Why does my golf cart go in reverse but not forward?
Check the Forward/Reverse switch of your golf cart for loose connections. If the connections are intact, interchange the top and bottom wires at the rear. If the cart now goes in reverse but not forward, the problem is with the switch. You have to just change the switch in this case.
Why won't my EZGO gas golf cart go in reverse?
A EZGO gas golf cart will not go in reverse if there is a faulty transmission system, improper cable adjustment, a defective microswitch present inside the Forward/Reverse controller, or a malfunctioning neutral limit switch. Sometimes, this happens if the cart is kept in the forward position for a long time.
What does it mean when a golf cart dies in neutral?
Golf Cart Dies when shifted into Forward or Reverse but runs in Neutral The golf cart runs smoothly in neutral, but when you shift to forward or reverse the golf cart dies. When your engine dies when you apply load but no gas on the pedal, this means that your idle speed is set too low.
Why won’t my RXV go forward or reverse?
An EZGO RXV golf cart won’t go forward or reverse if the battery pack voltage is low, the solenoid has a discoloration, the battery connections are loose, or if the brake is failing. Check the battery pack voltage. This should ideally be close to 50 volts.
Why will my golf cart go backwards but not forward?
A faulty Forward/Reverse switch can cause a Club Car golf cart to move in reverse but not forward. Replace the entire switch and the contacts if they are burnt. The cart moving only in the reverse and not in the forward position is peculiar and there are only a few areas that need to be checked.
How do you fix the reverse on a golf cart?
One possible cause of a cart not moving forward or in reverse is because of the way the wires are hooked in reverse. To fix this, you should switch the position of both the wires that are leading to the motor. If the golf cart is not rolling across freely, there might be an issue with the brakes.
How do you test a directional switch on a golf cart?
Place your foot on the car's brake, insert the key, and put the forward-reverse key in the forward position. If you see that the solenoid charges up pushing the pedal, then your forward reverse switch is working fine. As you put your Golf Cart in the forward mode, check your multimeter for full voltage.
Where is the direction switch on a golf cart?
0:3011:38Golf Cart Forward Reverse Switch - YouTubeYouTubeStart of suggested clipEnd of suggested clipIf you have any of those symptoms. Most likely that your forward reverse switch. Which is locatedMoreIf you have any of those symptoms. Most likely that your forward reverse switch. Which is located right there. This is what makes your golf cart go forward or reverse.
How do I troubleshoot my EZGO forward/reverse switch?
Check all the connections and make sure each part is getting power by using the multimeter. Have your foot firmly on the brake, put in the key, and the F/R switch in the forward position. When you push the go pedal if the solenoid charges up then your EZGO F/R switch is good to go.
Where is the reset button on a Club Car golf cart?
Identify your main battery supply (usually the largest battery) on your motor. Check around this supply for a small red button that may or may not be labeled “Reset”. Press and hold this button for a few moments and then release it to reset the motor.
How do you change a forward and reverse switch on a golf cart?
1:4511:18EZGO Forward and Reverse Switch | How to Install Golf Cart F and RYouTubeStart of suggested clipEnd of suggested clipOff. There we go got that loose now now we'll actually take the furnace full reverse switch looseMoreOff. There we go got that loose now now we'll actually take the furnace full reverse switch loose from the frame in doing that we'll need our half-inch socket along with a half-inch wrench.
Where is the reset button on a ezgo golf cart motor?
Locate the motor Remove the panel so the electric motor is visible. Electric motors usually include reset buttons that can perform similar to circuit breakers. Look in the area where several electrical wires enter the motor and locate a small red button. This is the reset button.
How does a gas golf cart forward reverse switch work?
0:379:43Golf Cart Forward and Reverse Switch Direction Selector Tutorial - YouTubeYouTubeStart of suggested clipEnd of suggested clipThat is brand new it simply cables connect to the bright copper colored contacts. And the switchMoreThat is brand new it simply cables connect to the bright copper colored contacts. And the switch rotates through a hand action and that changes the polarity.
Where is the solenoid on a club car?
0:304:43Club Car Precedent 48 Volt Solenoid | How to Replace on Golf CartYouTubeStart of suggested clipEnd of suggested clipPosition next what we want to do is take off the battery of hold-downs. We're going to remove theseMorePosition next what we want to do is take off the battery of hold-downs. We're going to remove these two batteries in the center they'll have to take certain cables either off or loose.
How do you bypass a solenoid on a golf cart?
To bypass the solenoid of your golf cart, simply connect both the large side wires of terminals of the solenoid. And after making the connection, attempt to start the cart. If you fail to start, this is an indication that there is no problem with your solenoid.
How do you replace the forward reverse switch on a Club Car Precedent?
0:183:44Club Car Golf Cart Forward And Reverse Switch ReplacementYouTubeStart of suggested clipEnd of suggested clipAnd then just get a flathead screwdriver right underneath here start prying up on. It.MoreAnd then just get a flathead screwdriver right underneath here start prying up on. It.
Loose Cables
Loose power cable connections are the primary culprit in the failure of traditional mechanical rotary style forward reverse switches. Power cables are the thicker, usually 6-gauge, cables that connect the forward reverse switches to the starter generator, in the case of 2-cycle gas golf carts.
OEM 6 Gauge
For most golfing applications 6-gauge cabling is adequate to the task of carrying two golfers and their two golf bags around the course, stopping every 200 yards or so while they play their next shot.
Upgrades
The larger diameter tires require more current (amps) to simply get the cart rolling. Added passengers mean more pay load demanding still more amps through the electrical system. Add a hilly or mountainous terrain and the amp draw just keeps getting higher.
Sepex Controllers
Many modern golf carts have an electronic speed controller that handles the forward and reverse switching function internally. These carts have a toggle switch of some design to change direction rather than the older mechanical rotary forward reverse switches common to many golf carts.
Golf Cart
Support for gas-powered and electric golf carts, sometimes referred to as golf cars or club cars after the Club Car Golf Cart brand.
2 Answers
Look at the motor. On one end of the motor (the side closest to the gearbox) the studs will be labeled S1 and S2 (for a Series cart) or F1 and F2 (for a sepex cart). Take those two cables off and swap them and your problem should be rectified
golfcartman
When you removed the batteries, a certain procedure MUST be followed. Key switch off, switch to tow position and shift lever in reverse. You must wait until the beeper unit sound dies out then remove the wire from the most NEGATIVE cable. Place in Neutral before installing new batteries.
golfcartman
Your batteries have died. The reason it will barely move in reverse is that current is being supplied to the motor is a direction that it spends very little time using. There is a slight change in the armature over time, and reverse tends to work better over time. Check the voltage when under load.