Why does my Yamaha golf cart keep running?
Your Yamaha golf cart keeps running because of loose wires. If you suspect the issue is loose wires, check that the TCI wire connector which is at the front of the engine hasn’t been pulled out of the wire harness connector.
How to tell if a Yamaha golf cart battery pack is failing?
If the spin occurs doing the same test with a big jumper and on the larger posts on the solenoid, then the solenoid is not functioning. The absence of a spin in this test could mean your Yamaha golf cart’s battery pack is failing.
Why is my Yamaha golf cart sticking accelerator switch?
Your Yamaha golf cart has a sticking accelerator switch. If your cart has problems stopping, you might have a sticking accelerator switch on your hands. This will make you need to push the gas pedal multiple times to get it to work properly.
Why does my golf cart idle rather than shut off?
The golf cart will idle rather than shut off. Make sure you tell people before they drive the golf cart that you removed the safety feature. The relay on the throttle valve is a safety feature in place to prevent accidents. Use care and be aware of your surroundings.
How do I reset my Yamaha golf cart?
Identify your main battery supply (usually the largest battery) on your motor. Check around this supply for a small red button that may or may not be labeled “Reset”. Press and hold this button for a few moments and then release it to reset the motor.
What does a Yamaha golf cart stop switch do?
This is a replacement accelerator micro (stop) switch for use with gas and electric G14-G22 model Yamaha golf carts. As a safety mechanism, this switch kills the car when the pedal is released. When the pedal is depressed, the switch is activated and sends a signal to the solenoid, allowing your golf cart to start.
What does the red light mean on a Yamaha golf cart?
Your standard gas golf cart is equipped with similar light, to let you know when you're low on fuel and you need to refill the tank. The light, usually red, starts flashing when the battery has got less than 10 percent charge left, in an electric golf cart or less than 10 percent fuel in a gasoline-powered golf cart.
How do you troubleshoot a Yamaha golf cart remote?
How do I test my Yamaha g16 speed controller?Keep the key on.Press down the accelerator.If you hear a clicking noise, the solenoid is working. Otherwise, there is a problem.Next, examine the controller for defects. ... If the wires are damaged, replace them to get back the speed.
Where is the solenoid located on a Yamaha golf cart?
0:095:38Replace Solenoid in Golf Cart - YouTubeYouTubeStart of suggested clipEnd of suggested clipCart um your solenoid could be located in a bunch of different places but almost always underneathMoreCart um your solenoid could be located in a bunch of different places but almost always underneath the seat.
How do I test a golf cart solenoid?
Set your multimeter to ohms and insert a probe on each large terminal with the key off and the cart direction switch in the neutral position. Press on the accelerator with the cart's movement control in the forward position, and the key is turned on. A click should be heard first from the solenoid.
What does flashing battery light mean golf cart?
When the battery symbol flashes, it means that the battery is low and needs to be charged. The flashing may also be a warning that the battery is about to die.
What does a flashing yellow light mean on a golf cart charger?
The yellow light in your golf cart charger flashes when the batteries need to be charged. If you have not used your golf cart for some time and the battery charge level goes below the threshold, the yellow LED indicator starts flashing. Once the charging starts, the flashing of the yellow light will stop.
What does orange battery light mean on golf cart?
The battery light on Club Car golf carts is only on battery-powered models and indicates that the battery for the cart is running low. When this warning light is activated, the cart should be charged immediately.
How do I know if my golf cart controller is bad?
X Common Symptoms of Controller FailureTop Speeds Not Appropriate for Your Cart. Golf carts are designed to reach pretty specific speeds and to not go over them or beneath them. ... Sudden and Unexpected Slowing. ... Shuttering or Shaky Driving. ... Stalling Out and Refusing to Start. ... Surges in Speed When Driving.
Where is the speed sensor located on a Yamaha golf cart?
Typically, the speed sensor can be found on the backside of the motor. When removing the speed sensor, unplug all the cables that are on the backside of the motor. To do this, use a socket to take off the connector pigtail. Then, remove its plastic housing over the sensor.
What does a potentiometer do on a golf cart?
It sends an electrical signal to the speed controller from the accelerator pedal, indicating the pedal's position. When it is working properly, the potentiometer allows your golf cart to accelerate smoothly. Find your potentiometer and inspect it for any cracks, broken parts, or disconnected wires.
Why is my Yamaha golf cart not moving?
The main cause of a Yamaha golf cart clicking but not moving, is a faulty controller or solenoid. The battery has to be checked first to see if it’s delivering the right voltage while in the idle state as well as when the pedal is pressed. There can be other reasons for the Yamaha golf cart not moving though you hear the click.
What does absence of spin mean on Yamaha golf cart?
The absence of a spin in this test could mean your Yamaha golf cart’s battery pack is failing.
Why is my G29 not moving?
Some experts think that faulty batteries are the main reason for G29 Yamaha golf carts not moving when started. With the batteries, there can be multiple issues. Keeping them charged to the full is important.
Why is my solenoid not clicking?
The reason why the solenoid is not clicking could be that it is faulty or has no grounding. Experts recommend checking all wiring and cable connections to rule out this possibility. Batteries on your G16 Yamaha golf carts should raise sufficient power to reach the solenoid and the starter/generator.
What to do if your G9 golf cart is not clicking?
If you find your G9 Yamaha golf cart not starting nor clicking, check the key components for damage. If you find the parts to in good condition, check the brushes in the starter/generator.
How to check solenoid on a G9 golf cart?
The solenoid can be checked using an old screwdriver to jump the terminals. Your G9 Yamaha golf cart’s key must be in the start position. If the starter turns when you do this, your solenoid needs to be replaced. You must be careful while doing this crude test; there could be sparks when the two terminals touch.
How to connect a battery to a solenoid?
Take a jumper cable and connect them from the positive and negative posts of the battery pack to the two posts on the solenoid that you just disconnected.
Why is my club car golf cart not working?
OBC regulates the car’s batteries’ charge, and the solenoid supplies the electrical current from the battery to the entire vehicle.
Why is my club car not working?
Most club car users face this problem. Mainly the problem occurs if the OBC or On-Board Computer is not functioning correctly.
What to do if solenoid is damaged?
If the solenoid or the battery is damaged, then all that is left to do is replace the parts.
Why is my solenoid not getting enough power?
Check if the solenoid is getting enough electricity. It can happen if the battery is damaged somehow. Solenoid mainly supplies the power from the battery to the rest of the car. So, the battery can be the reason.
What is a gas club car?
Gas club cars are mostly used for maneuvering rolling hills, rougher terrain, and for transportation of heavy payloads. Here I have mentioned a few troubleshooting steps which can help to shut off your car, and also, they are necessary when you are using the vehicle regularly.
Why is my starter still working?
May be the starter is still operating because the spring, which pulls back the pinion to the rest pose, is not doing its job correctly.
How to turn off a car with a key?
Switch off the car with your key. Set forward or reverse to neutral. Now find out the run or tow switch and put it to tow. If the negative battery terminal is connected to the battery pack, disconnect it. Now put the switch from tow to run and the forward or reverse switch to reverse. Then turn the key switch on.
Why does my Yamaha golf cart controller die?
The controller on a Yamaha golf cart can die when the battery voltage is too high, or because of loose wiring in the charger.
How to troubleshoot a 2008 Yamaha golf cart controller?
You can troubleshoot the 2008 Yamaha golf cart controller using the following steps: Press the accelerator and check whether the voltage increases up to the full voltage of the battery. If it does not increase, then there is a problem with the controller or the batteries. Examine the batteries and check if they are dead.
What problems does a 1996 Yamaha golf cart have?
The 1996 Yamaha golf cart can also encounters controller problems.
What causes a golf cart speed controller to fail?
A faulty solenoid can cause major problems for a golf cart speed controller. Yamaha G22 also faces similar problems like G9 and G16.
What are the problems with a G16 golf cart speed controller?
The most common problems with a G16 golf cart speed controller is overheating and voltage issues.
Why is my Yamaha controller hot?
The primary reason why a Yamaha golf cart controller gets too hot is because of overuse. When the golf cart is used for long periods of time, the controller can start overheating.
How to test Yamaha G16?
To test the Yamaha g16’s speed controller, check the voltage reading while pressing the accelerator. Test other components such as the batteries, the charger, and the solenoid for their smooth functioning. If any of these components do not work as expected, then you need to replace them.
How to turn off a golf cart?
Push the throttle cable toward the throttle valve body on the engine from the gas pedal position. Screw the throttle cable back in place on both the gas pedal and the throttle valve body on the engine. The golf cart will idle rather than shut off. Make sure you tell people before they drive the golf cart that you removed the safety feature. ...
What is the safety feature of a golf cart?
One of the safety features on a golf cart is cutting out the engine when the gas pedal is not in use. Many golf enthusiasts understand the importance of this safety feature. However, those who use a golf cart for purposes other than golfing may view it as unimportant.
How to remove relay switch on golf cart?
Look for a relay switch that closes when the golf cart accelerates on the throttle cable. Remove this relay switch with a flathead screwdriver.
What is a relay on a golf cart?
The relay on the throttle valve is a safety feature in place to prevent accidents. Use care and be aware of your surroundings. Any change in the manufacturer specifications on the golf cart can invalidate any warranty given at the time of purchase.
Where is the throttle cable on a golf cart?
Find the throttle cable on the golf cart. The throttle cable runs from the gas pedal to the throttle valve on the engine. Lift the seat to find the throttle cable.
Do security guards need to shut off the engine?
Security guards at airports who shuttle passengers back and forth, for example, have no need to have the engine shut off. Having the golf cart idle makes their job faster and easier. Remove the speed governor to shut this safety feature off on a golf cart.
How to fix a stalling engine?
If it gets too dirty it can cause your engine to not get enough air and stall out. Check the oil level and make sure you have enough and that the color is light and not black. If the oil is blackened or dark, you need to change it. Get a new oil filter and enough oil to refill the engine. Drain the oil through the plug on the oil pan underneath. Change the filter out and refill it with clean oil.
Do you need to troubleshoot a golf cart?
If you have a golf cart you will eventually need to troubleshoot the golf cart motor. This is an easy thing to do quickly. Remember, it is a gas-powered engine that is not much different than your lawn mower or car. You are going to go through some of the same steps to troubleshoot the motor.
What does it mean when a golf cart doesn't produce enough power?
Inspect the battery connections throughout the golf cart. If it doesn't produce this much power, then it indicates the battery is not outputting properly.
Why is my golf cart slow?
Usually, the most common reason golf carts slow down is when they don't get enough power output from the battery. If the battery pack charge is very low and your cart is out of power, your cart will run slow.
Why is my Ampacity controller not working?
Usually, this issue arises when the controller has not been installed correctly. Consult with a professional to ensure that you don't run into any problems. Sometimes repair experts may use aftermarket items that don't fit properly on your ampacity controller and cause it to run poorly or fail and leave you with a cart that runs slow.
What happens if your golf cart speed sensor breaks?
So, it will send less power to your engine and cause it to produce less speed as well as cause accelerator problems in the golf cart .
How to check battery connections?
Take a digital voltmeter and connect it to your battery pack and check the connections.
Why does my cart slow down?
Check Mud and Dirt Build-up: Although the speed sensor is a tricky part that withstands some wear and tear, there's a good chance that your cart will slow down because of dirt or mud build-up.
What to do if battery voltage is low?
Consider replacing the battery if the voltage output remains low.
