, or it may work normal after changing the f/r switch, key switch, or even the run/tow switch.

Answer

It sounds like you are dealing with what we classify an intermittent problem. So, first things first, we need to reproduce the problem. Most likely, you are dealing with a connectivity issue. Essentially, what you are describing is a power outage to the system. The clicking noise you are hearing is the solenoid disengaging due to lack of power.

A B C D E F G H I J K L M N O P Q R S T U V W X Y Z 1 2 3 4 5 6 7 8 9